Göran Frank

A closure study of sub-micrometer aerosol particle hygroscopic behaviour

Abstract The hygroscopic properties of sub-micrometer aerosol particles were studied in connection with a ground-based cloud experiment at Great Dun Fell, in northern England in 1995. Hygroscopic diameter growth factors were measured with a Tandem Differential Mobility Analyser (TDMA) for dry particle diameters between 35 and 265 nm at one of the sites upwind of the orographic cloud. An external mixture consisting of three groups of particles, each with different hygroscopic properties, was observed. These particle groups were denoted less-hygroscopic, more-hygroscopic and sea spray particles and had average diameter growth factors of 1.11–1.15, 1.38–1.69 and 2.08–2.21 respectively when taken from a dry state to a relative humidity of 90%. Average growth factors increased with dry particle size. A bimodal hygroscopic behaviour was observed for 74–87% of the cases depending on particle size. Parallel measurements of dry sub-micrometer particle number size distributions were performed with a Differential Mobility Particle Sizer (DMPS). The inorganic ion aerosol composition was determined by means of ion chromatography analysis of samples collected with Berner-type low pressure cascade impactors at ambient conditions. The number of ions collected on each impactor stage was predicted from the size distribution and hygroscopic growth data by means of a model of hygroscopic behaviour assuming that only the inorganic substances interacted with the ambient water vapour. The predicted ion number concentration was compared with the actual number of all positive and negative ions collected on the various impactor stages. For the impactor stage which collected particles with aerodynamic diameters between 0.17–0.53 μm at ambient relative humidity, and for which all pertinent data was available for the hygroscopic closure study, the predicted ion concentrations agreed with the measured values within the combined measurement and model uncertainties for all cases but one. For this impactor sampling occasion, the predicted ion concentration was significantly higher than the measured. The air mass in which this sample was taken had undergone extensive photochemical activity which had probably produced hygroscopically active material other than inorganic ions, such as organic oxygenated substances.

Hygroscopic properties of aerosol particles in the north-eastern Atlantic during ACE-2

Measurements of the hygroscopic properties of sub-micrometer atmospheric aerosol particles were performed with hygroscopic tandem differential mobility analysers (H-TDMA) at 5 sites in the subtropical north-eastern Atlantic during the second Aerosol Characterization Experiment (ACE-2) from 16 June to 25 July 1997. Four of the sites were in the marine boundary layer and one was, at least occasionally, in the lower free troposphere. The hygroscopic diameter growth factors of individual aerosol particles in the dry particle diameter range 10−440 nm were generally measured for changes in relative humidity (RH) from <10% to 90%. In the marine boundary layer, growth factors at 90% RH were dependent on location, air mass type and particle size. The data was dominated by a unimodal growth distribution of more-hygroscopic particles, although a bimodal growth distribution including less-hygroscopic particles was observed at times, most often in the more polluted air masses. In clean marine air masses the more-hygroscopic growth factors ranged from about 1.6 to 1.8 with a consistent increase in growth factor with increasing particle size. There was also a tendency toward higher growth factors as sodium to sulphate molar ratio increased with increasing sea-salt contribution at higher wind speeds. During outbreaks of European pollution in the ACE-2 region, the growth factors of the largest particles were reduced, but only slightly. Growth factors at all sizes in both clean and polluted air masses were markedly lower at the Sagres, Portugal site due to more proximate continental influences. The frequency of occurrence of less-hygroscopic particles with a growth factor of ca. 1.15 was greatest during polluted conditions at Sagres. The free tropospheric 50 nm particles were predominately less-hygroscopic, with an intermediate growth factor of 1.4, but more-hygroscopic particles with growth factors of about 1.6 were also frequent. While these particles probably originate from within the marine boundary layer, the less-hygroscopic particles are probably more characteristic of lower free tropospheric air masses. For those occasions when measurements were made at 90% and an intermediate 60% or 70% RH, the growth factor G(RH) of the more-hygroscopic particles could be modelled empirically by a power law expression. For the ubiquitous more-hygroscopic particles, the expressions G(RH)=(1-RH/100)-0.210 for 50 nm Aitken mode particles and G(RH)=(1-RH/100)-0.233 for 166 nm accumulation mode particles are recommended for clean marine air masses in the north-eastern Atlantic within the range 0

Enhanced organic mass fraction and decreased hygroscopicity of cloud condensation nuclei (CCN) during new particle formation events

