G. Biskos

The rise of low-cost sensing for managing air pollution in cities.

Ever growing populations in cities are associated with a major increase in road vehicles and air pollution. The overall high levels of urban air pollution have been shown to be of a significant risk to city dwellers. However, the impacts of very high but temporally and spatially restricted pollution, and thus exposure, are still poorly understood. Conventional approaches to air quality monitoring are based on networks of static and sparse measurement stations. However, these are prohibitively expensive to capture tempo-spatial heterogeneity and identify pollution hotspots, which is required for the development of robust real-time strategies for exposure control. Current progress in developing low-cost micro-scale sensing technology is radically changing the conventional approach to allow real-time information in a capillary form. But the question remains whether there is value in the less accurate data they generate. This article illustrates the drivers behind current rises in the use of low-cost sensors for air pollution management in cities, while addressing the major challenges for their effective implementation.

Phase Transitions of Single Salt Particles Studied Using a Transmission Electron Microscope with an Environmental Cell

The hygroscopic behavior of 0.1 to 4 μ m NaBr, CsCl, NaCl, (NH4)2SO4, and KBr particles were monitored using a transmission electron microscope (TEM) equipped with an environmental cell into which gases can be introduced. This instrument, commonly called an environmental transmission electron microscope or ETEM, allowed us to observe phase transitions and behavior of small particles at relative humidities between 0 and 100%. We used deliquescence relative humidity and efflorescence relative humidity values from the literature for each salt to calibrate the relative humidity in the environmental cell. Using our methodology, we reliably and accurately measured the phase transitions and hygroscopic behavior of inorganic particles with the ETEM.

Toward industrial scale synthesis of ultrapure singlet nanoparticles with controllable sizes in a continuous gas-phase process

Continuous gas-phase synthesis of nanoparticles is associated with rapid agglomeration, which can be a limiting factor for numerous applications. In this report, we challenge this paradigm by providing experimental evidence to support that gas-phase methods can be used to produce ultrapure non-agglomerated “singlet” nanoparticles having tunable sizes at room temperature. By controlling the temperature in the particle growth zone to guarantee complete coalescence of colliding entities, the size of singlets in principle can be regulated from that of single atoms to any desired value. We assess our results in the context of a simple analytical model to explore the dependence of singlet size on the operating conditions. Agreement of the model with experimental measurements shows that these methods can be effectively used for producing singlets that can be processed further by many alternative approaches. Combined with the capabilities of up-scaling and unlimited mixing that spark ablation enables, this study provides an easy-to-use concept for producing the key building blocks for low-cost industrial-scale nanofabrication of advanced materials.

Engineered nanomaterials: knowledge gaps in fate, exposure, toxicity, and future directions

The aim of this study is to identify current knowledge gaps in fate, exposure, and toxicity of engineered nanomaterials (ENMs), highlight research gaps, and suggest future research directions. Humans and other living organisms are exposed to ENMs during production or use of products containing them. To assess the hazards of ENMs, it is important to assess their physiochemical properties and try to relate them to any observed hazard. However, the full determination of these relationships is currently limited by the lack of empirical data. Moreover, most toxicity studies do not use realistic environmental exposure conditions for determining dose-response parameters, affecting the accurate estimation of health risks associated with the exposure to ENMs. Regulatory aspects of nanotechnology are still developing and are currently the subject of much debate. Synthesis of available studies suggests a number of open questions. These include (i) developing a combination of different analytical methods for determining ENM concentration, size, shape, surface properties, and morphology in different environmental media, (ii) conducting toxicity studies using environmentally relevant exposure conditions and obtaining data relevant to developing quantitative nanostructure-toxicity relationships (QNTR), and (iii) developing guidelines for regulating exposure of ENMs in the environment.

Plasmonic nanoparticle-semiconductor composites for efficient solar water splitting

Photoelectrochemical (PEC) water splitting is a promising technology that uses light absorbing semiconductors to convert solar energy directly into a chemical fuel (i.e., hydrogen). PEC water splitting has the potential to become a key technology in achieving a sustainable society, if high solar to fuel energy conversion efficiencies are obtained with earth abundant materials. This review article discusses recent developments and discoveries in the mechanisms by which the localized surface plasmon resonance (LSPR) in metallic nanoparticles can increase or complement a neighbouring semiconductor in light absorption for catalytic water splitting applications. These mechanisms can mitigate the intrinsic optical limitations of semiconductors (e.g., metal oxides) for efficient solar water splitting. We identify four types of enhancement mechanisms in the recent literature: (i) light scattering, (ii) light concentration, (iii) hot electron injection (HEI), and (iv) plasmon-induced resonance energy transfer (PIRET). (i) Light scattering and (ii) light concentration are light trapping mechanisms that can increase the absorption of light with energies above the semiconductor optical band-edge. These two mechanisms are ideal to enhance the absorption of promising semiconductors with narrow bandgap energies that suffer from limited absorption coefficients and bulk charge recombination. On the other hand, (iii) HEI and the recently discovered (iv) PIRET are mechanisms that can enhance the absorption also below the semiconductor optical band-edge. Therefore, HEI and PIRET have the potential to extend the light utilization to visible and near-infrared wavelengths of semiconductors with excellent electrochemical properties, but with large bandgap energies. New techniques and theories that have been developed to elucidate the above mentioned plasmonic mechanisms are presented and discussed for their application in metal oxide photoelectrodes. Finally, other plasmonic and non-plasmonic effects that do not increase the device absorption, but affect the electrochemical properties of the semiconductor (e.g., charge carrier transport) are also discussed, since a complete understanding of these phenomena is fundamental for the design of an efficient plasmonic NP-semiconductor water splitting device.

