Helle A. Pedersen

Complex lithospheric structure under the central Baltic Shield from surface wave tomography

Complex lithospheric structure under the central Baltic Shield from surface wave tomography

Crustal structure below Popocatépetl Volcano (Mexico) from analysis of Rayleigh waves

An array of ten broadband stations was installed on the Popocatepetl volcano (Mexico) for five months between October 2002 and February 2003. 26 regional and teleseismic earthquakes were selected and filtered in the frequency time domain to extract the fundamental mode of the Rayleigh wave. The average dispersion curve was obtained in two steps. Firstly, phase velocities were measured in the period range [2-50] s from the phase difference between pairs of stations, using Wiener filtering. Secondly, the average dispersion curve was calculated by combining observations from all events in order to reduce diffraction effects. The inversion of the mean phase velocity yielded a crustal model for the volcano which is consistent with previous models of the Mexican Volcanic Belt. The overall crustal structure beneath Popocatepetl is therefore not different from the surrounding area, and the velocities in the lower crust are confirmed to be relatively low. Lateral variations of the structure were also investigated by dividing the network into four parts and by applying the same procedure to each sub-array. No well-defined anomalies appeared for the two sub-arrays for which it was possible to measure a dispersion curve. However, dispersion curves associated with individual events reveal important diffraction for 6 s to 12 s periods which could correspond to strong lateral variations at 5 to 10 km depth.

Anomalous surface waves from Lop Nor nuclear explosions: Observations and numerical modeling

Surface waves from the Chinese test site of Lop Nor are analyzed using long-period and broadband stations located at regional and teleseismic distances and at different azimuths. For most azimuths, strong Love waves between 0.02 and 0.045 Hz are observed with an amplitude of up to 10 times that of the Rayleigh waves. In addition, an anomalous early Rayleigh wave train is observed at some stations in western Europe. Due to a particularly favorable station and source configuration, it is possible to isolate the areas where the anomalies are created. The high-amplitude Love waves must be attributed to either source effects or path effects immediately north of Lop Nor. The early wave train is shown to be due to a partial energy conversion between Love and Rayleigh waves, probably at the Tornquist Zone. To estimate the possible contribution from surface wave conversions to the observed anomalies, numerical simulations are carried out with the indirect boundary element method. The simulations show that a relatively small variation of crustal thickness can induce Rayleigh to Love wave conversions between 0.02 and 0.1 Hz frequency. The calculated amplitudes of the Love waves are significant (up to 35% of the amplitude of the incoming Rayleigh waves), but they are too small to fit the observed amplitude anomaly. The observed converted waves and the numerical results nevertheless indicate that surface wave conversions can be significant across strong lateral crustal heterogeneities. In particular, the conversions due to changes in crustal thickness are located in the period interval which is routinely used for estimation of Ms.