Network
Latest external collaboration on country level. Dive into details by clicking on the dots.
Publication
Featured researches published by Hong-Yeon Cho.
Journal of Korean Society of Coastal and Ocean Engineers | 2013
Hyuck-Min Kweon; Hong-Yeon Cho; Weon-Mu Jeong
There exist various types of the WEC (Wave Energy Converter), and among them, the point absorber is the most popularly investigated type. However, it is difficult to find examples of systematically measured data analysis for the design of the point absorber type of power buoy in the world. The study investigates the wave load acting on the point absorber type resonance power buoy wave energy extraction system proposed by Kweon et al. (2010). This study analyzes the time series spectra with respect to the three-year wave data (2002.05.01~2005.03.29) measured using the pressure type wave gage at the seaside of north breakwater of Hupo harbor located in the east coast of the Korean peninsula. From the analysis results, it could be deduced that monthly wave period and wave height variations were apparent and that monthly wave powers were unevenly distributed annually. The average wave steepness of the usual wave was 0.01, lower than that of the wind wave range of 0.02-0.04. The mode of the average wave period has the value of 5.31 sec, while mode of the wave height of the applicable period has the value of 0.29 m. The occurrence probability of the peak period is a bi-modal type, with a mode value between 4.47 sec and 6.78 sec. The design wave period can be selected from the above four values of 0.01, 5.31, 4.47, 6.78. About 95% of measured wave heights are below 1 m. Through this study, it was found that a resonance power buoy system is necessary in coastal areas with low wave energy and that the optimal design for overcoming the uneven monthly distribution of wave power is a major task in the development of a WEF (Wave Energy Farm). Finding it impossible to express the average spectrum of the usual wave in terms of the standard spectrum equation, this study proposes a new spectrum equation with three parameters, with which basic data for the prediction of the power production using wave power buoy and the fatigue analysis of the system can be given.
Journal of Korean Society of Coastal and Ocean Engineers | 2015
Weon Mu Jeong; Hong-Yeon Cho; Won-Dae Baek
Wave data acquired over seven years near Daejin Harbor located in the north central area of the east coast was analyzed using spectral method and wave-by-wave analysis method and its major wave characteristics were examined. Significant wave heights were found to be high in winter and low in summer, and peak periods were also found to be long in winter and short in summer. The maximum significant wave height observed was 6.59 m and was caused by Typhoon No. 1216, SANBA. The distributional pattern of the significant wave heights and peak periods were both reproduced better by Kernel distribution function than by Generalized Gamma distribution function and Generalized Extreme Value distribution function. Meanwhile, the wave data was subdivided by month and wave height level and the cumulative appearance rate was proposed to aid designing and constructing works in nearby coastal areas.
Journal of Korean Society of Coastal and Ocean Engineers | 2014
Ju Whan Kang; Yang-Mi Joo; Hong-Yeon Cho; Hyuck-Min Kweon
The approximately highest high water(AHHW), which has been used frequently as a basis of the design sea level, has not only ambiguous return period but also spatio-temporal problems induced by sea level rise and the spatial variability of tidal characteristics. The ratios of 4 major constituents with other constituents were investigated. In addition, tidal data were analyzed by probability density function. The temporal variability may be cured by using the latest tidal data. And the AHHW at summer was examined to lessen the spatial variability. The results show that the design sea levels need to increase by 10 cm or more at the Southern Coast and by 15~25 cm at the East Coast.
Journal of Korean Society of Coastal and Ocean Engineers | 2013
Hong-Yeon Cho; Weon-Mu Jeong; Ki Cheon Jun
In this study, the quantitative analysis and pattern analysis of the error bounds with respect to recording period were carried out using the wave climate data from coastal areas. Arbitrary recording periods were randomly sampled from one month to six years using the bootstrap method. Based on the analysis, for recording periods less than one year, it was found that the error bounds decreased rapidly as the recording period increased. Meanwhile, the error bounds were found to decrease more slowly for recording periods longer than one year. Assuming the absolute estimate error to be around 10% () for an one meter significant wave height condition, the minimum recording period for reaching the estimate error for Sokcho and Geoje-Hongdo stations satisfied this condition with over two years of data, while Anmado station was found to satisfy this condition when using observational data of over three years. The confidence intervals of the significant wave height clearly show an increasing pattern when the percentile value of the wave height increases. Whereas, the confidence intervals of the mean wave period are nearly constant, at around 0.5 seconds except for the tail regions, i.e., 2.5- and 97.5-percentile values. The error bounds for 97.5-percentile values of the wave height necessary for harbor tranquility analysis were found to be 0.75 m, 0.5 m, and 1.2 m in Sokcho, Geoje-Hongdo, and Anmado, respectively.
