Guillaume Gomard

The role of random nanostructures for the omnidirectional anti-reflection properties of the glasswing butterfly

The glasswing butterfly (Greta oto) has, as its name suggests, transparent wings with remarkable low haze and reflectance over the whole visible spectral range even for large view angles of 80°. This omnidirectional anti-reflection behaviour is caused by small nanopillars covering the transparent regions of its wings. In difference to other anti-reflection coatings found in nature, these pillars are irregularly arranged and feature a random height and width distribution. Here we simulate the optical properties with the effective medium theory and transfer matrix method and show that the random height distribution of pillars significantly reduces the reflection not only for normal incidence but also for high view angles.

Micrometer-Thin Crystalline-Silicon Solar Cells Integrating Numerically Optimized 2-D Photonic Crystals

A 2-D photonic crystal was integrated experimentally into a thin-film crystalline-silicon solar cell of 1-μm thickness, after numerical optimization maximizing light absorption in the active material. The photonic crystal boosted the short-circuit current of the cell, but it also damaged its open-circuit voltage and fill factor, which led to an overall decrease in performances. Comparisons between modeled and actual optical behaviors of the cell, and between ideal and actual morphologies, show the global robustness of the nanostructure to experimental deviations, but its particular sensitivity to the conformality of the top coatings and the spread in pattern dimensions, which should not be neglected in the optical model. As for the electrical behavior, the measured internal quantum efficiency shows the strong parasitic absorptions from the transparent conductive oxide and from the back-reflector, as well as the negative impact of the nanopattern on surface passivation. Our exemplifying case, thus, illustrates and experimentally confirms two recommendations for future integration of surface nanostructures for light trapping purposes: 1) the necessity to optimize absorption not for the total stack but for the single active material, and 2) the necessity to avoid damage to the active material by pattern etching.

Absorption control in pseudodisordered photonic-crystal thin film

The positive effects of various perturbations introduced in a bidimensional photonic-crystal patterned membrane on its integrated absorption are investigated numerically and theoretically. Two phenomena responsible for the enhanced absorption observed are identified: an increase of the spectral density of modes, obtained thanks to folding mechanisms in the reciprocal lattice, and a better coupling of the modes with the incident light. By introducing a proper pseudodisordered pattern, we show that those two effects can be exploited so as to overcome the integrated absorption obtained for an optimized and single pattern unit cell photonic crystal.

Blue light absorption enhancement based on vertically channelling modes in nano-holes arrays

We investigate the specific optical regime occurring at short wavelengths, in the high absorption regime, in silicon thin-films patterned by periodically arranged nano-holes. Near-field scanning optical microscopy indicates that the incoming light is coupled to vertically channelling modes. Optical modelling and simulations show that the light, travelling inside the low-index regions, is absorbed at the direct vicinity of the nano-holes sidewalls. This channelling regime should be taken into account for light management in optoelectronic devices.

Bioinspired Superhydrophobic Highly Transmissive Films for Optical Applications

Inspired by the transparent hair layer on water plants Salvinia and Pistia, superhydrophobic flexible thin films, applicable as transparent coatings for optoelectronic devices, are introduced. Thin polymeric nanofur films are fabricated using a highly scalable hot pulling technique, in which heated sandblasted steel plates are used to create a dense layer of nano- and microhairs surrounding microcavities on a polymer surface. The superhydrophobic nanofur surface exhibits water contact angles of 166 ± 6°, sliding angles below 6°, and is self-cleaning against various contaminants. Additionally, subjecting thin nanofur to argon plasma reverses its surface wettability to hydrophilic and underwater superoleophobic. Thin nanofur films are transparent and demonstrate reflection values of less than 4% for wavelengths ranging from 300 to 800 nm when attached to a polymer substrate. Moreover, used as translucent self-standing film, the nanofur exhibits transmission values above 85% and high forward scattering. The potential of thin nanofur films for extracting substrate modes from organic light emitting diodes is tested and a relative increase of the luminous efficacy of above 10% is observed. Finally, thin nanofur is optically coupled to a multicrystalline silicon solar cell, resulting in a relative gain of 5.8% in photogenerated current compared to a bare photovoltaic device.

