Feng Fu

Visual detection of melamine in milk products by label-free gold nanoparticles

A simple, rapid, field-portable colorimetric method for the detection of melamine based on melamine-induced color change of label-free gold nanoparticles (Au NPs) was developed in this study. Melamine can induced the aggregation of Au NPs and results in the color change from wine-red to purple, which provided a platform for rapid and field-portable colorimetric detection of melamine. The proposed method can be used to detect melamine in liquid milk and infant formula with a detection limit of 1.0 and 4.2ppm, respectively, within 30min by naked eyes observation without the aid of any advanced instrument and the need of any complex pretreatment, and detect as low as 0.15ppm of melamine in liquid milk and 2.5ppm of melamine in infant formula with UV-vis-spectroscopy. The proposed method is promising for on-site screening of melamine adulterant in milk products.

A G-quadruplex based label-free fluorescent biosensor for lead ion

Many Pb(2+) biosensors based on Pb(2+)-specific RNA-cleaving DNAzyme have been developed in the past years. However, many of them have limited practical use because of high cost (e.g., enzymes), complicated processing and the use of unstable molecules (e.g., RNA). In this study, a novel label-free fluorescent biosensor for Pb(2+) was proposed based on Pb(2+)-induced allosteric G-quadruplex (PS2.M). In the presence of K(+), N-methyl mesoporphyrin IX (NMM) could bind to K(+)-stabilized G-quadruplexes, giving rise to high fluorescence. On addition of Pb(2+), Pb(2+) competitively binded to K(+)-stabilized G-quadruplexes to form more compact DNA folds. The Pb(2+)-stabilized G-quadruplexes did not bind to NMM, which resulted in fluorescence decrease. This allowed us to utilize PS2.M for quantitative analysis of Pb(2+) using the NMM-G-quadruplex system by convenient mix-and-detect protocol. The fluorescence emission ratio (F(0)/F) showed a good linear response toward Pb(2+) over the range from 5.0 nM to 1.0 μM with a limit of detection of 1.0 nM. This proposed biosensor was simple and cost efficiency in design and in operation with high sensitivity and selectivity. We validated the practicality of this biosensor for the determination of Pb(2+) in lake water samples.

A signal-on electrochemiluminescence aptamer biosensor for the detection of ultratrace thrombin based on junction-probe.

A novel signal-on junction-probe electrogenerated chemiluminescence (ECL) aptamer biosensor has been developed for the detection of ultratrace thrombin based on a structure-switching ECL-quenching mechanism. The ECL aptamer biosensor comprises two main parts: an ECL substrate and an ECL intensity switch. The ECL substrate was made by modifying the complex of Au nanoparticle and ruthenium (II) tris-bipyridine (Ru(bpy)(3)(2+)-AuNPs) on the surface of gold electrode (GE), and the ECL intensity switch contains three probes designed according to the junction-probe strategy. The first probe is capture probe (Cp) which was functionalized with a thiol group at one end and covalently attached to Ru(bpy)(3)(2+)-AuNPs modified GE through S-Au bonding. The second probe is aptamer probe (Ap), which containing 15-base anti-thrombin DNA aptamer. The third one is ferrocene-labeled probe (Fp), which was functionalized with ferrocene tag at one end. We demonstrated that, in the absence of thrombin, Cp, Ap and Fp will hybridize to form a ternary Y junction structure and resulted in a quenching of ECL of Ru(bpy)(3)(2+). Whereas, in the presence of thrombin, the Ap prefers to form the G-quadruplex aptamer-thrombin complex and lead to an obvious recovery of ECL of Ru(bpy)(3)(2+), which provided a sensing platform for the detection of thrombin. Using this reusable sensing platform, a simple, rapid and selective signal-on ECL aptamer biosensor for the detection of thrombin with a detection limit of 8.0×10(-15) M has been developed. The success in the present biosensor served as a significant step towards the development of monitoring ultratrace thrombin in clinical detection.

Speciation analysis of mercury in natural water and fish samples by using capillary electrophoresis-inductively coupled plasma mass spectrometry

A environment-friendly microwave-assisted extraction used to extract trace mercury compounds from fish samples, and a ultra-sensitive method for the analysis of Hg(II), methylmercury (MeHg) and ethylmercury (EtHg) by using capillary electrophoresis-inductively coupled plasma mass spectrometry (CE-ICP-MS) were described in this study. The extraction method is environment-friendly, simple, effective, and can be used to extract trace mercury compounds in fish samples with a satisfied recovery within several minutes. The CE-ICP-MS analytical method has a detection limit as lower as 0.021-0.032 ng Hg/mL for MeHg, EtHg and Hg(II), and can be used to determined ultratrace MeHg, EtHg and Hg(II) in natural water and fish samples directly without any preconcentration. With the help of the above methods, we have successfully determined MeHg, EtHg and Hg(II) in dried fish (Tapertail anchovy) muscle and natural water within 25 min with a RSD (relative standard deviation, n=6) <5% and a recovery of 94-103%. Our results showed that dried muscle of T. anchovy contained only one species of mercury, MeHg, indicating that MeHg is easier to be accumulated by aquatic organisms.

Speciation analysis of arsenic in Mya arenaria Linnaeus and Shrimp with capillary electrophoresis-inductively coupled plasma mass spectrometry.

