F. Javier Montes Ruiz-Cabello

Attractive Forces between Charged Colloidal Particles Induced by Multivalent Ions Revealed by Confronting Aggregation and Direct Force Measurements

Interactions involving charged particles in the presence of multivalent ions are relevant in wide-range of phenomena, including condensation of nucleic acids, cement hardening, or water treatment. Here, we study such interactions by combining direct force measurements with atomic force microscopy (AFM) and aggregation studies with time-resolved light scattering for particles originating from the same colloidal suspension for the first time. Classical DLVO theory is found to be only applicable for monovalent and divalent ions. For ions of higher valence, charge inversion and additional non-DLVO attractive forces are observed. These attractive forces can be attributed to surface charge heterogeneities, which leads to stability ratios that are calculated from direct force measurements to be higher than the experimental ones. Ion-ion correlations are equally important as they induce the charge inversion in the presence of trivalent or tetravalent ions, and they enhance the surface charge heterogeneities. Such heterogeneities therefore play an essential role in controlling interactions in particle suspensions containing multivalent ions.

Measurements of dispersion forces between colloidal latex particles with the atomic force microscope and comparison with Lifshitz theory

Interaction forces between carboxylate colloidal latex particles of about 2 μm in diameter immersed in aqueous solutions of monovalent salts were measured with the colloidal probe technique, which is based on the atomic force microscope. We have systematically varied the ionic strength, the type of salt, and also the surface charge densities of the particles through changes in the solution pH. Based on these measurements, we have accurately measured the dispersion forces acting between the particles and estimated the apparent Hamaker constant to be (2.0 ± 0.5) × 10(-21) J at a separation distance of about 10 nm. This value is basically independent of the salt concentration and the type of salt. Good agreement with Lifshitz theory is found when roughness effects are taken into account. The combination of retardation and roughness effects reduces the value of the apparent Hamaker constant and its ionic strength dependence with respect to the case of ideally smooth surfaces.

Accurate predictions of forces in the presence of multivalent ions by Poisson-Boltzmann theory.

Forces between positively and negatively charged colloidal particles across aqueous salt solutions containing multivalent ions are measured directly with the atomic force microscope (AFM). The measurements are interpreted quantitatively with Poisson-Boltzmann (PB) theory. Thereby, the surface potentials and regulation properties of the particle surfaces are extracted from symmetric measurements between the same types of particles. This information is used to predict force profiles in the asymmetric situations involving different types of particles without any adjustable parameters. These predictions turn out to be very accurate, which demonstrates that the mean-field PB theory is reliable down to distances of about 5 nm. While various reports in the literature indicate that this theory should fail due to neglect of ion correlations, such effects seem important only at higher concentrations and smaller distances.

Interaction Forces and Aggregation Rates of Colloidal Latex Particles in the Presence of Monovalent Counterions

Force profiles and aggregation rates involving positively and negatively charged polystyrene latex particles are investigated in monovalent electrolyte solutions, whereby the counterions are varied within the Hofmeister series. The force measurements are carried out with the colloidal probe technique, which is based on the atomic force microscope (AFM), while the aggregation rates are measured with time-resolved multiangle light scattering. The interaction force profiles cannot be described by classical DLVO theory, but an additional attractive short-ranged force must be included. An exponential force profile with a decay length of about 0.5 nm is consistent with the measured forces. Furthermore, the Hamaker constants extracted from the measured force profiles are substantially smaller than the theoretical values calculated from dielectric spectra. The small surface roughness of the latex particles (below 1 nm) is probably responsible for this deviation. Based on the measured force profiles, the aggregation rates can be predicted without adjustable parameters. The measured absolute aggregation rates in the fast regime are somewhat lower than the calculated ones. The critical coagulation concentration (CCC) agrees well with the experiment, including the respective shifts of the CCC within the Hofmeister series. These shifts are particularly pronounced for the positively charged particles. However, the consideration of the additional attractive short-ranged force is essential to quantify these shifts correctly. In the slow regime, the calculated rates are substantially smaller than the experimental ones. This disagreement is probably related to surface charge heterogeneities.