In a forested near-urban location in central Germany, the CCN efficiency of particles smaller than 100 nm decreases significantly during periods of new particle formation. This results in an increase of average activation diameters, ranging from 5 to 8% at supersaturations of 0.33% and 0.74%, respectively. At the same time, the organic mass fraction in the sub-100-nm size range increases from approximately 2/3 to 3/4. This provides evidence that secondary organic aerosol (SOA) components are involved in the growth of new particles to larger sizes, and that the reduced CCN efficiency of small particles is caused by the low hygroscopicity of the condensing material. The observed dependence of particle hygroscopicity (k) on chemical composition can be parameterized as a function of organic and inorganic mass fractions (forg, finorg) determined by aerosol mass spectrometry: k = korg forg + kinorg finorg. The obtained value of korg ~ 0.1 is characteristic for SOA, and kinorg ~ 0.7 is consistent with the observed mix of ammonium, sulfate and nitrate ions. (Less)

Cloud‐nucleating properties of the Amazonian biomass burning aerosol: Cloud condensation nuclei measurements and modeling

The cloud-nucleating properties of the atmospheric aerosol were studied in an area under strong influence of vegetation burning. The measurements were part of Large-Scale Biosphere Atmosphere Experiment in Amazonia-Smoke Aerosols, Clouds, Rainfall and Climate (LBA-SMOCC) and were carried out at a ground site located in the state of Rondonia in southwestern Amazonia, Brazil, September to November 2002, covering the dry season, a transition period, and the onset of the wet season. The concentrations of cloud condensation nuclei (CCN) were measured with a static thermal gradient CCN counter for supersaturations ranging between 0.23 and 1.12%. As a closure test, the CCN concentrations were predicted with a time resolution of 10 min from measurements of the dry particle number size distribution (3-850 nm, Differential Mobility Analyzer (DMPS)) and hygroscopic growth at 90% relative humidity (Hygroscopic Tandem Differential Mobility Analyzer (H-TDMA)). No chemical information was needed. The predicted and measured CCN concentrations were highly correlated (r(2)=0.97-0.99), and the predictions were only slightly lower than those measured, typically by 15-20%. Parameterizations of the predicted CCN concentrations are given for each of the three meteorological periods. These are based on averages taken during the afternoon hours when the measurements at ground level were representative for the aerosol entering the base of convective clouds. Furthermore, a more detailed parameterization including the mixing state of the aerosol is given, where the hygroscopic properties are expressed as the number of soluble ions or nondissociating molecules per unit volume dry particle. (Less)

Soluble Mass, Hygroscopic Growth, and Droplet Activation of Coated Soot Particles during LACIS Experiment in November (LExNo)

The LACIS Experiment in November (LExNo) campaign was conducted in November 2005 at the Atmospheric Composition Change the European Network of Excellence (ACCENT) site Leipzig Aerosol Cloud Interaction Simulator (LACIS). The goal of LExNo was to provide deeper insight into the activation properties of coated soot particles imitating aged combustion aerosol particles. The aerosols were prepared by starting with spark-generated soot particles. In some experiments the soot particles were compacted by exposure to propanol vapor; in others this step was bypassed. The soot was thermally coated with ammonium sulfate, levoglucosan, or a mixture of both ammonium sulfate and levoglucosan. The synthesized particles were investigated using aerosol mass spectrometry, a Hygroscopicity Tandem differential mobility analyzer, two Wyoming static diffusion cloud condensation nuclei (CCN) instruments, a Droplet Measurement Technologies continuous flow CCN instrument, and LACIS. A close correlation between the hygroscopic growth factor at 98% relative humidity and the critical supersaturation of CCN activation was observed. Closure between hygroscopic growth, CCN activation, and chemical composition of the investigated particles was achieved with two different single-parameter Kohler model approaches and with a third approach, a standard Kohler model using as input parameter the soluble mass as determined by aerosol mass spectrometry. (Less)

The great dun fell cloud experiment 1993: An overview

The 1993 Ground-based Cloud Experiment on Great Dun Fell used a wide range of measurements of trace gases, aerosol particles and cloud droplets at five sites to study their sources and sinks especially those in cloud. These measurements have been interpreted using a variety of models. The conclusions add to our knowledge of air pollution, acidification of the atmosphere and the ground, eutrophication and climate change. The experiment is designed to use the hill cap cloud as a flow-through reactor, and was conducted in varying levels of pollution typical of much of the rural temperate continental northern hemisphere in spring-time.

Droplet nucleation and growth in orographic clouds in relation to the aerosol population

Abstract The formation and development of orographic clouds was studied in a field experiment comprising several measurement sites at a mountain ridge. The influence of the aerosol population present on the cloud microstructure was studied in relation to the dynamics in the cloud formation. Droplet nucleation scavenging was investigated by the introduction of a non-dimensional particle diameter related to the process, and it was found that the scavenging rose rapidly in a relatively narrow particle size interval. The size dependency of the scavenging could partly be explained by external mixture of the aerosol. The large particles in the cloud interstitial aerosol was found to be of a chemical nature which allows for only a very weak uptake of water, implying that the chemical composition of these particles rather than entrainment of dry air prevented the droplet nucleation. The aerosol particle number concentration was found to strongly influence the cloud microstructure. Droplet number concentrations up to approximately 2000 cm −3 were observed together with a substantially reduced effective droplet diameter. The observed effect of elevated particle number concentrations in orographic clouds was generalised to the climatologically more important stratiform clouds by the use of a cloud model. It was found that the microstructure of stratiform clouds was strongly dependent on the aerosol population present as well on the dynamics in the cloud formation.

