Enikő Tatár

Leaching of antimony from polyethylene terephthalate (PET) bottles into mineral water.

The Sb leaching from polyethylene terephthalate (PET) package material into 10 different brands of still (non-carbonated) and sparkling (carbonated) Hungarian mineral water purchased in supermarkets was investigated by inductively coupled plasma sector field mass spectrometry (ICP-SF-MS). The Sb concentration measured in PET package materials varied between 210 and 290 mg/kg. Generally, the Sb concentration of still mineral water was lower than that of sparkling in the case of identical storage time. For modelling improper storage conditions, storage time (10-950 days), temperature (22 degrees C-70 degrees C), illumination (dark vs. 23 W daylight lamp for 116 h) as well as bottle volume (0.5, 1.0 and 1.5 L) were taken into consideration. Under certain extreme light and temperature storage conditions, the Sb concentration of some samples exceeded the concentration value of 2 ng/mL. The extent of Sb leaching from the PET recipients of different brands of mineral water can differ by even one order of magnitude in experiments conducted under the same conditions. Thus, the adequate selection of the polymer used for the production of the PET bottle for the solar water disinfection (SODIS) procedure seems to ensure low Sb levels in the water samples.

Study on the leaching of phthalates from polyethylene terephthalate bottles into mineral water

Carbonated and non-carbonated mineral water samples bottled in 0.5-L, 1.5-L and 2.0-L polyethylene terephthalate (PET) containers belonging to three different water brands commercialized in Hungary were studied in order to determine their phthalate content by gas chromatography-mass spectrometry. Among the six investigated phthalates, diisobutyl phthalate, di-n-butyl-phthalate, benzyl-butyl phthalate and di(2-ethyl-hexyl) phthalate (DEHP) were determined in non-carbonated samples as follows: <3.0 ng L(-1)-0.2 μg L(-1), <6.6 ng L(-1)-0.8 μg L(-1), <6.0 ng L(-1)-0.1 μg L(-1) and <16.0 ng L(-1)-1.7 μg L(-1), respectively. Any of the above-mentioned phthalate esters could be detected in carbonated mineral water samples. DEHP was the most abundant phthalate in the investigated samples. It could be detected after 44 days of storage at 22 °C and its leaching was the most pronounced when samples were stored over 1200 days. Mineral water purchased in PET bottles of 0.5L had the highest phthalate concentrations compared to those obtained for waters of the identical brand bottled in 1.5-L or 2.0-L PET containers due to the higher surface/volume ratio. No clear trend could be established for phthalate leaching when water samples were kept at higher temperatures (max. 60 °C) showing improper storage conditions. Phthalate determination by pyrolysis-gas chromatography/mass spectrometric measurements in the plastic material as well as in the aqueous phase proved the importance of the quality of PET raw material used for the production of the pre-form (virgin vs. polymer containing recycled PET).

Impact of two iron(III) chelators on the iron, cadmium, lead and nickel accumulation in poplar grown under heavy metal stress in hydroponics.

Poplar (Populus jacquemontiana var. glauca cv. Kopeczkii) was grown in hydroponics containing 10 μM Cd(II), Ni(II) or Pb(II), and Fe as Fe(III) EDTA or Fe(III) citrate in identical concentrations. The present study was designed to compare the accumulation and distribution of Fe, Cd, Ni and Pb within the different plant compartments. Generally, Fe and heavy-metal accumulation were higher by factor 2-7 and 1.6-3.3, respectively, when Fe(III) citrate was used. Iron transport towards the shoot depended on the Fe(III) chelate and, generally, on the heavy metal used. Lead was accumulated only in the root. The amounts of Fe and heavy metals accumulated by poplar were very similar to those of cucumber grown in an identical way, indicating strong Fe uptake regulation of these two Strategy I plants: a cultivar and a woody plant. The Strategy I Fe uptake mechanism (i.e. reducing Fe(III) followed by Fe(II) uptake), together with the Fe(III) chelate form in the nutrient solution had significant effects on Fe and heavy metal uptake. Poplar appears to show phytoremediation potential for Cd and Ni, as their transport towards the shoot was characterized by 51-54% and 26-48% depending on the Fe(III) supply in the nutrient solution.

