Dominik Wöll

Heterogeneous diffusion in thin polymer films as observed by high-temperature single-molecule fluorescence microscopy.

Single-molecule fluorescence microscopy was used to investigate the dynamics of perylene diimide (PDI) molecules in thin supported polystyrene (PS) films at temperatures up to 135 °C. Such high temperatures, so far unreached in single-molecule spectroscopy studies, were achieved using a custom-built setup which allows for restricting the heated mass to a minimum. This enables temperature-dependent single-molecule fluorescence studies of structural dynamics in the temperature range most relevant to the processing and to applications of thermoplastic materials. In order to ensure that polymer chains were relaxed, a molecular weight of 3000 g/mol, clearly below the entanglement length of PS, was chosen. We found significant heterogeneities in the motion of single PDI probe molecules near T(g). An analysis of the track radius of the recorded single-probe molecule tracks allowed for a distinction between mobile and immobile molecules. Up to the glass transition temperature in bulk, T(g,bulk), probe molecules were immobile; at temperatures higher than T(g,bulk) + 40 K, all probe molecules were mobile. In the range between 0 and 40 K above T(g,bulk) the fraction of mobile probe molecules strongly depends on film thickness. In 30-nm thin films mobility is observed at lower temperatures than in thick films. The fractions of mobile probe molecules were compared and rationalized using Monte Carlo random walk simulations. Results of these simulations indicate that the observed heterogeneities can be explained by a model which assumes a T(g) profile and an increased probability of probe molecules remaining at the surface, both effects caused by a density profile with decreasing polymer density at the polymer-air interface.

Fluorescence correlation spectroscopy in polymer science

Fluorescence correlation spectroscopy (FCS) is a well-established technique for studying dynamic processes and interactions with minimal invasion into the corresponding system. Even though FCS has been mainly applied to biological systems, within the last 15 years an increasing number of studies in material sciences have appeared, demonstrating its enormous potential also for this field. Apart from investigations on colloidal systems, polymer science has benefited significantly from this technique. This review will summarize FCS studies on polymer systems and, in particular, focus on the diffusion of differently sized molecular and macromolecular probes in polymer solutions, classical and responsive polymer gels, polymer melts and glasses. It will be discussed how FCS can be used to determine translational and rotational diffusion in polymer solutions and at interfaces, scaling laws, micellization and aggregation and, to some extent, polymer structure including heterogeneity. Thus, FCS should be considered a powerful complement to other methods for the investigation of polymer structure and dynamics.

Intracellular Tracking of Single-plasmid DNA Particles After Delivery by Electroporation

Electroporation is a physical method of transferring molecules into cells and tissues. It takes advantage of the transient permeabilization of the cell membrane induced by electric field pulses, which gives hydrophilic molecules access to the cytoplasm. This method offers high transfer efficiency for small molecules that freely diffuse through electrically permeabilized membranes. Larger molecules, such as plasmid DNA, face several barriers (plasma membrane, cytoplasmic crowding, and nuclear envelope), which reduce transfection efficiency and engender a complex mechanism of transfer. Our work provides insight into the way electrotransferred DNA crosses the cytoplasm to reach the nucleus. For this purpose, single-particle tracking experiments of fluorescently labeled DNA were performed. Investigations were focused on the involvement of the cytoskeleton using drugs disrupting or stabilizing actin and tubulin filaments as the two relevant cellular networks for particle transport. The analysis of 315 movies (~4,000 trajectories) reveals that DNA is actively transported through the cytoskeleton. The large number of events allows a statistical quantification of the DNA motion kinetics inside the cell. Disruption of both filament types reduces occurrence and velocities of active transport and displacements of DNA particles. Interestingly, stabilization of both networks does not enhance DNA transport.

Nanoscopic Visualization of Soft Matter Using Fluorescent Diarylethene Photoswitches

The in situ imaging of soft matter is of paramount importance for a detailed understanding of functionality on the nanoscopic scale. Although super-resolution fluorescence microscopy methods with their unprecedented imaging capabilities have revolutionized research in the life sciences, this potential has been far less exploited in materials science. One of the main obstacles for a more universal application of super-resolved fluorescence microscopy methods is the limitation of readily available suitable dyes to overcome the diffraction limit. Here, we report a novel diarylethene-based photoswitch with a highly fluorescent closed and a nonfluorescent open form. Its photophysical properties, switching behavior, and high photostability make the dye an ideal candidate for photoactivation localization microscopy (PALM). It is capable of resolving apolar structures with an accuracy far beyond the diffraction limit of optical light in cylindrical micelles formed by amphiphilic block copolymers.

Polymers in focus: fluorescence correlation spectroscopy

Fluorescence correlation spectroscopy has been increasingly used in polymer science. In the present perspective, the principles of the method are briefly reviewed, and the temporal and spatial resolutions are critically discussed. Examples of recent findings are summarized, focusing on polymer solutions, environmental parameters, combination with other techniques, near-interface measurements, simulations, and modeling. Finally, desirable new developments are discussed.

