Guodi Zheng

Moisture variation associated with water input and evaporation during sewage sludge bio-drying

The variation of moisture during sewage sludge bio-drying was investigated. In situ measurements were conducted to monitor the bulk moisture and water vapor, while the moisture content, water generation, water evaporation and aeration water input of the bio-drying bulk were calculated based on the water mass balance. The moisture in the sewage sludge bio-drying material decreased from 66% to 54% in response to control technology for bio-drying. During the temperature increasing and thermophilic phases of sewage sludge bio-drying, the moisture content, water generation and water evaporation of the bulk initially increased and then decreased. The peak water generation and evaporation occurred during the thermophilic phase. During the bio-drying, water evaporation was much greater than water generation, and aeration facilitated the water evaporation.

Influence of forced air volume on water evaporation during sewage sludge bio-drying

Mechanical aeration is critical to sewage sludge bio-drying, and the actual water loss caused by aeration can be better understood from investigations of the relationship between aeration and water evaporation from the sewage sludge bio-drying pile based on in situ measurements. This study was conducted to investigate the effects of forced air volume on the evaporation of water from a sewage sludge bio-drying pile. Dewatered sewage sludge was bio-dried using control technology for bio-drying, during which time the temperature, superficial air velocity and water evaporation were measured and calculated. The results indicated that the peak air velocity and water evaporation occurred in the thermophilic phase and second temperature-increasing phase, with the highest values of 0.063 ± 0.027 m s(-1) and 28.9 kg ton(-1) matrix d(-1), respectively, being observed on day 4. Air velocity above the pile during aeration was 43-100% higher than when there was no aeration, and there was a significantly positive correlation between air volume and water evaporation from day 1 to 15. The order of daily means of water evaporation was thermophilic phase > second temperature-increasing phase > temperature-increasing phase > cooling phase. Forced aeration controlled the pile temperature and improved evaporation, making it the key factor influencing water loss during the process of sewage sludge bio-drying.

Application of a recyclable plastic bulking agent for sewage sludge composting

A recyclable plastic bulking agent (RPBA) that can be screened and reused was developed to improve sludge composting and to reduce costs. Two RPBAs were developed: RPBA35 (35 mm in diameter) and RPBA50 (50mm in diameter). The objective was to study the influence of size and quantity of RPBA on temperature, oxygen content, water removal during sludge composting, and phytotoxicity of the compost. RPBAs of both sizes improved the temperature, oxygen supply, and water removal compared with the treatment with no RPBA, and obtained phytotoxic-free compost. RPBA50 more effectively removed water than RPBA35. Oxygen diffusion rate in the composting pile containing RPBA50 was higher than in the treatment with no RPBA. When the RPBA50: sludge mixture ratio was above 1:1.5, the period over which the temperature exceeded 55 °C was insufficient to meet the harmless treatment requirement. The water evaporation rate was highest at a ratio of 1:2.

Reducing H2S production by O2 feedback control during large-scale sewage sludge composting

Hydrogen sulfide (H(2)S) production patterns and the influence of oxygen (O(2)) concentration were studied based on a well operated composting plant. A real-time, online multi-gas detection system was applied to monitor the concentrations of H(2)S and O(2) in the pile during composting. The results indicate that H(2)S was mainly produced during the early stage of composting, especially during the first 40 h. Lack of available O(2) was the main reason for H(2)S production. Maintaining the O(2) concentration higher than 14% in the pile could reduce H(2)S production. This study suggests that shortening the interval between aeration or aerating continuously to maintain a high O(2) concentration in the pile was an effective strategy for restraining H(2)S production in sewage sludge composting.

Simulation of substrate degradation in composting of sewage sludge.

To simulate the substrate degradation kinetics of the composting process, this paper develops a mathematical model with a first-order reaction assumption and heat/mass balance equations. A pilot-scale composting test with a mixture of sewage sludge and wheat straw was conducted in an insulated reactor. The BVS (biodegradable volatile solids) degradation process, matrix mass, MC (moisture content), DM (dry matter) and VS (volatile solid) were simulated numerically by the model and experimental data. The numerical simulation offered a method for simulating k (the first-order rate constant) and estimating k(20) (the first-order rate constant at 20 degrees C). After comparison with experimental values, the relative error of the simulation value of the mass of the compost at maturity was 0.22%, MC 2.9%, DM 4.9% and VS 5.2%, which mean that the simulation is a good fit. The k of sewage sludge was simulated, and k(20), k(20s) (first-order rate coefficient of slow fraction of BVS at 20 degrees C) of the sewage sludge were estimated as 0.082 and 0.015 d(-1), respectively.

Online monitoring of volatile organic compound production and emission during sewage sludge composting.

The production and emission of volatile organic compounds (VOCs) were studied using an online monitoring method in a well-operated sludge composting plant. Results indicated that VOC production within the pile was different from emission at the pile surface. The total mass of VOC production was 1.09gCkgDM(-1), which was 2.3 times as high as the total mass of emission. The maximum production and emission masses occurred in the mesophilic phase of composting and were 444 and 202mgkgDM(-1)d(-1), respectively. VOC production and emission rates also varied rapidly at different times. The relationship of VOC production rates and time in an on/off aeration cycle at different periods could be expressed as a quadratic equation, while the emission rate could be expressed as a linear equation.

