Estelle Lebègue

Electrochemical Detection of Single Phospholipid Vesicle Collisions at a Pt Ultramicroelectrode

We report the collision behavior of single unilamellar vesicles, composed of a bilayer lipid membrane (BLM), on a platinum (Pt) ultramicroelectrode (UME) by two electrochemical detection methods. In the first method, the blocking of a solution redox reaction, induced by the single vesicle adsorption on the Pt UME, can be observed in the amperometric i-t response as current steps during the electrochemical oxidation of ferrocyanide. In the second technique, the ferrocyanide redox probe is directly encapsulated inside vesicles and can be oxidized during the vesicle collision on the UME if the potential is poised positive enough for ferrocyanide oxidation to occur. In the amperometric i-t response for the latter experiment, a current spike is observed. Here, we report the vesicle blocking (VB) method as a relevant technique for determining the vesicle solution concentration from the collisional frequency and also for observing the vesicle adhesion on the Pt surface. In addition, vesicle reactor (VR) experiments show clear evidence that the lipid bilayer membrane does not collapse or break open at the Pt UME during the vesicle collision. Because the bilayer is too thick for electron tunneling to occur readily, an appropriate concentration of a surfactant, such as Triton X-100 (TX100), was added in the VR solution to induce loosening of the bilayer (transfection conditions), allowing the electrode to oxidize the contents of the vesicle. With this technique, the TX100 effect on the vesicle lipid bilayer permeability can be evaluated through the current spike charge and frequency corresponding to redox vesicle collisions.

Toward fully organic rechargeable charge storage devices based on carbon electrodes grafted with redox molecules

Activated carbon powders modified with naphthalimide and 2,2,6,6-tetramethylpiperidine-N-oxyl were assembled into a hybrid electrochemical capacitor containing an organic electrolyte. The fully organic rechargeable system demonstrated an increase in specific capacitance up to 51%, an extended operating voltage of 2.9 V in propylene carbonate, compared to 1.9 V for the unmodified system, and a power 2.5 times higher.

Modification of activated carbons based on diazonium ionsin situ produced from aminobenzene organic acid without addition of other acid

Activated carbon products modified with a benzene sulfonic acid group were prepared based on the spontaneous reduction of diazonium salts in situ generated in water without addition of an external acid. The diazotization reaction assisted by the organic acid substituent, produced at once amine, diazonium and triazene functionalities that maximize the grafting yield by a chemical cooperation effect.

Responsive Polydiacetylene Vesicles for Biosensing Microorganisms

Polydiacetylene (PDA) inserted in films or in vesicles has received increasing attention due to its property to undergo a blue-to-red colorimetric transition along with a change from non-fluorescent to fluorescent upon application of various stimuli. In this review paper, the principle for the detection of various microorganisms (bacteria, directly detected or detected through the emitted toxins or through their DNA, and viruses) and of antibacterial and antiviral peptides based on these responsive PDA vesicles are detailed. The analytical performances obtained, when vesicles are in suspension or immobilized, are given and compared to those of the responsive vesicles mainly based on the vesicle encapsulation method. Many future challenges are then discussed.

Microbial Fuel Cells—Wastewater Utilization

The content and properties of common wastewater streams are detailed together with current wastewater treatment technology. The principle of microbial fuel cells (MFCs) where living microorganisms organized into surface biofilms catalyze electrode reactions is then explained. Laboratory prototype MFCs that treat wastewater at the anode (oxidation of organic compounds to carbon dioxide) and/or at the cathode (reduction of inorganic pollutants such as nitrate), coupled to electrical energy recovery, are discussed. The technological locks and prospects for future application of MFCs to wastewater treatment on a large scale are addressed.

Reductive electrografting of in situ produced diazopyridinium cations: Tailoring the interface between carbon electrodes and electroactive bacterial films

Carbon electrodes were functionalized through the reduction of diazopyridinium cations that are produced from in situ diazotization of 2-, 3- and 4-aminopyridine. Diazopyridinium salts were much more rarely employed for surface functionalization than other aryldiazonium derivatives. A study combining X-ray Photoelectron Spectroscopy (XPS), contact angle, ellipsometry, Atomic Force Microscopy (AFM) measurements and electrochemical analyses demonstrates that films obtained from 4-diazopyridinium cations are hydrophilic, dense, compact but sufficiently thin to preserve fast electronic transfer rate, being then relevant to efficiently tailor the interface between the anode surface and an electroactive biofilm. Microbial Fuels Cells (MFCs) with pyridine-functionalized graphite anodes exhibit faster development and improved performances than MFCs operating with bare graphite anodes.

Electrochemical Detection of pH-Responsive Grafted Catechol and Immobilized Cytochrome c onto Lipid Deposit-Modified Glassy Carbon Surface

The electrochemical systems of both grafted catechol as a pH-responsive electrophore and immobilized cytochrome c as a model redox protein are detected by cyclic voltammetry at an optimized lipid deposit-modified glassy carbon electrode. The catechol covalent grafting is successfully performed by the one-pot/three-step electrochemical reduction of 3,4-dihydroxybenzenediazonium salts generated in situ from 4-nitrocatechol. The resulting glassy carbon electrode electrochemically modified by grafted catechol species is evaluated as an efficient electrochemical pH sensor. The optimized molar ratio for the lipid deposit, promoting cytochrome c electrochemical activity in solution onto glassy carbon electrode, is reached for the lipid mixture composed of 75% 1,2-dioleoyl-sn-glycero-3-phosphocholine and 25% cardiolipin. Cytochrome c immobilization into the optimized supported lipid deposit is efficiently achieved by cyclic voltammetry (10 cycles) recorded at the modified glassy carbon electrode in a cytochrome c solution. The pH-dependent redox response of the grafted catechol and that of the immobilized cytochrome c are finally detected at the same lipid-modified glassy carbon electrode without alteration of their structure and electrochemical properties in the pH range 5–9.