Anomalous Diffusion in Thermoresponsive Polymer–Clay Composite Hydrogels Probed by Wide-Field Fluorescence Microscopy

Thermoresponsive materials exhibit an enormous potential for tissue engineering, separation systems, and drug delivery. We investigated the diffusion of laponite clay nanoparticles, which serve as physical cross-linkers to achieve improved material properties in poly(N-isopropylacrylamide) (PNIPAM)-clay composite hydrogels close to the gel point. The networks are formed through physical interactions between PNIPAM chains and clay nanoparticles after these two components are mixed. In contrast to previous studies, a covalent labeling strategy was chosen to minimize the amount of free dyes in solution. Single-particle tracking of the labeled clay nanoparticles showed that their diffusion is anomalous at all temperatures used in this study, reflecting the viscoelastic behavior as a cross-linker. Stepwise heating from 24 to 38 °C resulted in a slight increase of the diffusion coefficient and the anomality parameter α up to the volume phase transition temperature of ca. 31 °C, which was followed by a significant drop of both parameters, reflecting strongly hindered motion of the collapsed nanoparticle aggregates.

More Efficient Photolithographic Synthesis of DNA-Chips by Photosensitization

Protecting groups of the o-nitrophenyl type thatare preferentially used for this purpose have rather low absorption coefficientsat 366nm, the wavelength of the most conveniently used mercury line. The weakabsorptivity of these compounds leads to principal limitations of their light sen-sitivity. Since they have photoreactive triplet states, however, this problem can beovercome by introducing a triplet sensitizer that efficiently absorbs the light andtransfers the electronic energy to the reactive protecting group.The sensitized photodeprotection was studied in detail for the o-nitrophenyl-2-propoxycarbonyl (NPPOC) group

Sortase-Mediated Surface Functionalization of Stimuli-Responsive Microgels

In this work we explored an enzyme-mediated method for selective and efficient decoration of aqueous microgels with biomolecules. Poly(N-vinylcaprolactam) (VCL) microgels with varied amounts of glycidyl methacrylate (GMA) as comonomer incorporated in the microgel shell were synthesized and characterized in regard to their size, swelling degree, and temperature-responsiveness in aqueous solutions. The surface of the PVCL/GMA microgel containing 5 mol % glycidyl methyacrylate was modified by grafting of a specific recognition peptide sequence (LPETG) for Sortase A from Staphylococcus aureus (Sa-SrtAΔ59). Sortase-mediated conjugation of the enhanced Green Fluorescent Protein (eGFP) carrying a N-terminal triglycine tag to LPETG-modified microgels was successfully performed. Conjugation of eGFP to the microgel surface was qualitatively proven by confocal microscopy and by fluorescence intensity measurements. The developed protocol enables a precise control of the amount of eGFP grafted to the microgel surface as evidenced by the linear increase of fluorescence intensity of modified microgel samples. The kinetic of the sortase-mediated coupling reaction was determined by time-dependent fluorescence intensity measurements. In summary, sortase-mediated coupling reactions are a simple and powerful technique for targeted surface functionalization of stimuli-responsive microgels with biomolecules.

Fluorescent Diarylethene Photoswitches : A Universal Tool for Super-Resolution Microscopy in Nanostructured Materials

Super-resolution fluorescence microscopy allows for unprecedented in situ visualization of biological structures, but its application to materials science has so far been comparatively limited. One of the main reasons is the lack of powerful dyes that allow for labeling and photoswitching in materials science systems. In this study it is shown that appropriate substitution of diarylethenes bearing a fluorescent closed and dark open form paves the way for imaging nanostructured materials with three of the most popular super-resolution fluorescence microscopy methods that are based on different concepts to achieve imaging beyond the diffraction limit of light. The key to obtain optimal resolution lies in a proper control over the photochemistry of the photoswitches and its adaption to the system to be imaged. It is hoped that the present work will provide researchers with a guide to choose the best photoswitch derivative for super-resolution microscopy in materials science, just like the correct choice of a Swiss Army Knifes tool is essential to fulfill a given task.

Stimulated Transitions of Directed Nonequilibrium Self-Assemblies

Near-equilibrium stimulus-responsive polymers have been used extensively to introduce morphological variations in dependence of adaptable conditions. Far-less-well studied are triggered transformations at constant conditions. These require the involvement of metastable states, which are either able to approach the equilibrium state after deviation from metastability or can be frozen on returning from nonequilibrium to equilibrium. Such functional nonequilibrium macromolecular systems hold great promise for on-demand transformations, which result in substantial changes in their material properties, as seen for triggered gelations. Herein, a diblock copolymer system consisting of a hydrophilic block and a block that is responsive to both pressure and temperature, is introduced. This species demonstrates various micellar transformations upon leaving equilibrium/nonequilibrium states, which are triggered by a temperature deflection or a temporary application of hydrostatic pressure.