Henrik M. Schrøder

Patient survival after total knee arthroplasty: 5-year data in 926 patients

We analyzed prospectively the 5-year survival in 926 patients undergoing 1,024 total knee arthroplasties (TKA) in the period February 1989-December 1990. The patients were compared to an age- and sex-matched general population and to 326 patients operated on in the same period with total hip arthroplasty. Cox analysis showed that male sex, rheumatoid arthritis and complications within the first year increased the mortality rate in the TKA group. When this group was compared to the general population, only rheumatoid patients aged 65-74 years had an increased mortality. Generally, the TKA patients had a longer survival than the general population, especially women > 75 years old with arthrosis. The cumulative 5-year patient survival was 89%, both after hip and knee arthroplasty and was 81% in the matched general population.

Cementless total knee arthroplasty in rheumatoid arthritis: A report on 51 AGC knees followed for 54 months

Fifty-one primary consecutive cementless AGC 2000 (Anatomically Graduated Components, Biomet, Warsaw, IN) total knee arthroplasties were performed during 1985 through 1990 in 40 patients with rheumatoid arthritis. Forty-one knees (32 patients) were available for clinical and radiologic follow-up analysis after 24 to 76 months (median, 54 months). There was no pain in 33 knees and mild pain in the rest. Median range of motion was 110 degrees (range, 50 degrees-130 degrees). Median knee score was 90 (range, 71-97), and all knees were rated good or excellent. Radiolucencies greater than 1 mm were found under five tibial components, but no obvious migrations were seen. One tibial component was revised due to aseptic loosening. The cumulative success rate after 4 to 5 years was 97% (lower limit of 95% confidence interval, 91.8%). The medium-term results are considered to compare favorably with reported cemented series.

Outcome of revision total knee arthroplasty with the use of trabecular metal cone for reconstruction of severe bone loss at the proximal tibia.

BACKGROUND The relative effectiveness of different methods for reconstructing large bone loss at the proximal tibia in revision total knee arthroplasty (rTKA) has not been established. The aim of this study was to evaluate the clinical and radiological outcome after the use of trabecular metal technology (TMT) cones for the reconstruction of tibial bone loss at the time of rTKA. METHODS Thirty-six patients had rTKA with the use of a TMT Cone. Bone loss was classified according to the AORI classification and 25% of the patients suffered from T3 AORI defects and 75% of the patients from T2 AORI defects. Implants used were from the NexGen series. At follow-up, radiographs were evaluated according to the Knee Society Roentgenographic Scoring System. Knee and function score was calculated using the Knee Society Clinical Rating System. Average follow-up time was 47 months (range 3-84 months). RESULTS Clinical and radiological follow-up data were available in 30 patients and missing in six patients: two died and four patients had re-revision (reinfection (n=2), aseptic loosening (n=1), and knee hyperextension (n=1)). Knee- and function scores (follow-up 43 months (range 12-84 months)) improved from 42 to 77 points (p<0.0005) and 19 to 63 points (p<0.0005) respectively. Twenty-seven patients (follow-up 44 months (range 12-72 months)) showed no signs of radiological loosening of rTKA components. CONCLUSION Based on our study, it was concluded that the use of TMT Cones provided an effective treatment in terms of surgical efficacy, clinical results and radiological results and was evidently at least as effective as the other options reviewed in the literature. LEVEL OF EVIDENCE IV.

Monoblock versus modular polyethylene insert in uncemented total knee arthroplasty: A randomized RSA study with 2-year follow-up of 53 patients

