Edson Tomaz

Ambiental volatile organic compounds in the megacity of São Paulo

In order to characterize the composition of the main urban air organic compounds in the megacity of Sao Paulo, analysis of samples collected during the winter of 2003 downtown was carried out. The samplings were performed on the roof of a building in the commercial center of Sao Paulo. Hydrocarbons and carbonyls compounds were collected on August 4, 5 and 6. Comparing to previous data, the concentration of hydrocarbons presented no decrease in the concentration, except for the aldehydes, which decreased when compared to previous data. Among the HCs species analyzed, the highest concentrations observed were those of toluene (7.5 ± 3.4 ppbv), n-decane (3.2 ± 2.0 ppbv), benzene (2.7 ± 1.4 ppbv) and 1,3,5-trimethylbenzene (2.2 ± 1.5 ppbv).

INVENTÁRIO DE EMISSÃO DE FONTES VEICULARES DA REGIÃO METROPOLITANA DE CAMPINAS, SÃO PAULO

The degradation of air quality in great urban centers is noted by frequent critical episodes of air pollution and public health issues, and vehicles are a great source of pollutant emissions, mainly derived from combustion processes. A database is needed to direct mitigation of emissions. The main objective of this work is to present it as an emissions inventory. The results show that vehicular sources of CO, HC and NOx represent over 75% of total emissions in the MRC. Besides, the proposed methodology presented results consistent with the literature

Air pollution and the influence of sources on Paulínia (Brazil) and surroundings

The air quality in the industrial area and surroundings of the city of Paulinia (state of Sao Paulo, Brazil) has been investigated by analysing the concentration of air pollutants (SO2, PM10, NO, NO2, CO and ozone) and identifying the main sources of air pollution. A mobile pollutant monitoring unit was used to collect the data at five different sites from November 2000 to July 2002. Critical pollutants were determined based on air quality standards, and sources were identified by principal component analysis. Photochemical reactions play an important role in Paulinias air pollution: three out of five monitored sites showed levels exceeding the standard air quality of ozone. SO2 and PM10 appeared as pollutants deserving special attention. All the monitored sites showed vehicles and industrial plants (which release SO2) to be significant sources of pollution. Depending on the location, ozone was related mainly with vehicular or industrial sources.

A CFD model for pollutant dispersion in rivers

Studies have shown that humankind will experience a water shortage in the coming decades. It is therefore paramount to develop new techniques and models with a view to minimizing the impact of pollution. It is important to predict the environmental impact of new emissions in rivers, especially during periods of drought. Computational fluid dynamics (CFD) has proved to be an invaluable tool to develop models able to analyze in detail particle dispersion in rivers. However, since these models generate grids with thousands (even millions) of points to evaluate velocities and concentrations, they still require powerful machines. In this context, this work contributes by presenting a new three-dimensional model based on CFD techniques specifically developed to be fast, providing a significant improvement in performance. It is able to generate predictions in a couple of hours for a one-thousand-meter long section of river using Pentium IV computers. Commercial CFD packages would require weeks to solve the same problem. Another innovation inb this work is that a half channel with a constant elliptical cross section represents the river, so the Navier Stokes equations were derived for the elliptical system. Experimental data were obtained from REPLAN (PETROBRAS refining unit) on the Atibaia River in Sao Paulo, Brazil. The results show good agreement with experimental data.

Degradation of volatile organic compounds in the gas phase by heterogeneous photocatalysis with titanium dioxide/ultraviolet light

