Eui-Hwan Kim

The Biomechanical Evaluation of Functional Insoles

The purpose of this study was to compare and biomechanical evaluate the effects of three varying functional insoles on the kinematics of the lower extremities and foot pressure distribution during gait. For this 12 subjects participated in this study and each worn the 3 functional insoles during gait which kinematics, kinetics, electromyography and foot pressures were recorded. The function on the first insole was to absorb shock and increase the dynamic stability, the second was a gel type to absorb shock, and the third was to massage the center regions of the foot sole. the results were as follows; the first insole reduced the joints range of motion and reduced muscular fatigue, the second insole reduce the maximum, total and average foot pressures. Finally, the third insole produced larger values for the contact times and contact area.

A Biomechanical Analysis of Four Different Taekwondo Body Punch Types in Horseback-Riding Stance

The purpose of this study is to compare 4 different body punch types(type 1: a punch using a shoulder, type 2: a punch using a waist, type 3: a punch using lower extremities, and type 4: a punch with elbows by your side at chest level) in horseback-riding stance and establish suitable teaching theor...

The Effects of 12 Week Balance Ability Improvement Exercise to the Changes of Selected Joint Angles and Ground Reaction Forces during Down Staircase Walking

The purpose of this study was to investigate the effects of balance ability improvement exercise program which applied to the elderly people for increasing balance, stability and range of motion. Ten elderly people and ten university students were recruited as the subjects. Kinematic data were collected by seven real-time infrared cameras while subjects walk stair descent as a pre-test. Korean folk dance exercise program was applied to the elderly for 12 weeks. Same experiment on stair descent walk was performed as post-test. Results indicated that CM movement and selected joint angle patterns of elderly group after treatment changed to the similar patterns of young group. However, ankle joint angle and vertical GRF of elderly group after treatment also increased compared to those of the elderly group before treatment. This might be explained by the fact that elderly used a different walking strategy which maximize support base for increasing stability. Overall, these results indicated that the exercise treatment may affect to adapt and improve the gait pattern of stair descent of elderly people.

A Kinematic Comparative Analysis of Yoko Ukemi(side breakfall) by Each Stage in Judo[ I ]

The purpose of this study was to analyze the comparisons of the kinematical variables when performing Yoko Ukemi(side breakfall) by three Stage in Judo. The subjects were four male judokas who were trainees Y. I. University Squad members and the Yoko Ukemi were filmed by two S-VHS 16mm video cameras(60fields/sec.). The selected times were subject to KWON 3D analysis program and kinematical analysis to compare variables of three Yoko Ukemi. Temporal variables(total time-required : TK, TR by each phase), the body part touched order on the mat and COG variables were computed through video analysis while performing right Yoko Ukemi by three stage. From the data analysis and discussion, the following conclusions were drawn : 1. Temporal variables : total time-required(TR) when performing Yoko Ukemi(side breakfall) by each stage, the first stage(full squat posture: FP : 1.11sec.) showed the shortest time, the next was 3rd(Shizenhontai, straight natural posture: NP : 1.41sec.), and 2nd(Jigohontai, straight defensive posture, DP : 1.42sec.), respectively- 2. TR when performing Yoko Ukemi(side breakfall) by each stage, and phase : the first phase(take of phase, average 0.68sec.) showed the longest time, next was the third phase(ukemi phase, 0.39sec.), and the second phase(air phase, 0.23sec.), respectively. 3. When performing yore Ukemi the body part touched order and TR on the mat : hip(0.94sec.) showed the shortest time, the next was elbow hand(0.97sec.), back(0.98sec.), and shoulder(1.04sec.) order. The hip part touched on the mat the first, but slap the mat in order to alleviate the shock try hand palm and forearm before receiving impact (difference 0.03sec,) 4. Vertical COG variables in each event by each stage : e1(ready position, average 78.33cm) moved the highest, the next was e2(jumping position, 70.14cm), e3(transition position, average 64.00cm), e4(landing position, average 35.99cm), and e5(ukemi position, average 18.32cm) order, gradual decrease respectively. And the difference of COG were showed in initial by each stage, because position fo Yoko Ukemi was difference by each stage in preparation position, but in accordance with executing of Ukemi phase that difference of COG was by decreasing, almost equal displacement in e4(landing) and e5(Ukemi)position finally.

Biomechanical Analysis of Men`s High Jump Medalists in IAAF World Championships, Daegu 2011

The purpose of this study was to perform a kinematic analysis of the high jump techniques of the three men`s medalists at the 2011 IAAF Championships in Daegu (August 27-September 4, 2011). In particular, a three-dimensional coordinates method was used to analyze the last three strides before touchdown, the touchdown techniques, and the movements after takeoff toward the bar. An analysis of the, data for the biomechanical characteristics of the world`s best high jumpers could contribute to an improvement in the performance of a national high jumper. The first conclusion of the data analysis was that the arm movements of the gold medalist, J. Williams, had a single arm form, whereas the arm movements of the other medalists were a double arm form. Second, the difference in the knee joint angles upon touchdown and toe-off was . Third, J. Williams achieved his maximum CM height after takeoff (1.26 m) using the maximum flexion of his knee joint. Fourth, the foot contact duration of A. Dmitrik (0.11 s) was the shortest among the medalists, and the ratio for his transformation of horizontal velocity to vertical velocity was the greatest (75.25%) among the three. Last, the maximum CM height of T. Barry was the greatest, and his foot contact duration was the longest.