An improved sheath-flow interface used to couple capillary electrophoresis (CE) with inductively coupled plasma mass spectrometry (ICP-MS) and a microwave-assisted extraction used to extract each arsenic species in seafood were developed in this work. The improved sheath-flow interface completely avoids laminar flow in CE capillary caused by the suction from ICP-MS, makes electric supply more stable in CE, and transports analyte solution to ICP-MS easily and more efficiently. CE-ICP-MS coupled with our interface have two quantitative analysis modes: continuous sample-introduction mode and collective sample-introduction mode. The collective sample-introduction technique greatly reduced the dead volume of interface to approximately zero, obviously avoided the excessive dilution of analyte, and eventually led to a much lower detection limit and a much better electrophoretic resolution. This was demonstrated by the better symmetry and narrow peak widths (10-12s) and much lower detection limits (0.030-0.042 microg/L) of four species of arsenic determined with collective sample-introduction mode. With the help of this improved sheath-flow interface and the microwave-assisted extraction, we have successfully separated and determined four arsenic species, As(III), As(V), monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA) in dried Mya arenaria Linnaeus and Shrimp samples using CE-ICP-MS within 10 min with a relative standard deviation of 2-4% (peak areas, n=6) and a recovery of 96-105%.

A novel electrically magnetic-controllable electrochemical biosensor for the ultra sensitive and specific detection of attomolar level oral cancer-related microRNA.

Non-invasive early diagnosis of oral cancer is the most effective means to reduce mortality rate from this disease. In this paper, we described a novel magnetic-controllable electrochemical RNA biosensor for the ultra sensitive and specific detection of oral cancer-related microRNA (miRNA) based on a home-made electrically magnetic-controllable gold electrode. The electrically magnetic-controllable gold electrode combined the merits of heated electrode and magnetic electrode, has notable advantage such as that the strength and direction of the magnetic field and the temperature of the electrodes surface can be easily regulated. The advantage of electrically magnetic-controllable gold electrode, as well as the utilization of junction-probe strategy and magnetic beads (MBs)-based enzymatic catalysis amplification, make the biosensor has ultra-high sensitivity and discrimination ability even for the detection of similar miRNAs. It can be used to detect as low as 0.22 aM (2.2 × 10(-19)M) of oral cancer-related miRNA with a recovery of 93-108% and a RSD<6 (n=5). The high sensitivity and selectivity, as well as the easiness of fabrication, operational convenience, short analysis time, good stability and re-usability, make the biosensor a promising alternative for the early point-of-care diagnosis of oral cancer. The success of the biosensor also leads to a great potential in the development of biosensor for the early diagnosis of other diseases.

Speciation analysis of selenium in rice samples by using capillary electrophoresis-inductively coupled plasma mass spectrometry.

An enzyme-assisted extraction used to extract all species of selenium in rice sample and a sensitive analytical method for the determination of ultratrace Se(VI), Se(IV), SeCys(2) (selenocystine) and SeMet (selenomethionine) with capillary electrophoresis-inductively coupled plasma mass spectrometry were firstly described in this study. The extraction method is simple, effective and can be used to extract trace selenium compounds in rice with high extraction efficiency and no altering its species. The analytical method has a detection limit of 0.1-0.9 ng Se/mL, and can be used to determine trace Se(VI), Se(IV), SeCys(2) and SeMet in rice directly without any derivatization and pre-concentration. With the help of above methods, we have successfully determined Se(VI), Se(IV), SeCys(2) and SeMet in selenium-enriched rice within 18 min with a recovery of 90-103% and a RSD (relative standard deviation, n=6) of 3-7%. Our results indicated that selenium-enriched rice contained only one species of selenium, SeMet, and its concentration is in range of 0.136-0.143 μg Se/g dried weight. The proposed method providing a realistic approach for the nutritional and toxical evaluation of different selenium compounds in nutritional supplements.

Study on the simultaneous determination of seven benzoylurea pesticides in Oolong tea and their leaching characteristics during infusing process by HPLC–MS/MS

A method for the simultaneous determination of 7 benzoylurea pesticides (chlorfluazuron, diflubenzuron, fluazuron, flufenoxuron, hexaflumuron, teflubenzuron and triflumuron) in the manufactured Oolong tea leaves and its infusion was described. The method has a LOD of 0.03-1.00ng/mL, a recovery of 90.4-103% for made tea and 90.3-102% for tea-infused liquid, respectively. By using the proposed method, the leaching characteristics of above 7 pesticides during infusing process were investigated. The experimental results revealed that: (1) diflubenzuron can be most easily extracted out during infusing process, followed by triflumuron, teflubenzuron, hexaflumuron, chlorfluazuron, flufenoxuron and fluazuron. (2) The leaching of flufenoxuron and chlorfluazuron during infusing process seems to be controlled by only their solubility, whereas, the leaching of other 5 benzoylurea insecticides was primarily controlled by their partitioning coefficient between made tea and hot water. The results of this study are helpful for the accurate evaluation of the safety of Oolong tea.

A pH-responsive controlled release system using layered double hydroxide (LDH)-capped mesoporous silica nanoparticles

A pH-responsive controlled release system is proposed using acid-decomposable layered double hydroxides (LDHs) as inorganic nanovalves by virtue of the electrostatic adsorption of LDH nanosheets on the surface of mesoporous silica nanoparticles (MSNs). Guest molecules (Ru(bpy)3Cl2 in this case) are loaded and encapsulated in a neutral environment. The dissolution of the LDH coatings in an acidic environment triggers the release of the guest molecules from the MSNs.

An ultrasensitive electrochemical sensor for the mercuric ion via controlled assembly of SWCNTs

An ultrasensitive turn-on electrochemical sensor for the Hg(2+) ion was proposed based on the T-Hg(2+)-T coordination chemistry and the controlled assembly of SWCNTs on the MHA/SAM-modified gold electrode.