H. C. Xu

Interface-induced superconductivity and strain-dependent spin density waves in FeSe/SrTiO3 thin films

The record superconducting transition temperature (T(c)) for the iron-based high-temperature superconductors (Fe-HTS) has long been 56 K. Recently, in single-layer FeSe films grown on SrTiO3 substrates, indications of a new record of 65 K have been reported. Using in situ photoemission measurements, we substantiate the presence of spin density waves (SDWs) in FeSe films--a key ingredient of Fe-HTS that was missed in FeSe before--and we find that this weakens with increased thickness or reduced strain. We demonstrate that the superconductivity occurs when the electrons transferred from the oxygen-vacant substrate suppress the otherwise pronounced SDWs in single-layer FeSe. Beyond providing a comprehensive understanding of FeSe films and directions to further enhance its T(c), we map out the phase diagram of FeSe as a function of lattice constant, which contains all the essential physics of Fe-HTS. With the simplest structure, cleanest composition and single tuning parameter, monolayer FeSe is an ideal system for testing theories of Fe-HTS.

Nodeless superconducting gap in AxFe2Se2 (A=K,Cs) revealed by angle-resolved photoemission spectroscopy

Pairing symmetry is a fundamental property that characterizes a superconductor. For the iron-based high-temperature superconductors, an s(±)-wave pairing symmetry has received increasing experimental and theoretical support. More specifically, the superconducting order parameter is an isotropic s-wave type around a particular Fermi surface, but it has opposite signs between the hole Fermi surfaces at the zone centre and the electron Fermi surfaces at the zone corners. Here we report the low-energy electronic structure of the newly discovered superconductors, A(x)Fe(2)Se(2) (A=K,Cs) with a superconducting transition temperature (Tc) of about 30 K. We found A(x)Fe(2)Se(2) (A=K,Cs) is the most heavily electron-doped among all iron-based superconductors. Large electron Fermi surfaces are observed around the zone corners, with an almost isotropic superconducting gap of ~10.3 meV, whereas there is no hole Fermi surface near the zone centre, which demonstrates that interband scattering or Fermi surface nesting is not a necessary ingredient for the unconventional superconductivity in iron-based superconductors. Thus, the sign change in the s(±) pairing symmetry driven by the interband scattering as suggested in many weak coupling theories becomes conceptually irrelevant in describing the superconducting state here. A more conventional s-wave pairing is probably a better description.

Tuning the band structure and superconductivity in single-layer FeSe by interface engineering

The interface between transition metal compounds provides a rich playground for emergent phenomena. Recently, significantly enhanced superconductivity has been reported for single-layer FeSe on Nb-doped SrTiO3 substrate. Yet it remains mysterious how the interface affects the superconductivity. Here we use in situ angle-resolved photoemission spectroscopy to investigate various FeSe-based heterostructures grown by molecular beam epitaxy, and uncover that electronic correlations and superconducting gap-closing temperature (Tg) are tuned by interfacial effects. Tg up to 75 K is observed in extremely tensile-strained single-layer FeSe on Nb-doped BaTiO3, which sets a record high pairing temperature for both Fe-based superconductor and monolayer-thick films, providing a promising prospect on realizing more cost-effective superconducting device. Moreover, our results exclude the direct correlation between superconductivity and tensile strain or the energy of an interfacial phonon mode, and highlight the critical and non-trivial role of FeSe/oxide interface on the high Tg, which provides new clues for understanding its origin.In the quest for high temperature superconductors, the interface between a metal and a dielectric was proposed to possibly achieve very high superconducting transition temperature (

Surface electronic structure and isotropic superconducting gap in ( Li 0.8 Fe 0.2 ) OH Fe Se

T_c

Tuning the dead-layer behavior of La0.67Sr0.33MnO3/SrTiO3 via interfacial engineering

) through interface-assisted pairing. Recently, in single layer FeSe (SLF) films grown on SrTiO

Direct Observation of the Bandwidth Control Mott Transition in the NiS

_3

_{2-x}

substrates, signs for

Se

T_c

_x

up to 65~K have been reported. However, besides doping electrons and imposing strain, whether and how the substrate facilitates the superconductivity are still unclear. Here we report the growth of various SLF films on thick BaTiO

Multiband System

_3