E. Falchini

Measurement of the atmospheric muon flux with the NEMO Phase-1 detector

Abstract The NEMO Collaboration installed and operated an underwater detector including prototypes of the critical elements of a possible underwater km3 neutrino telescope: a four-floor tower (called Mini-Tower) and a Junction Box. The detector was developed to test some of the main systems of the km3 detector, including the data transmission, the power distribution, the timing calibration and the acoustic positioning systems as well as to verify the capabilities of a single tridimensional detection structure to reconstruct muon tracks. We present results of the analysis of the data collected with the NEMO Mini-Tower. The position of photomultiplier tubes (PMTs) is determined through the acoustic position system. Signals detected with PMTs are used to reconstruct the tracks of atmospheric muons. The angular distribution of atmospheric muons was measured and results compared to Monte Carlo simulations.

The Data Acquisition and Transport Design for NEMO Phase 1

The NEMO collaboration proposes to build an underwater neutrino telescope located South-East off the Sicily coast. This paper describes the concepts underlying the communication link design going over the whole data acquisition and transport from the front-end electronics to the module sending data on-shore through a fiber optic link which relies on Dense Wavelength Division Multiplexing. An on-shore board, plugged into a PC, extracts and distributes data both to first-level trigger and control systems. Underwater apparatus monitoring and controls are guaranteed by oceanographic instruments and dedicated sensors, whose data are packed and sent back to shore using the same optical link. The communication is fully bidirectional, allowing transmission of timing and control commands. The architecture described here provides a complete real-time data transport layer between the onshore laboratory and the underwater detector. During winter 2006 a first prototype of the apparatus has been deployed: calibration results from the currently working system are here reported.

NEMO: A PROJECT FOR A KM3 UNDERWATER DETECTOR FOR ASTROPHYSICAL NEUTRINOS IN THE MEDITERRANEAN SEA

The status of the project is described: the activity on long term characterization of water optical and oceanographic parameters at the Capo Passero site candidate for the Mediterranean km3 neutrino telescope; the feasibility study; the physics performances and underwater technology for the km3; the activity on NEMO Phase 1, a technological demonstrator that has been deployed at 2000 m depth 25 km offshore Catania; the realization of an underwater infrastructure at 3500 m depth at the candidate site (NEMO Phase 2).

Fiber laser hydrophones as pressure sensors

The development of hydro-phonic sensors for deep see acoustic detection is described. The sensitive element is an erbium-doped single mode fiber laser, with the cavity delimited by two Bragg grating reflectors. The variations of temperature and pressure perturb the cavity, inducing a wavelength shift. The very narrow emission band of the laser, together with the interferometric detection technique, allows a dynamic pressure sensitivity in the μPa range. The devices have been characterized both optically and acoustically in a closed tub. A resin coating of the fiber laser has been experimented: this technique improves the sensitivity by more than one order of magnitude. The high sensitivity makes these sensors suitable for the detection of the acoustic waves induced in water by Ultra High Energy Neutrinos.