Climatology and trends of aerosol optical depth over the Mediterranean basin during the last 12 years (2002–2014) based on Collection 006 MODIS-Aqua data

The Mediterranean basin is a region of particular interest for studying atmospheric aerosols due to the large variety of air masses it receives, and its sensitivity to climate change. In this study we use the newest collection (C006) of aerosol optical depth from MODIS-Aqua, from which we also derived the fine-mode fraction and Ångström exponent over the last 12years (i.e., from 2002 to 2014), providing the longest analyzed dataset for this region. The long-term regional optical depth average is 0.20±0.05, with the indicated uncertainty reflecting the inter-annual variability. Overall, the aerosol optical depth exhibits a south-to-north decreasing gradient and an average decreasing trend of 0.0030 per year (19% total decrease over the study period). The correlation between the reported AOD observations with measurements from the ground AERONET stations is high (R=0.76-0.80 depending on the wavelength), with the MODIS-Aqua data being slightly overestimated. Both fine-fraction and Ångström exponent data highlight the dominance of anthropogenic aerosols over the northern, and of desert aerosols over the southern part of the region. Clear intrusions of desert dust over the Eastern Mediterranean are observed principally in spring, and in some cases in winter. Dust intrusions dominate the Western Mediterranean in the summer (and sometimes in autumn), whereas anthropogenic aerosols dominate the sub-region of the Black Sea in all seasons but especially during summer. Fine-mode optical depth is found to decrease over almost all areas of the study region during the 12-year period, marking the decreasing contribution of anthropogenic particulate matter emissions over the study area. Coarse-mode aerosol load also exhibits an overall decreasing trend. However, its decrease is smaller than that of fine aerosols and not as uniformly distributed, underlining that the overall decrease in the region arises mainly from reduced anthropogenic emissions.

Real-time sensors for indoor air monitoring and challenges ahead in deploying them to urban buildings.

Household air pollution is ranked the 9(th) largest Global Burden of Disease risk (Forouzanfar et al., The Lancet 2015). People, particularly urban dwellers, typically spend over 90% of their daily time indoors, where levels of air pollution often surpass those of outdoor environments. Indoor air quality (IAQ) standards and approaches for assessment and control of indoor air require measurements of pollutant concentrations and thermal comfort using conventional instruments. However, the outcomes of such measurements are usually averages over long integrated time periods, which become available after the exposure has already occurred. Moreover, conventional monitoring is generally incapable of addressing temporal and spatial heterogeneity of indoor air pollution, or providing information on peak exposures that occur when specific indoor sources are in operation. This article provides a review of new air pollution sensing methods to determine IAQ and discusses how real-time sensing could bring a paradigm shift in controlling the concentration of key air pollutants in billions of urban houses worldwide. We also show that besides the opportunities, challenges still remain in terms of maturing technologies, or data mining and their interpretation. Moreover, we discuss further research and essential development needed to close gaps between what is available today and needed tomorrow. In particular, we demonstrate that awareness of IAQ risks and availability of appropriate regulation are lagging behind the technologies.

Dewatering of wastewater sludge through a solar still

Wastewater sludge was passed through a laboratory solar still in order to determine the dewatering process. A number of parameters describing the distillate and the sludge were measured at the end of each day in order to determine the process behavior under conditions of relatively high solar radiation and temperature levels. It was realized that dewatering is accelerated and further analysis is needed in order to determine optimum conditions and design parameters for a demonstration plant that will operate towards reducing the sludge volume.

Indirect evidence of the composition of nucleation mode atmospheric particles in the high Arctic

Previous long-term observations have shown that nanoparticle formation events are common in the summer-time high Arctic and linked to local photochemical activity. However, current knowledge is limited with respect to the chemical precursors of resulting nanoparticles and the compounds involved in their subsequent growth. Here we report case-study measurements during new particle formation (NPF) events of the particle size distribution (diameter > 7 nm) and for the first time the volatility of monodisperse particles having diameter ≤40 nm, providing indirect information about their composition. Volatility measurements provide indirect evidence that a predominant fraction of the 12 nm particle population is ammoniated sulfates in the summertime high Arctic. Our observations further suggest that the majority of the sub-40 nm particle population during NPF events does not exist in the form of sulfuric acid but rather as partly or fully neutralized ammoniated sulfates.

A Cost-Effective Electrostatic Precipitator for Aerosol Nanoparticle Segregation

Copyright 2015 American Association for Aerosol Research