Interaction Forces, Heteroaggregation, and Deposition Involving Charged Colloidal Particles

Force profiles as well as aggregation and deposition rates are studied for asymmetrically charged particles and surfaces in aqueous electrolytes theoretically. Interactions are calculated within the Derjaguin, Landau, Verwey, and Overbeek (DLVO) theory, whereby the electrostatic part is modeled at Poisson-Boltzmann (PB) level. Unequally charged surfaces are examined, from the symmetric system, where both surfaces are equally charged, to fully asymmetric systems, where the surfaces are oppositely charged. Charged-neutral systems, where one surface is charged and the other is neutral, emerge as an essential scenario. In this case, the choice of boundary conditions used for solving the PB equation is crucial, whereby constant charge and constant potential boundary conditions lead to either fully repulsive or fully attractive forces. Consequently, charge regulation has a major influence on particle aggregation and deposition rates too. In the charge-neutral case, substantial shifts in the critical coagulation concentration (CCC) are observed when the regulation properties are changed. In the presence of multivalent ions, these systems behave similarly to the symmetrically charged ones. The CCC decreases with the square of the valence in weakly charged systems, while unrealistically high charge densities are needed to recover the classical Schulze-Hardy limit, which predicts a sixth power dependence on valence.

Fabrication of water-repellent surfaces on galvanized steel

The design of durable superhydrophobic coatings for metal surfaces is a subject of interest and research. Galvanized steel is one of the most used metallic materials for components of automobiles, building structures and roofing. In spite of its wide number of applications, galvanized steel has been scarcely modified to reach superhydrophobicity. The main reason for this is that galvanized steel is essentially a zinc-coated steel surface and most of the strategies to prepare superhydrophobic coatings on metal substrates require partial removal of the surface material. For this reason, providing a non-aggressive strategy to create superhydrophobic galvanized steel (or other metal coated materials) is an important challenge. With this aim, we propose in this paper a methodology based on a two-step texturing process (sandblasting and “soft” acid-etching) followed by a fluoropolymer deposition as a non-invasive strategy to produce water repellent surfaces on this material. The roughness of the samples was analyzed by confocal microscopy and FE-SEM imaging, the surface chemical composition by EDX and the wettability properties by contact angle measurements. Our results show that both texturing methods are necessary to create hierarchically micro/nano-structured surfaces on galvanized steel. This structure induces superhydrophobic properties once the metal is subsequently Teflon-coated. Sandblasting introduces a micro-scale texture, while soft acid-etching incorporates nano-asperities.

Testing the performance of superhydrophobic aluminum surfaces

The analysis of wetting properties of superhydrophobic surfaces may be a difficult task due to the restless behavior of drops on this type of surfaces and the limitations of goniometry for high contact angles. A method to validate the performance of superhydrophobic surfaces, rather than standard goniometry, is required. In this work, we used bouncing drop dynamics as a useful tool to predict the water repellency of different superhydrophobic surfaces. From bouncing drop experiments conducted over a wide range of superhydrophobic surfaces, we found that those surfaces with a proper roughness degree and homogeneous chemical composition showed higher water-repellency. We also conducted a drop condensation study at saturating conditions aimed to determine whether there is direct correlation between water repellency and condensation delay. We found that the drop condensation process is strongly related to the surface topography, as well as the intrinsic wettability. The condensation is promoted on rough surfaces but it is delayed on intrinsically hydrophobic surfaces. However, the differences found in condensation delay between the superhydrophobic surfaces explored in this study cannot be justified by their chemical homogeneity nor their efficiency as water repellent surfaces, separately.

Forces between different latex particles in aqueous electrolyte solutions measured with the colloidal probe technique

In this article, a compilation of results on direct force measurements between colloidal particles in monovalent salts carried out with the colloidal probe technique based on Atomic Force Microscopy was presented. The interaction forces between similar and dissimilar particles was studied and it was concluded that, in general, these force profiles may be satisfactorily quantified by the DLVO theory down to distances of few nanometers. However, in the specific case where the charge of one of the involved particle is close to neutral, it was found that the surface potential of this particle may change its sign depending on the sign of charge of the opposite particle. In this respect, the assumption that the surface potential of a particle is a property only related to the particle surface features and the bulk properties is called into question. Microsc. Res. Tech. 80:144–152, 2017.