Biomechanical Analysis of Take-Off Techniques of Women's High Jump Winners at IAAF World Championships, Daegu 2011

The purpose of this study was to analyze, from a kinematical point of view, the high jump techniques of three women`s high jump winners at the IAAF World Championships, Daegu 2011. The trends for the techniques of the world`s top high jumpers were examined, with a view toward adapting these techniques to the physical characteristics of Korean women`s high jumpers. It was valuable that Di Martino, who was the shortest in height, was able to win a medal by using a single arm swing take-off technique, along with a half flexed leading leg swing to attain a deep arch and clear the bar. This showed that the world`s top athletes used jumping techniques with no decrease in the run-up velocity at the take-off. Furthermore, It appeared that the knee joint angle at take-off had a direct effect on the body position at take-off (H1).

The Effect of Form and Hardness of Outsoles on the Motion of the Lower Extremity Joints and on Foot Pressure during Gait

The purpose of this study was to analysis the effect of form and hardness of outsoles on the motion of the lower extremity joints and on foot pressure during gait. The subjects were 15 women(mean age, 48.5±2.4 years), who had no serious musculoskeletal, coordination, balance or joint/ligament problems within 1 year prior to the study. The pelvic tilt, joint angles at the lower extremities and the vertical ground reaction force(GRF) were compared during gait with 3 types of shoes (A, B, C) by using one-way repeated ANOVA(p<.05). During gait, the peak tilt angle and the range of motion(ROM) of the ankle and knee joints were found to be significantly different among the 3 types of shoes. The type C shoes showed a significantly lower mean second maximum vertical GRF than types A and B. The curved outsoles of type C shoes, which had a form and hardness different from those of A and B, was designed strategically for walking shoes to provide stability to the Additionally, type C induced the dispersion of eccentric pressure and made the center of pressure roll over to the center line of the foot.

The Biomechanical Evaluation of New Walking-shoes

This study was to analysis the kinematic and kinetic differences between new walking shoe(NWS : RYN) and general walking shoe(GWS). The subjects for this study were 10 male adults who had the walking pattern of rearfoot shrike with normal foot. The movement of one lower leg was measured using plantar pressure and Vicon Motion Analysis Program(6 MX13 and 2 MX40 cameras : 100 f / s) while the subjects walked at the velocity(1.5m/s. on 2m).. The results of this study was as follows : 1. The NWS was better than the GWS that caused injuries such as adduction, abduction and pronation are reduced While walking on a perpendicular surface, the landing angle and the knees angles were extensive which makes walking more safe which reduces anxiety and uneasiness. 2. The bottom of the NWS were now made into a more circular arch which supports the weight of the body and reduces the irregular angles when wearing GWS. This arch made the supporting area more wide which made the upholding the trunk of the body more effective. The whole bottom of the foot that supports the weight is more flexible in addition, increases the safeness of walking patterns and the momentum of the body. 3. The moment the heel of the foot of the NWS touch the ground, the range of the pressure were partially notable and the range of the pressure on the upper part of the thigh were dispersed The injuries that occurred while walking. primary factors when a shock related injuries are reduced Judgements of the impacts of the knees and the spinal column dispersing could be made.

The Biomechanical Comparison of Functional Insoles

The purpose of this study was to compare and evaluate the effects of three varying functional insoles on the kinematics of the lower extremities and foot pressure distribution during gait. For this, 12 subjects participated in this study and each worn the 3 functional insoles during gait while kinematics, kinetics, electromyography and foot pressures were recorded. The function on the first insole was to absorb shock and increase the dynamic stability, the second was a gel type to absorb shock, and the third was to massage the center regions of the foot sole. The results were as follows; the first insole reduced the joints range of motion and reduced muscular fatigue, the second insole reduce the maximum, total and average foot pressures. Finally, the third insole produced larger values for the contact times and contact area.

Kinematic Analysis of T-Stop Motion by Inline Skate Rolling Speed

The purpose of this study was to investigate the kinematical analysis of T-stop motion by inline skate rolling speed. Six subjects were participated in the experiment(age: yrs, weight: , height: , career: yrs). The study method adopted 3-dimensional analysis and 2 cameras for filming to analyze the required displacement of center of mass, displacement of right and left hip joint, displacement of right and left knee joint, displacement of trunk tilt using by APAS. The results were as follows; In anterior-posterior displacement of COM, the faster rolling speed, the longer displacement at phase 2. In vertical displacement of COM, the faster rolling speed, the lower displacement. In medial-lateral displacement of COM, there was no significant on rolling speed. In angular displacement of right thigh segment, the faster rolling speed, the bigger displacement in X and Z axis. In angular displacement of left thigh segment, the faster rolling speed, the lower displacement in X axis. In angular displacement of right shank segment, the faster rolling speed, the bigger displacement in Z axis. In angular displacement of left shank segment, the faster rolling speed, the bigger displacement in X and Y axis. In angular displacement of trunk segment, the faster rolling speed, the bigger displacement in Z axis.