Simulation of water removal process and optimization of aeration strategy in sewage sludge composting

Reducing moisture in sewage sludge is one of the main goals of sewage sludge composting and biodrying. A mathematical model was used to simulate the performance of water removal under different aeration strategies. Additionally, the correlations between temperature, moisture content (MC), volatile solids (VS), oxygen content (OC), and ambient air temperature and aeration strategies were predicted. The mathematical model was verified based on coefficients of correlation between the measured and predicted results of over 0.80 for OC, MC, and VS, and 0.72 for temperature. The results of the simulation showed that water reduction was enhanced when the average aeration rate (AR) increased to 15.37 m(3) min(-1) (6/34 min/min, AR: 102.46 m(3) min(-1)), above which no further increase was observed. Furthermore, more water was removed under a higher on/off time of 7/33 (min/min, AR: 87.34 m(3) min(-1)), and when ambient air temperature was higher.

Current status and developing trends of the contents of heavy metals in sewage sludges in China

It is essential to determine the heavy metal concentrations in sewage sludge to select appropriate disposal methods. We conducted a national survey of heavy metal concentrations of sewage sludge samples from 107 municipal sewage treatment plants located in 48 cities covering the 31 provinces and autonomous regions, as well as Hong Kong, Macao and Taiwan by Xinjiang Production and Construction Corps in 2006, and identified the temporal trends of heavy metal contents in sewage sludge by comparison with surveys conducted in 1994–2001. In 2006, the average concentrations of As, Cd, Cr, Cu, Hg, Ni, Pb, and Zn in sewage sludge were 20.2, 1.97, 93.1, 218.8, 2.13, 48.7, 72.3, and 1058 mg·kg−1, respectively. Because of the decreased discharge of heavy metals into industrial wastewater in China and the increasingly stringent regulations governing the content of industrial wastes entering sewers, the average concentrations of Cd, Cr, Cu, Hg, Ni, Pb, and Zn have decreased by 32.3%, 49.7%, 54.9%, 25.0%, 37.2%, 44.8%, and 27.0%, respectively, during the past 12 years. The concentrations of Cd, Cr, Cu, Ni, and Zn in the samples exceeded the heavy metal limits of the Discharge Standard of Pollutants for Municipal Wastewater Treatment Plant in China (GB 18918-2002) by 6.5%, 3.7%, 6.5%, 6.5%, and 11.2%, respectively. From these results, 85 of the 107 municipal sludges analyzed would be considered suitable for land application.

Time domain reflectometry measured moisture content of sewage sludge compost across temperatures

Time domain reflectometry (TDR) is a prospective measurement technology for moisture content of sewage sludge composting material; however, a significant dependence upon temperature has been observed. The objective of this study was to assess the impacts of temperature upon moisture content measurement and determine if TDR could be used to monitor moisture content in sewage sludge compost across a range of temperatures. We also investigated the combined effects of temperature and conductivity on moisture content measurement. The results revealed that the moisture content of composting material could be determined by TDR using coated probes, even when the measured material had a moisture content of 0.581 cm(3)cm(-3), temperature of 70°C and conductivity of 4.32 mS cm(-1). TDR probes were calibrated as a function of dielectric properties that included temperature effects. When the bulk temperature varied from 20°C to 70°C, composting material with 0.10-0.70 cm(3)cm(-3) moisture content could be measured by TDR using coated probes, and calibrations based on different temperatures minimized the errors.

Heavy metal contents and enrichment characteristics of dominant plants in wasteland of the downstream of a lead-zinc mining area in Guangxi, Southwest China

A field investigation on the content of heavy metals in soils and 17 kinds of dominant plants from wasteland of the downstream of a Pb-Zn mine in Northwest Guangxi Zhuang Autonomous Region was carried out. The absorption and accumulation characteristics of heavy metals between plants and soil were compared, and the candidate species for ecosystem restoration of the area were selected. The results indicated that the soils had been subjected to pollution of heavy metals in varying degrees. The concentrations of Cd, Pb, Zn were 46.5, 57.3 and 23.7 times higher than their corresponding background values, respectively. The contents of Cd, Pb and Zn in the most analyzed plants exceed the normal ranges and the phytotoxic level. C. crepidioides, S. nigrum, B. pilosa, C. Canadensis, A. conyzoides, I. denticulata and E. crusgali showed strong capability in accumulation and transport of Cd, and they could be used as good candidates for Cd- phytoextraction. Among which, Cd concentration in the aerial part of C. crepidioides exceeded the threshold of Cd-hyperaccumulator. Thus, C. crepidioides demonstrated the basic characteristics of a Cd-hyperaccumulator. The lower translocation ratios for Cd, Cu, Zn and Pb in P. vittata and C. chinensis make them suitable for phytostabilization in the study area.