Helen G. Hansma

Tapping mode atomic force microscopy in liquids

Tapping mode atomic force microscopy in liquids gives a substantial improvement in imaging quality and stability over standard contact mode. In tapping mode the probe‐sample separation is modulated as the probe scans over the sample. This modulation causes the probe to tap on the surface only at the extreme of each modulation cycle and therefore minimizes frictional forces that are present when the probe is constantly in contact with the surface. This imaging mode increases resolution and reduces sample damage on soft samples. For our initial experiments we used a tapping frequency of 17 kHz to image deoxyribonucleic acid plasmids on mica in water. When we imaged the same sample region with the same cantilever, the plasmids appeared 18 nm wide in contact mode and 5 nm in tapping mode.

Bone indentation recovery time correlates with bond reforming time

Despite centuries of work, dating back to Galileo, the molecular basis of bones toughness and strength remains largely a mystery. A great deal is known about bone microsctructure and the microcracks that are precursors to its fracture, but little is known about the basic mechanism for dissipating the energy of an impact to keep the bone from fracturing. Bone is a nanocomposite of hydroxyapatite crystals and an organic matrix. Because rigid crystals such as the hydroxyapatite crystals cannot dissipate much energy, the organic matrix, which is mainly collagen, must be involved. A reduction in the number of collagen cross links has been associated with reduced bone strength and collagen is molecularly elongated (‘pulled’) when bovine tendon is strained. Using an atomic force microscope, a molecular mechanistic origin for the remarkable toughness of another biocomposite material, abalone nacre, has been found. Here we report that bone, like abalone nacre, contains polymers with ‘sacrificial bonds’ that both protect the polymer backbone and dissipate energy. The time needed for these sacrificial bonds to reform after pulling correlates with the time needed for bone to recover its toughness as measured by atomic force microscope indentation testing. We suggest that the sacrificial bonds found within or between collagen molecules may be partially responsible for the toughness of bone.

Reproducible Imaging and Dissection of Plasmid DNA Under Liquid with the Atomic Force Microscope

Reproducible images of uncoated DNA in the atomic force microscope (AFM) have been obtained by imaging plasmid DNA on mica in n-propanol. Specially sharpened AFM tips give images with reproducible features several nanometers in size along the DNA. Plasmids can be dissected in propanol by increasing the force applied by the AFM tip at selected locations.

DNA binding to mica correlates with cationic radius: assay by atomic force microscopy

In buffers containing selected transition metal salts, DNA binds to mica tightly enough to be directly imaged in the buffer in the atomic force microscope (AFM, also known as scanning force microscope). The binding of DNA to mica, as measured by AFM-imaging, is correlated with the radius of the transition metal cation. The transition metal cations that effectively bind DNA to mica are Ni(II), Co(II), and Zn(II), which have ionic radii from 0.69 to 0.74 A. In Mn(II), ionic radius 0.82 A, DNA binds weakly to mica. In Cd(II) and Hg(II), respective ionic radii of 0.97 and 1.1 A, DNA does not bind to mica well enough to be imaged with the AFM. These results may to relate to how large a cation can fit into the cavities above the recessed hydroxyl groups in the mica lattice, although hypotheses based on hydrated ionic radii cannot be ruled out. The dependence of DNA binding on the concentrations of the cations Ni(II), Co(II), or Zn(II) shows maximal DNA binding at approximately 1-mM cation. Mg(II) does not bind DNA tightly enough to mica for AFM imaging. Mg(II) is a Group 2 cation with an ionic radius similar to that of Ni(II). Ni(II), Co(II), and Zn(II) have anomalously high enthalpies of hydration that may relate to their ability to bind DNA to mica. This AFM assay for DNA binding to mica has potential applications for assaying the binding of other polymers to mica and other flat surfaces.

Mapping interaction forces with the atomic force microscope

Force curves were recorded as the sample was raster-scanned under the tip. This opens new opportunities for imaging with the atomic force microscope: several characteristics of the samples can be measured simultaneously, for example, topography, adhesion forces, elasticity, van der Waals, and electrostatic interactions. The new opportunities are illustrated by images of several characteristics of thin metal films, aggregates of lysozyme, and single molecules of DNA.