The Great Dun Fell Experiment 1995: an overview

Abstract During March and April of 1995 a major international field project was conducted at the UMIST field station site on Great Dun Fell in Cumbria, Northern England. The hill cap cloud which frequently envelopes this site was used as a natural flow through reactor to examine the sensitivity of the cloud microphysics to the aerosol entering the cloud and also to investigate the effects of the cloud in changing the aerosol size distribution, chemical composition and associated optical properties. To investigate these processes, detailed measurements of the cloud water chemistry (including the chemistry of sulphur compounds, organic and inorganic oxidised nitrogen and ammonia), cloud microphysics and properties of the aerosol and trace gas concentrations upwind and downwind of the cap cloud were undertaken. It was found that the cloud droplet number was generally strongly correlated to aerosol number concentration, with up to 2000 activated droplets cm−3 being observed in the most polluted conditions. In such conditions it was inferred that hygroscopic organic compounds were important in the activation process. Often, the size distribution of the aerosol was substantially modified by the cloud processing, largely due to the aqueous phase oxidation of S(IV) to sulphate by hydrogen peroxide, but also through the uptake and fixing of gas phase nitric acid as nitrate, increasing the calculated optical scattering of the aerosol substantially (by up to 24%). New particle formation was also observed in the ultrafine aerosol mode (at about 5 nm) downwind of the cap cloud, particularly in conditions of low total aerosol surface area and in the presence of ammonia and HCl gases. This was seen to occur at night as well as during the day via a mechanism which is not yet understood. The implications of these results for parameterising aerosol growth in Global Climate Models are explored.

Experimental determination of the connection between cloud droplet size and its dry residue size

The droplet activation process and droplet growth was studied during early stages of the formation of orographically-induced clouds. The experimental results were compared with the results obtained with a closed parcel, adiabatic cloud model. Good agreement was in most cases found between model and measurements with respect to cloud droplet number concentration, cloud droplet solute concentration and particle sizes scavenged due to cloud droplet nucleation. The experimental results were mainly obtained with a new instrument, the droplet aerosol analyser (DAA), which allows the determination of ambient sizes of cloud droplets and interstitial aerosol particles directly connected with the size of its dry residue in a two-parameter data acquisition. The resulting three-dimensional data set (ambient size, dry size, number concentration) was utilised to determine several cloud/aerosol properties, whereof some unique.

Examination of laboratory-generated coated soot particles: An overview of the LACIS Experiment in November (LExNo) campaign

In the suite of laboratory measurements described here and in companion articles we deal with the hygroscopic growth and activation behavior of coated soot particles synthesized to mimic those of an atmospheric aerosol originating from biomass combustion. The investigations were performed during the measurement campaign LACIS Experiment in November (LExNo) which took place at the Leipzig Aerosol Cloud Interaction Simulator (LACIS). The specific goals of this campaign were (1) to perform a critical supersaturation measurement intercomparison using data sets from three different cloud condensation nucleus (CCN) instruments (two static thermal gradient type, one stream-wise thermal gradient type) and LACIS, (2) to examine particle hygroscopic growth (hydrated particle size as function of relative humidity) for particle characteristics such as aerosol mass spectrometer (AMS) measured soluble mass and particle morphology, and (3) to relate critical supersaturations derived from both measurements of soluble mass and high humidity tandem differential mobility analyzer (HH-TDMA) determined growth factors to critical supersaturations measured by means of the CCN instruments. This paper provides information on the particle synthesis techniques used during LExNo, an overview concerning the particle characterization measurements performed, and, by proving relations between measured composition, hygroscopic growth, and activation data, lay the foundations for the detailed investigations described in the companion studies. In the context of the present paper, excellent agreement of the critical supersaturations measured with three different CCN instruments and LACIS was observed. Furthermore, clear relations between coating masses determined with AMS and both hygroscopic growth factors at 98% RH and measured critical supersaturations could be seen. Also, a strong correlation between measured hygroscopic growth (growth factors at 98%) and measured critical supersaturation for all of the differently coated soot particles (coating substances being levoglucosan and/or ammonium (hydrogen) sulfate) was found. This is clearly indicative of the possibility of predicting the critical supersaturation of coated soot particles based on hygroscopic growth measurements using Kohler theory. (Less)