This work presents an overview over heterogeneous photocatalysis performed in gas phase towards the degradation of o-xylene, n-hexane, n-octane, n-decane, methylcyclohexane and 2,2,4-trimethylpentane. The experimental set-up composed by a titanium plug flow reactor vessel contained a quartz tube with a 100 W UV lamp placed at center position from 1.7 cm to the quartz wall. A titanium dioxide film was immobilized on the internal walls of the reactor and used as catalyst. All measurements were taken after reaching steady state condition and evaluated at the inlet and outlet of the system. Conversion rates were studied in a wide range of residence times yielding to a 90% or above conversion as from 20 seconds of residence time. During experiments the temperature of reactor’s wall was monitored and remained between 52 and 62 °C. Temperature influence over degradation rates was negligible once a control experiment performed at 15 °C did not modify outgoing results. Humidity effect was also evaluated showing an ideal working range of 10 - 80% with abrupt conversion decay outside the range. By varying inlet concentration between 60 and 110 ppmv the VOC degradation curves remained unchanged. Loss over catalytic activity was only observed for o-xylene after 30 minutes of reaction, the catalyst was reactivated with a solution of hydrogen peroxide and UV light followed by additional deposition of the catalytic layer. The kinetic study suggests a first order reaction rate. Implications: The study of effective and economically viable techniques on the treatment of volatile organic compounds (VOCs) has being highlighted as an important parameter on the environmental research. The heterogeneous photocatalysis in gas phase was proved to be an effective process for the degradation of the nonaromatic VOCs tested, yielding high conversion values for the optimized systems.

Software para modelagem de dispersão de efluentes em rios

This work presents a three-dimensional model for the dispersion of effluents in rivers using Computational Fluid Dynamics (CFD) techniques. There are several models in the literature, some of which even analyze complex flows. They are however restricted to small river sections. The main contribution of this work is that it proposes a new software capable of predicting the dispersion of effluents in very large open channels. The model is very fast, an unusual feature of CFD models. Due to this, it is possible to predict the dispersion of substances in long sections of rivers with some kilometers in extension. Moreover, multiple emissions can be analyzed by the model, allowing its use as a predictive tool to analyze and guide management decisions on future industrial installations near rivers. Results for the dispersion of an inert emission in a river near Campinas (Brazil) were used to validate the model.

Steady state modeling and numerical simulation of the rotary kiln incinerator and afterburner system

Abstract A model based on one-dimensional approach which considers the radiation within each zone and between immediately adjacent zones as well as conduction and convection is proposed in this work. The zone modeling and jet or flame, annular gas and solid flowing streams approach is adopted. The kiln and afterburner are splitted of axially into equal width zones, where each stream is considered well stirred. The heat capacities, thermal condutivities and viscosities are calculated taking into account the dependence on temperature and compositions. The influences of the several parameters, flame geometry approximation, as well as, the mass loss rate specification on flame and exit temperature are analyzed.

Power generation and gaseous emissions performance of an internal combustion engine fed with blends of soybean and beef tallow biodiesel

ABSTRACT This study aimed to compare the performance of an internal combustion engine fed with blends of biodiesel produced from soybean and diesel, and blends of biodiesel produced from beef tallow and diesel. Performance was evaluated in terms of power generated at low loading conditions (0.5, 1.0 and 1.5 kW) and emission of organic and inorganic pollutants. In order to analyse inorganic gases (CO, SO2 and NOx), an automatic analyser was used and the organic emissions (benzene, toluene, ethylbenzene and xylene – BTEX) were carried out using a gas chromatograph. The results indicate that the introduction of the two biodiesels in the fuel caused a reduction in CO, SO2 and BTEX emissions. In addition, the reduction was proportional to the increase in loading regime. Beef tallow biodiesels presented better results regarding emission than soybean biodiesels. The use of pure biodiesels also presented a net reduction in pollutant gas emissions without hindering the engine generator performance.

Concentration of selected VOC in Metropolitan Region of São Paulo

Concentrations of selected Volatile Organic Compounds (VOC) were measured at five different sites in the Metropolitan Region of Sao Paulo (MRSP) in campaigns performed in 2001 and 2002. Active air sampling was employed to adsorb VOC in tubes packed with TENAX TA. The analyses of the samples were carried out by Thermal Desorption followed by Gas Chromatography with Flame Ionisation (FID) and/or Mass Spectrometry (MS) Detection. This work emphasizes the significant daily variation of VOC concentration during the sampling period. Among the selected VOC, toluene had the highest atmospheric concentrations, followed by benzene, m,p-xylenes and n-decane/1,2,4-TMB. Some differences were found among the sampling sites, but these were not significant because the concentrations range was in the same order of magnitude. The comparison of VOC levels of this research with previous works in the MRSP indicated that our results presented lower concentrations.