Background and purpose — Backside wear of the polyethylene insert in total knee arthroplasty (TKA) can produce clinically significant levels of polyethylene debris, which can lead to loosening of the tibial component. Loosening due to polyethylene debris could theoretically be reduced in tibial components of monoblock polyethylene design, as there is no backside wear. We investigated the effect of 2 different tibial component designs, monoblock and modular polyethylene, on migration of the tibial component in uncemented TKA. Patients and methods — In this randomized study, 53 patients (mean age 61 years), 32 in the monoblock group and 33 in the modular group, were followed for 2 years. Radiostereometric analysis (RSA) was done postoperatively after weight bearing and after 3, 6, 12, and 24 months. The primary endpoint of the study was comparison of the tibial component migration (expressed as maximum total point motion (MTPM)) of the 2 different implant designs. Results — We did not find any statistically significant difference in MTPM between the groups at 3 months (p = 0.2) or at 6 months (p = 0.1), but at 12 and 24 months of follow-up there was a significant difference in MTPM of 0.36 mm (p = 0.02) and 0.42 mm (p = 0.02) between groups, with the highest amount of migration (1.0 mm) in the modular group. The difference in continuous migration (MTPM from 12 and 24 months) between the groups was 0.096 mm (p = 0.5), and when comparing MTPM from 3–24 months, the difference between the groups was 0.23 mm (p = 0.07). Interpretation — In both study groups, we found the early migration pattern expected, with a relatively high initial amount of migration from operation to 3 months of follow-up, followed by stabilization of the implant with little migration thereafter. However, the modular implants had a statistically significantly higher degree of migration compared to the monoblock. We believe that the greater stiffness of the modular implants was the main reason for the difference in migration, but an initial creep in the polyethylene metal-back locking mechanism of the modular group could also be a possible explanation for the observed difference in migration between the 2 study groups.

Bone Remodeling of the Distal Femur After Uncemented Total Knee Arthroplasty—A 2-Year Prospective DXA Study

Loss of bone stock as a response to the bone trauma, immobilization, and stress shielding related to joint replacement surgery increases the risk of fracture of the distal femur after total knee arthroplasty. Previous studies of uncemented femoral components have reported very high levels of bone loss in the distal femur. This study investigates the adaptive bone remodeling of the distal femur after uncemented total knee arthroplasty. We performed a 2-year follow-up of 53 patients (mean age 61.5 [38-70] years, F/M = 27/26, body mass index 29.5) who because of osteoarthritis received an uncemented total knee arthroplasty. All patients received a NexGen CR-Flex Porous Femoral Component. Measurements of bone mineral density of the distal femur using dual-energy X-ray absorptiometry were performed postoperatively and after 3, 6, 12, and 24 months. Bone mineral density (g/cm2) was measured in 3 regions of interest in the periprosthetic bone of the distal femur. Repeated measures analysis of variance and Tukey post hoc test for bone mineral density changed over time (p < 0.05 were considered significant). In the distal femur, significant changes in bone mineral density were seen after 24 months of follow-up, and bone mineral density decreased by 23.6% in the anterior region behind the anterior flange of the prosthesis (p < 0.001), 10.1% in the posterior region (p < 0.001), and 5.5% in the most proximal region (p < 0.001). We found highly significant bone mineral change in the distal femur after uncemented total knee arthroplasty, most pronounced in the anterior region, where a decrease in bone mineral density of almost 25%, was seen. Taking the expected age-related decay in bone mineral density in this age group into consideration, the decrease was substantial and must be considered to predispose to periprosthetic fractures.

Bone mineral density of the distal femur following uncemented total knee arthroplasty: a two-year follow-up of 11 knees using dual energy X-ray absorptiometry

In a prospective study, we evaluated the adaptive bone remodelling pattern of the distal femur using dual energy X-ray absorptiometry (DEXA) after total knee arthroplasty (TKA). Eleven patients underwent TKA with insertion of an Interax total knee system (Howmedica) because of primary osteoarthrosis of the knee. All patients received an uncemented femoral component with an uncoated cast-mesh ingrowth surface. The components had a 20-mm long central peg placed anteriorly just behind the anterior flange. DEXA scans were performed postoperatively at 2 weeks and at 3, 6, 12 and 24 months in the mediolateral plane of the distal femur and in the anteroposterior plane of the distal tibia and fibula. Compared to the immediate 2-week postoperative bone mineral density (BMD) value, we found no significant changes in BMD in 4 regions of interest (ROI) in the distal femur during the 2-year follow-up at 3 months. A temporary but significant decrease in BMD of 11.2% (95% CL, -17.3% to -5.0%) was observed in the most distal ROI just posterior to the fixation peg. Bone mineral content (BMC) of the distal tibia and fibula showed no significant changes in the operated and contralateral legs during the follow-up. The adaptive bone remodelling of the distal femur after TKA using an uncemented femoral component not previously examined by DEXA induced only a very limited and temporary loss of bone mineral.