Gary D. Noojin

Influence of pulse duration on mechanical effects after laser-induced breakdown in water

The influence of the pulse duration on the mechanical effects following laser-induced breakdown in water was studied at pulse durations between 100 fs and 100 ns. Breakdown was generated by focusing laser pulses into a cuvette containing distilled water. The pulse energy corresponded to 6-times breakdown threshold energy. Plasma formation and shock wave emission were studied photographically. The plasma photographs show a strong influence of self-focusing on the plasma geometry for femtosecond pulses. Streak photographic recording of the shock propagation in the immediate vicinity of the breakdown region allowed the measurement of the near-field shock pressure. At the plasma rim, shock pressures between 3 and 9 GPa were observed for most pulse durations. The shock pressure rapidly decays proportionally to r−(2⋯3) with increasing distance r from the optical axis. At a 6 mm distance of the shock pressure has dropped to (8.5±0.6) MPa for 76 ns and to <0.1 MPa for femtosecond pulses. The radius of the cavitat...

Shielding properties of laser-induced breakdown in water for pulse durations from 5 ns to 125 fs.

The shielding effectiveness of laser-induced breakdown from focused, visible laser pulses from 5 ns to 125 fs is determined from measurements of transmission of energy through the focal volume. The shielding efficiency decreases as a function of pulse duration from 5 ns to 300 fs and increases from 300 fs to 125 fs. The results are compared with past studies at similar pulse durations. The results of the measurements support laser-induced breakdown models and may lead to an optimization of laser-induced breakdown in ophthalmic surgery by reduction of collateral effects.

Spectrally resolved white-light interferometry for measurement of ocular dispersion

Spectrally resolved white-light interferometry was used to measure the wavelength dependence of refractive index (i.e., dispersion) for various ocular components. Verification of the techniques efficacy was substantiated by accurate measurement of the dispersive properties of water and fused silica, which have both been well-characterized in the past by single-wavelength measurement of the refractive index. The dispersion of bovine and rabbit aqueous and vitreous humors was measured from 400 to 1100 nm. In addition, the dispersion was measured from 400 to 700 nm for aqueous and vitreous humors extracted from goat and rhesus monkey eyes. An unsuccessful attempt was also made to use the technique for dispersion measurement of bovine cornea and lens. The principles of white-light interferometry, including image analysis, measurement accuracy, and limitations of the technique, are discussed. In addition, alternate techniques and previous measurements of ocular dispersion are reviewed.

A first-order model for computation of laser-induced breakdown thresholds in ocular and aqueous media. II. Comparison to experiment

For pt. I see ibid., vol.31, no.12, p.2241-9 (1995). An analytic, first-order model has been developed to calculate irradiance thresholds for laser-induced breakdown (LIB) in condensed media, including ocular and aqueous media. A complete derivation and description of the model was given in a previous paper (Part I). The model has been incorporated into a computer code and code results have been compared to experimentally measured irradiance thresholds for breakdown of ocular media, saline, and water by nanosecond, picosecond, and femtosecond laser pulses in the visible and near-infrared. The comparison included both breakdown data from the literature and from our own measurements. Theoretical values match experiment to within a factor of 2 or better, over a range of pulsewidths spanning five orders of magnitude.

Argon Laser Retinal Lesions Evaluated In Vivo by Optical Coherence Tomography

PURPOSE To assess the in vivo evolution of argon laser retinal lesions by correlating the cross-sectional structure from sequential optical coherence tomography with histopathologic sectioning. METHODS Argon laser lesions were created in the retinas of Macaca mulatta and evaluated by cross-section optical coherence tomography, which was compared at selected time points with corresponding histopathology. RESULTS Argon laser lesions induced an optical coherence tomography pattern of early outer retinal relative high reflectivity with subsequent surrounding relative low reflectivity that correlated well with histopathologic findings. The in vivo optical coherence tomography images of macular laser lesions clearly demonstrated differences in pathologic response by retinal layer over time. CONCLUSION The novel sequential imaging of rapidly evolving macular lesions with optical coherence tomography provides new insight into the patterns of acute tissue response by cross-sectional layer. This sequential imaging technique will aid in our understanding of the rapid evolution of retinal pathology and response to treatment in the research and clinical setting.

