Haiping He

Carrier concentration dependence of band gap shift in n-type ZnO:Al films

Al-doped ZnO (AZO) thin films have been prepared by mist chemical vapor deposition and magnetron sputtering. The band gap shift as a function of carrier concentration in n-type zinc oxide (ZnO) was systematically studied considering the available theoretical models. The shift in energy gap, evaluated from optical absorption spectra, did not depend on sample preparations; it was mainly related to the carrier concentrations and so intrinsic to AZO. The optical gap increased with the electron concentration approximately as ne2∕3 for ne≤4.2×1019 cm−3, which could be fully interpreted by a modified Burstein–Moss (BM) shift with the nonparabolicity of the conduction band. A sudden decrease in energy gap occurred at 5.4−8.4×1019 cm−3, consistent with the Mott criterion for a semiconductor-metal transition. Above the critical values, the band gap increased again at a different rate, which was presumably due to the competing BM band-filling and band gap renormalization effects, the former inducing a band gap widen...

ZnO light-emitting diode grown by plasma-assisted metal organic chemical vapor deposition

We report a breakthrough in fabricating ZnO homojunction light-emitting diode by metal organic chemical vapor deposition. Using NO plasma, we are able to grow p-type ZnO thin films on n-type bulk ZnO substrates. The as-grown films on glass substrates show hole concentration of 1016–1017cm−3 and mobility of 1–10cm2V−1s−1. Room-temperature photoluminescence spectra reveal nitrogen-related emissions. A typical ZnO homojunction shows rectifying behavior with a turn-on voltage of about 2.3V. Electroluminescence at room temperature has been demonstrated with band-to-band emission at I=40mA and defect-related emissions in the blue-yellow spectrum range.

Control of p- and n-type conductivities in Li-doped ZnO thin films

Li-doped ZnO films were prepared by pulsed laser deposition. The carrier type could be controlled by adjusting the growth conditions. In an ionized oxygen atmosphere, p-type ZnO was achieved, with the hole concentration of 6.04×1017cm−3 at an optimal Li content of 0.6at.%, whereas ZnO exhibited n-type conductivity in a conventional O2 growth atmosphere. At a Li content of more than 1.2at.% only high-resistivity ZnO was obtained. The amount of Li introduced into ZnO and the relative concentrations of such defects as Li substitutions and interstitials could play an important role in determining the conductivity of films.

Exciton localization in solution-processed organolead trihalide perovskites

Organolead trihalide perovskites have attracted great attention due to the stunning advances in both photovoltaic and light-emitting devices. However, the photophysical properties, especially the recombination dynamics of photogenerated carriers, of this class of materials are controversial. Here we report that under an excitation level close to the working regime of solar cells, the recombination of photogenerated carriers in solution-processed methylammonium–lead–halide films is dominated by excitons weakly localized in band tail states. This scenario is evidenced by experiments of spectral-dependent luminescence decay, excitation density-dependent luminescence and frequency-dependent terahertz photoconductivity. The exciton localization effect is found to be general for several solution-processed hybrid perovskite films prepared by different methods. Our results provide insights into the charge transport and recombination mechanism in perovskite films and help to unravel their potential for high-performance optoelectronic devices.

ZnO light-emitting diodes fabricated on Si substrates with homobuffer layers

ZnO homojunction light-emitting diodes (LEDs), comprised of N–Al codoped p-type ZnO and Al-doped n-type ZnO layers, were fabricated on Si substrates with homobuffer layers. The current-voltage measurements showed typical diode characteristic with a threshold voltage of about 3.3V. The electroluminescence (EL) bands at 110K consisted of a near-band-edge emission at 3.18eV and a deep level emission at 2.58eV. The EL emissions were assigned as radiative recombinations, presumably of donor-acceptor pairs, in the p-type layer of the LED. The quenching of EL with temperature was attributed to the degradation of p-type conducting of the ZnO:(N,Al) layer.

Room-temperature photoluminescence from ZnO∕ZnMgO multiple quantum wells grown on Si(111) substrates

A set of ten-period ZnO∕Zn0.85Mg0.15O multiple quantum wells with well thickness varying from 2.5to5nm has been grown on Si(111) substrates by pulsed laser deposition. A periodic structure with sharp interfaces was observed by cross-sectional transmission electron microscopy. The room-temperature photoluminescence resulting from the well regions exhibits a significant blueshift with respect to the ZnO single layer. The well layer thickness dependence of the emission energy from the well regions was investigated and compared with a simple theoretical model. The results suggest that the quantum confinement effects in the quantum wells can be observed up to room temperature.

p-type behavior in nominally undoped ZnO thin films by oxygen plasma growth

We report on intrinsic p-type ZnO thin films by plasma-assisted metal-organic chemical vapor deposition. The optimal results give a resistivity of 12.7Ωcm, a Hall mobility of 2.6cm2∕Vs, and a hole concentration of 1.88×1017cm−3. The oxygen concentration is increased in the intrinsic p-type ZnO, compared with the n-type layer. Two acceptor states, with the energy levels located at 160 and 270meV above the valence band maximum, are identified by temperature-dependent photoluminescence. The origin of intrinsic p-type behavior has been ascribed to the formation of zinc vacancy and some complex acceptor center.

Electrical and optical properties of phosphorus-doped p-type ZnO films grown by metalorganic chemical vapor deposition

P-doped p-type ZnO thin films have been grown by metalorganic chemical vapor deposition. By modulating the P evaporating temperature, p-type conductivity can be controlled due to the different P content incorporated into the ZnO films. The P-doped p-type ZnO thin films are of high optical quality, as indicated by low-temperature photoluminescence. P-related acceptor state with an energy level of 163 meV is identified from free-to-neutral-acceptor transitions. In addition, x-ray photoelectron spectroscopy confirms that only one chemical bonding state of P exists in the P-doped ZnO thin films.

Surface Passivation Effect on the Photoluminescence of ZnO Nanorods

We report an investigation of the impact of surface passivation on the optical properties of ZnO nanorods. Al2O3 coating and hydrogen plasma treatment were used to passivate the surface states. It was found that Al2O3 coating led to the suppression of the deep level emissions, while hydrogen plasma treatment completely quenched the deep level emissions. It was confirmed that the surface states of the as-grown ZnO nanorod arrays indeed contributed to the deep level emissions. Evidence was also provided that shows surface states have a greater impact on the green emission than the orange emission and may cause the negative thermal quenching behavior. Moreover, the passivation effect was confirmed by the changes of the O 1s and Zn 2p spectra.

Controlled synthesis of spinel ZnFe2O4 decorated ZnO heterostructures as peroxidase mimetics for enhanced colorimetric biosensing

Controlled synthesis of spinel ZnFe2O4 nanoparticle-decorated ZnO nanofiber heterostructures was carried out with regularly varied particle sizes and uniform distribution. The obtained heterostructures possessed enhanced intrinsic peroxidase-like activity, and the activities regularly changed as the sizes of ZnFe2O4 nanoparticles varied. The heterostructures were further applied in sensitive colorimetric biosensing of urine glucose.