George Rowbotham

Rate of strike-slip motion on the Amanos Fault (Karasu Valley, southern Turkey) constrained by K–Ar dating and geochemical analysis of Quaternary basalts

The left-lateral Amanos Fault follows a ∼200-km-long and up to ∼2-km-high escarpment that bounds the eastern margin of the Amanos mountain range and the western margin of the Karasu Valley in southern Turkey, just east of the northeastern corner of the Mediterranean Sea. Regional kinematic models have reached diverse conclusions as to the role of this fault in accommodating relative motion between either the African and Arabian, Turkish and African, or Turkish and Arabian plates. Local studies have tried to estimate its slip rate by K–Ar dating Quaternary basalts that erupted within the Amanos Mountains, flowed across it into the Karasu Valley, and have since become offset. However, these studies have yielded a wide range of results, ranging from ∼0.3 to ∼15 mm a−1, which do not allow the overall role and significance of this fault in accommodating crustal deformation to be determined. We have used the Cassignol K–Ar method to date nine Quaternary basalt samples from the vicinity of the southern part of the Amanos Fault. These basalts exhibit a diverse chemistry, which we interpret as a consequence varying degrees of partial melting of their source combined with variable crustal contamination. This dating allows us to constrain the Quaternary slip rate on the Amanos fault to ∼1.0 to ∼1.6 mm a−1. The dramatic discrepancies between past estimates of this slip rate are partly due to technical difficulties in K–Ar dating of young basalts by isotope dilution. In addition, previous studies at the key locality of Hacilar have unwittingly dated different, chemically distinct, flow units of different ages that are juxtaposed. This low slip rate indicates that, at present, the Amanos Fault takes up a small proportion of the relative motion between the African and Arabian plates, which is transferred southward to the Dead Sea Fault Zone. It also provides strong evidence against the long-standing view that its slip continues offshore to the southwest along a hypothetical left-lateral fault zone located south of Cyprus.

Constraints on the timing and regional conditions at the start of the present phase of crustal extension in western Turkey, from observations in and around the Denizli region

The chronology of extension of the continental crust in western Turkey has been the subject of major controversies. We suggest that these difficulties have arisen in part because of past misuse of dating evidence; and in part because the assumption often made, that deposition of major terrestrial sedimentary sequences implies crustal extension to create the necessary accommodation space, is incorrect. We report evidence that the present phase of extension began in the Denizli region at ~ 7 Ma, around the start of the Messinian stage of the Late Miocene. This timing matches the estimated start of right-lateral slip on the North Anatolian Fault Zone, and corresponds to a substantial increase in the dimensions of the Aegean extensional province to roughly its present size: beforehand, between ~ 12 Ma and ~ 7 Ma, extension seems to have only occurred in the central part of this modern province. In some localities, terrestrial sedimentation that began before this start of extension continued into this extensional phase, both within and outside normal fault zones. However, in other localities within the hanging-walls of normal faults, the start of extension marked the end of sedimentation. Relationships between sedimentation and crustal extension in this region are thus not straightforward, and a simple correlation should therefore not be assumed in structural interpretations. During the time-scale of this phase of extension, the Denizli region has also experienced major vertical crustal motions that are unrelated to this extension. The northern part of this region, in the relatively arid interior of western Turkey, has uplifted by ~ 400 m since the Middle Pliocene, whereas its southern part, closer to the Mediterranean Sea and with a much wetter climate, has uplifted by ~ 1,200 m since the Early Miocene, by up to ~ 900 m since the Middle Pliocene, and by an estimated ~ 300 m since the Early Pleistocene. This regional uplift, superimposed on the local effects of active normal faulting, is interpreted as a consequence of lateral variations in rates of erosion. A reliable chronology for this phase of extension in western Turkey, in relation to changes in the geometry of motions of adjoining plates and Late Cenozoic environmental change, is now in place.

Kinematics of the Amanos Fault, southern Turkey, from Ar/Ar dating of offset Pleistocene basalt flows: transpression between the African and Arabian plates

Abstract We report four new Ar/Ar dates and 18 new geochemical analyses of Pleistocene basalts from the Karasu Valley of southern Turkey. These rocks have become offset left-laterally by slip on the N20°E-striking Amanos Fault. The geochemical analyses help to correlate some of the less-obvious offset fragments of basalt flows, and thus to measure amounts of slip; the dates enable slip rates to be calculated. On the basis of four individual slip-rate determinations, obtained in this manner, we estimate a weighted mean slip rate for this fault of 2.89±0.05mm/a (±2σ). We have also obtained a slip rate of 2.68±0.54mm/a (±2σ) for the subparallel East Hatay Fault farther east. Summing these values gives 5.57±0.54mm/a (±2σ) as the overall left-lateral slip rate across the Dead Sea fault zone (DSFZ) in the Karasu Valley. These slip-rate estimates and other evidence from farther south on the DSFZ are consistent with a preferred Euler vector for the relative rotation of the Arabian and African plates of 0.434±0.012° Ma−1 about 31.1°N, 26.7°E. The Amanos Fault is misaligned to the tangential direction to this pole by 52° in the transpressive sense. Its geometry thus requires significant fault-normal distributed crustal shortening, taken up by crustal thickening and folding, in the adjacent Amanos Mountains. The vertical component of slip on the Amanos Fault is estimated as c. 0.15mm/a. This minor component contributes to the uplift of the Amanos Mountains, which reaches rates of c. 0.2–0.4mm/a. These slip rate estimates are considered representative of time since. 3.73±0.05Ma, when the modern geometry of strike-slip faulting developed in this region; an estimated 11km of slip on the Amanos Fault and c. 10km of slip on the East Hatay Fault have occurred since then. It is inferred that both these faults came into being, and the associated deformation in the Amanos Mountains began, at that time. Prior to that, the northern part of the Africa–Arabia plate boundary was located further east.