Stimulated Raman photoacoustic imaging

Achieving label-free, molecular-specific imaging with high spatial resolution in deep tissue is often considered the grand challenge of optical imaging. To accomplish this goal, significant optical scattering in tissues has to be overcome while achieving molecular specificity without resorting to extrinsic labeling. We demonstrate the feasibility of developing such an optical imaging modality by combining the molecularly specific stimulated Raman excitation with the photoacoustic detection. By employing two ultrashort excitation laser pulses, separated in frequency by the vibrational frequency of a targeted molecule, only the specific vibrational level of the target molecules in the illuminated tissue volume is excited. This targeted optical absorption generates ultrasonic waves (referred to as stimulated Raman photoacoustic waves) which are detected using a traditional ultrasonic transducer to form an image following the design of the established photoacoustic microscopy.

Bright emission from a random Raman laser

Random lasers are a developing class of light sources that utilize a highly disordered gain medium as opposed to a conventional optical cavity. Although traditional random lasers often have a relatively broad emission spectrum, a random laser that utilizes vibration transitions via Raman scattering allows for an extremely narrow bandwidth, on the order of 10 cm−1. Here we demonstrate the first experimental evidence of lasing via a Raman interaction in a bulk three-dimensional random medium, with conversion efficiencies on the order of a few percent. Furthermore, Monte Carlo simulations are used to study the complex spatial and temporal dynamics of nonlinear processes in turbid media. In addition to providing a large signal, characteristic of the Raman medium, the random Raman laser offers us an entirely new tool for studying the dynamics of gain in a turbid medium.

Retinal damage and laser-induced breakdown produced by ultrashort-pulse lasers

Abstract• Background: In vivo retinal injury studies using ultrashort-pulse lasers at visible wavelengths for both rabbit and primate eyes have shown that the degree of injury to the retina is not proportional to the pulse energy, especially at suprathreshold levels. In this paper we present results of calculations and measurements for laser-induced breakdown (LIB), bubble generation, and self-focusing within the eye. • Methods: We recorded on video and measured the first in vivo LIB and bubble generation thresholds within the vitreous in rabbit and primate eyes, using external optics and femtosecond pulses. These thresholds were then compared with calculations from our LIB model, and calculations were made for self-focusing effects within the vitreous for the high peak power pulses. • Results: Results of our nonlinear modeling and calculations for self-focusing and LIB within the eye were compared with experimental results. The LIB ED50 bubble threshold for the monkey eye was measured and found to be 0.56 μJ at 120 fs, compared with the minimum visible lesion (MVL) threshold of 0.43 μJ at 90 fs. Self-focusing effects were found to be possible for pulsewidths below 1 ps and are probably a contributing factor in femtosecond-pulse LIB in the eye. • Conclusions: Based on our measurements for the MVL thresholds and LIB bubble generation thresholds in the monkey eye, we conclude that in the femtosecond pulsewidth regime for visible laser pulses, LIB and self-focusing are contributing factors in the lesion thresholds measured. Our results may also explain why it is so difficult to produce hemorrhagic lesions in either the rabbit or primate eye with visible 100-fs laser pulses even at 100 μJ of energy.

Stimulated Raman scattering using a single femtosecond oscillator with flexibility for imaging and spectral applications.

Stimulated Raman scattering (SRS) is a powerful tool for obtaining background-free chemical information about a material without extrinsic labeling. Background-free spectra are particularly important in the fingerprint region (~800 and 1800 cm(-1)) where peaks are narrow, closely-spaced, and may be in abundance for a particular chemical. We demonstrate a method for obtaining SRS spectra using a single femtosecond laser oscillator. A photonic crystal fiber is used to create a supercontinuum to provide a range of Stokes shifts from ~300 to 3400 cm(-1). This SRS approach provides for collection capabilities that are easily modified between obtaining broadband spectra and single-frequency images.

Single-shot stand-off chemical identification of powders using random Raman lasing.

Significance The long-range stand-off chemical identification of materials has been a high profile goal of science in recent years. In this article, we demonstrate the stand-off identification of chemical compounds from kilometer-scale distances in a single laser pulse by detecting the emission from random Raman lasing processes in the target. This technique opens up the door to rapid identification of potentially hazardous chemicals from a safe distance. The task of identifying explosives, hazardous chemicals, and biological materials from a safe distance is the subject we consider. Much of the prior work on stand-off spectroscopy using light has been devoted to generating a backward-propagating beam of light that can be used drive further spectroscopic processes. The discovery of random lasing and, more recently, random Raman lasing provide a mechanism for remotely generating copious amounts of chemically specific Raman scattered light. The bright nature of random Raman lasing renders directionality unnecessary, allowing for the detection and identification of chemicals from large distances in real time. In this article, the single-shot remote identification of chemicals at kilometer-scale distances is experimentally demonstrated using random Raman lasing.