Influence of different bentonites on the rare earth element concentrations of clarified Romanian wines

The rare earth element (REE) concentrations of 19 Romanian young wine samples originating from the Dealurile Moldovei viticulture area were determined by double focusing inductively coupled plasma mass spectrometry (DF-ICP-MS) after microwave-assisted digestion with nitric acid. The determination of Eu was hampered by the BaO molecular interference. Generally, the red wine samples were more concentrated for REEs than the white wine samples studied. The REE concentrations of the four bentonites (Gelbenton, Evergel, BW200, Tükrös) determined after their fusion were higher by three orders of magnitude than those of the wine samples. After a simulated wine purification process performed with these bentonite samples and a red and white pool samples, the REE concentrations of the clarified wine samples increased by 1.2-1.5 times for red, and 1.3-3 times for white wines in case of the fibrous bentonite sample (Gelbenton), by about 2-5 times in case of the bentonite containing ovalbumin, caseine and gelatine (Evergel), meanwhile this factor was about 20-25 for Na bentonite powder samples (BW200, Tükrös). On basis of the chemometric evaluation using the REE concentrations as input data, the majority of the Feteasca wines belonged to the same cluster as well as the two Cabernet Sauvignon to another subcluster. The adequate choice of the bentonite may allow the use of REEs as fingerprints for determining the wine provenance.

Accumulation and distribution of iron, cadmium, lead and nickel in cucumber plants grown in hydroponics containing two different chelated iron supplies

Cucumber plants grown in hydroponics containing 10 μM Cd(II), Ni(II) and Pb(II), and iron supplied as Fe(III) EDTA or Fe(III) citrate in identical concentrations, were investigated by total-reflection X-ray fluorescence spectrometry with special emphasis on the determination of iron accumulation and distribution within the different plant compartments (root, stem, cotyledon and leaves). The extent of Cd, Ni and Pb accumulation and distribution were also determined. Generally, iron and heavy-metal contaminant accumulation was higher when Fe(III) citrate was used. The accumulation of nickel and lead was higher by about 20% and 100%, respectively, if the iron supply was Fe(III) citrate. The accumulation of Cd was similar. In the case of Fe(III) citrate, the total amounts of Fe taken up were similar in the control and heavy-metal-treated plants (27-31 μmol/plant). Further, the amounts of iron transported from the root towards the shoot of the control, lead- and nickel-contaminated plants were independent of the iron(III) form. Although Fe mobility could be characterized as being low, its distribution within the shoot was not significantly affected by the heavy metals investigated.

Relationship between arsenic content of food and water applied for food processing

As part of a survey conducted by the Central Agricultural Office of Hungary, 67 food samples including beverages were taken from 57 food industrial and catering companies, 75% of them being small and medium-sized enterprises (SMEs). Moreover, 40% of the SMEs were micro entities. Water used for food processing was simultaneously sampled. The arsenic (As) content of solid food stuff was determined by hydride generation atomic absorption spectrometry after dry ashing. Food stuff with high water content and water samples were analyzed by inductively coupled plasma mass spectrometry. The As concentration exceeded 10 μg/L in 74% of the water samples taken from SMEs. The As concentrations of samples with high water content and water used were linearly correlated. Estimated As intake from combined exposure to drinking water and food of the population was on average 40% of the daily lower limit of WHO on the benchmark dose for a 0.5% increased incidence of lung cancer (BMDL0.5) for As. Five settlements had higher As intake than the BMDL0.5. Three of these settlements are situated in Csongrád county and the distance between them is less than 55 km. The maximum As intake might be 3.8 μg/kg body weight.

Determination of lead isotope ratios in clinopyroxene by inductively coupled plasma mass spectrometry applying solution nebulization or laser ablation sample introduction techniques

Lead isotope ratios were determined in clinopyroxene originating from Hungary and in a Japanese basalt standard (JB-2) by a single-collector inductively coupled plasma sector field mass spectrometer applying solution nebulization and laser ablation (LA) as sample introduction techniques. The solutions were prepared by dissolution of samples in a mixture of HF/HNO3 and isolation of analyte by Pb-selective crown ether resin. The separation of Pb from the matrix and other compounds lowered the contribution of the major interference (204Hg) to the counts of 204Pb to less than 1%. More than 94.5% and 98.4% of the Pb content of the clinopyroxene and JB-2 samples, respectively, could be collected on the resin. The relative standard deviations of the measured Pb isotope ratios obtained by solution technique changed between 0.3% and 0.5%. In the case of LA with repetition rate of 10 Hz and spot size of 100 µm these values were between 1.3% and 1.6%.