Modal approach for tailoring the absorption in a photonic crystal membrane

In this paper, we propose a method for tailoring the absorption in a photonic crystal membrane. For that purpose, we first applied time domain coupled mode theory to such a subwavelength membrane and demonstrated that 100% resonant absorption can be reached even for a symmetric membrane, if degenerate modes are involved. Design rules were then derived from this model in order to tune the absorption. Subsequently, finite difference time domain simulations were used as a proof of concept and carried out on a low absorbing material (extinction coefficient = 10−2) with a high refractive index corresponding to the optical indices of amorphous silicon at around 720 nm. In doing so, 85% resonant absorption was obtained, which is significantly higher than the commonly reported 50% maximum value. Those results were finally analyzed and confronted to theory so as to extend our method to other materials, configurations and applications.

Bio-inspired, large scale, highly-scattering films for nanoparticle-alternative white surfaces

Inspired by the white beetle of the genus Cyphochilus, we fabricate ultra-thin, porous PMMA films by foaming with CO2 saturation. Optimising pore diameter and fraction in terms of broad-band reflectance results in very thin films with exceptional whiteness. Already films with 60 µm-thick scattering layer feature a whiteness with a reflectance of 90%. Even 9 µm thin scattering layers appear white with a reflectance above 57%. The transport mean free path in the artificial films is between 3.5 µm and 4 µm being close to the evolutionary optimised natural prototype. The bio-inspired white films do not lose their whiteness during further shaping, allowing for various applications.

Photon management in solution-processed organic light-emitting diodes: a review of light outcoupling micro- and nanostructures

Abstract. To allow a greater acceptance in the display and lighting markets, organic light-emitting diode (OLED) technology is currently the subject of intensive research efforts aimed at manufacturing cost-effective devices with higher efficiencies. In this regard, strategies matured in the field of photonics and nanophotonics can be applied for photon management purposes to improve the outcoupling of the generated light and to control the emission pattern. In this review, we report on the recent experimental and numerical advances to pursue those goals by highlighting the example of bottom-emitting devices. The cases of periodical micro- and nanostructures, as well as of stochastic ensembles that can be easily implemented using printing techniques, are covered herein. It is shown that beyond the sole optical properties, such additional elements can simultaneously improve the electrical characteristics of solution-processed OLEDs, and thus enable an optimization of the devices at different levels.

Bioinspired phase-separated disordered nanostructures for thin photovoltaic absorbers

Inspired by black butterfly scales, self-assembled phase-separated nanostructures form efficient photovoltaic absorbers. The wings of the black butterfly, Pachliopta aristolochiae, are covered by micro- and nanostructured scales that harvest sunlight over a wide spectral and angular range. Considering that these properties are particularly attractive for photovoltaic applications, we analyze the contribution of these micro- and nanostructures, focusing on the structural disorder observed in the wing scales. In addition to microspectroscopy experiments, we conduct three-dimensional optical simulations of the exact scale structure. On the basis of these results, we design nanostructured thin photovoltaic absorbers of disordered nanoholes, which combine efficient light in-coupling and light-trapping properties together with a high angular robustness. Finally, inspired by the phase separation mechanism of self-assembled biophotonic nanostructures, we fabricate these bioinspired absorbers using a scalable, self-assembly patterning technique based on the phase separation of binary polymer mixture. The nanopatterned absorbers achieve a relative integrated absorption increase of 90% at a normal incident angle of light to as high as 200% at large incident angles, demonstrating the potential of black butterfly structures for light-harvesting purposes in thin-film solar cells.

Light scattering by oblate particles near planar interfaces: on the validity of the T-matrix approach

We investigate the T-matrix approach for the simulation of light scattering by an oblate particle near a planar interface. Its validity has been in question if the interface intersects the particles circumscribing sphere, where the spherical wave expansion of the scattered field can diverge. However, the plane wave expansion of the scattered field converges everywhere below the particle, and in particular at the planar interface. We demonstrate that the particle-interface scattering interaction is correctly accounted for through a plane wave expansion in combination with Fresnel reflection at the planar interface. We present an in-depth analysis of the involved convergence mechanisms, which are governed by the transformation properties between spherical and plane waves. The method is illustrated with the cases of spherical and oblate spheroidal nanoparticles near a perfectly conducting interface, and its accuracy is demonstrated for different scatterer arrangements and materials.