Probing protein-protein interactions in real time.

We have used a prototype small cantilever atomic force microscope to observe, in real time, the interactions between individual protein molecules. In particular, we have observed individual molecules of the chaperonin protein GroES binding to and then dissociating from individual GroEL proteins, which were immobilized on a mica support. This work suggests that the small cantilever atomic force microscope is a useful tool for studying protein dynamics at the single molecule level.

Direct Observation of One-Dimensional Diffusion and Transcription by Escherichia coli RNA Polymerase

The dynamics of nonspecific and specific Escherichia coli RNA polymerase (RNAP)-DNA complexes have been directly observed using scanning force microscopy operating in buffer. To this end, imaging conditions had to be found in which DNA molecules were adsorbed onto mica strongly enough to be imaged, but loosely enough to be able to diffuse on the surface. In sequential images of nonspecific complexes, RNAP was seen to slide along DNA, performing a one-dimensional random walk. Heparin, a substance known to disrupt nonspecific RNAP-DNA interactions, prevented sliding. These observations suggest that diffusion of RNAP along DNA constitutes a mechanism for accelerated promoter location. Sequential images of single, transcribing RNAP molecules were also investigated. Upon addition of 5 microM nucleoside triphosphates to stalled elongation complexes in the liquid chamber, RNAP molecules were seen to processively thread their template at rates of 1.5 nucleotide/s in a direction consistent with the promoter orientation. Transcription assays, performed with radiolabeled, mica-bound transcription complexes, confirmed this rate, which was about three times smaller than the rate of complexes in solution. This assay also showed that the pattern of pause sites and the termination site were affected by the surface. By using the Einstein-Sutherland friction-diffusion relation the loading force experienced by RNAP due to DNA-surface friction is estimated and discussed.

Applications for atomic force microscopy of DNA.

Tapping mode atomic force microscopy (AFM) of DNA in propanol, dry helium, and aqueous buffer each have specific applications. Resolution is best in propanol, which precipitates and immobilizes the DNA and provides a fluid imaging environment where adhesive forces are minimized. Resolution on exceptional images of DNA appears to be approximately 2 nm, sufficient to see helix turns in detail, but the smallest substructures typically seen on DNA in propanol are approximately 6-10 nm in size. Tapping AFM in dry helium provides a convenient way of imaging such things as conformations of DNA molecules and positions of proteins on DNA. Images of single-stranded DNA and RecA-DNA complexes are presented. In aqueous buffer DNA molecules as small as 300 bp have been imaged even when in motion. Images are presented of the changes in shape and position of circular plasmid DNA molecules.

Fast imaging and fast force spectroscopy of single biopolymers with a new atomic force microscope designed for small cantilevers

Small cantilevers allow for faster imaging and faster force spectroscopy of single biopolymers than previously possible because they have higher resonant frequencies and lower coefficients of viscous damping. We have used a new prototype atomic force microscope with small cantilevers to produce stable tapping-mode images (1 μm×1 μm) in liquid of DNA adsorbed onto mica in as little as 1.7 s per image. We have also used these cantilevers to observe the forced unfolding of individual titin molecules on a time scale an order of magnitude faster than previously reported. These experiments demonstrate that a new generation of atomic force microscopes using small cantilevers will enable us to study biological processes with greater time resolution. Furthermore, these instruments allow us to narrow the gap in time between results from force spectroscopy experiments and molecular dynamics calculations.

Motion and enzymatic degradation of DNA in the atomic force microscope

The dynamics and enzymatic degradation of single DNA molecules can now be observed with the atomic force microscope. A combination of two advances has made this possible. Tapping in fluid has reduced lateral forces, which permits the imaging of loosely adsorbed molecules; and the presence of nickel ions appears to form a relatively stable bridge between the negatively charged mica and the negatively charged DNA phosphate backbone. Continuous imaging shows DNA motion and the process of DNA degradation by the nuclease DNase I. It is possible to see DNase degradation of both loosely adsorbed and tightly adsorbed DNA molecules. This method gives images in aqueous buffer of bare, uncoated DNA molecules with lengths of only a few hundred base pairs, or approximately 100 nm in length.