Journal of Korean Society of Coastal and Ocean Engineers | 2012
Dong Hui Ko; Shin Taek Jeong; Hong-Yeon Cho; Jiyoung Kim; Keum Seok Kang
In this paper, error analyses on the calculation of offshore wind speed have been conducted using HeMOSU-1 data to develop offshore wind energy in Yeonggwang sea of Korea and onshore observed wind data in Buan, Gochang and Yeonggwang for 2011. Offshore wind speed data at 98.69 m height above M.S.L is estimated using relational expression induced by linear regression analysis between onshore and offshore wind data. In addition, estimated offshore wind speed data is set at 87.65 m above M.S.L using power law wind profile model with power law exponent(0.115) and its results are compared with the observed data. As a result, the spatial adjustment error are 1.6~2.2 m/s and the altitude adjustment error is approximately 0.1 m/s. This study shows that the altitude adjustment error is about 5% of the spatial adjustment error. Thus, long term observed data are needed when offshore wind speed was estimated by onshore wind speed data. because the conversion of onshore wind data lead to large error.
Journal of Korean Society of Coastal and Ocean Engineers | 2015
Weon Mu Jeong; Kyung-Ho Ryu; Hong-Yeon Cho
Wave data acquired over eleven years near Sokcho Harbor located in the central area of the east coast were analyzed using spectral method and wave-by-wave analysis method and its major wave characteristics were examined. Significant wave heights were found to be high in winter and low in summer, and peak periods were also found to be long in winter and short in summer. The maximum significant wave height observed was 8.95 m caused by the East Sea twister. The distributional pattern of the significant wave heights and peak periods were both fitted better by Kernel distribution function than by Generalized Gamma distribution function and Generalized Extreme Value distribution function. The wave data were compiled to subdivide the wave height into intervals for each month, and the cumulative occurrence rates of wave heights were calculated to be utilized for the design and construction works in nearby construction works.
Journal of Korean Society of Coastal and Ocean Engineers | 2013
Weon-Mu Jeong; Hong-Yeon Cho; Gunwoo Kim
It is estimated and analyzed that the design wave height and the confidence interval (hereafter CI) according to the return period using the fourteen-year wave data obtained at Pusan New Port. The functions used in the extreme value analysis are the Gumbel function, the Weibull function, and the Kernel function. The CI of the estimated wave heights was predicted using one of the Monte-Carlo simulation methods, the Bootstrap method. The analysis results of the estimated CI of the design wave height indicate that over 150 years of data is necessary in order to satisfy an approximately 10% CI. Also, estimating the number of practically possible data to be around 25~50, the allowable error was found to be approximately 16~22% for Type I PDF and 18~24% for Type III PDF. Whereas, the Kernel distribution method, a typical non-parametric method, shows that the CI of the method is below 40% in comparison with the CI of the other methods and the estimated design wave height is 1.2~1.6 m lower than that of the other methods.
Journal of Korean Society of Coastal and Ocean Engineers | 2011
Hong-Yeon Cho; Dong-Hui Ko; Shin-Taek Jeong
The missing data patterns of tidal elevation data in Korean coasts are analysed and provided. The missing interval of the data is displayed for all stations using the missing data indicator matrix in order to identify the overall missing pattern. The spatial and temporal missing rates are also estimated. The total missing rate of tidal elevation data is low. However, most of the missing is mainly derived from just 1 or 2 specific stations. The autocorrelation function of the consecutive missing interval data also shows that the missing interval occurs randomly.
Journal of Korean Society of Coastal and Ocean Engineers | 2016
Shin Taek Jeong; Jong Tae Yoon; Hong-Yeon Cho; Dong Hui Ko; Keum Seok Kang
In designing of the wind power facilities, the highest and lowest astronomical tides (HAT and LAT) are needed in terms of an international design tidal water levels. The AHHW and ALLW, however, have been used as the design tidal levels in Korea. The HAT and LAT in the Wido coastal sea should be estimated to satisfy the standard because the pilot wind power facilities will be located in the adjacent Wido coastal sea. In this study, the HAT and LAT are estimated using the 31-years hourly tidal elevation data of the Wido tidal gauging station and the nodal variation patterns of the major lunar components, such as , , and , are analysed to check the expected long-term lunar cycle, i.e., 18.61-year`s nodal variation patterns. The temporal amplitude variations of the , , and clearly show the 18.61-years periodic patterns in case of the no-nodal correction condition. In addition, the suggested HAT and LAT elevations, estimated as the upper and lower confidence limits of the yearly HAT and LAT elevations, show 40 cm greater than AHHW and 35 cm lower than ALLW, respectively.
International Journal of Naval Architecture and Ocean Engineering | 2015
Jeongrok Kim; Hyuck-Min Kweon; Weon-Mu Jeong; Il-Hyoung Cho; Hong-Yeon Cho
Abstract A new conceptual dual-buoy Wave Energy Converter (WEC) for the enhancement of energy extraction efficiency is suggested. Based on actual wave data, the design process for the suggested WEC is conducted in such a way as to ensure that it is suitable in real sea. Actual wave data measured in Korea’s East Sea (position: 36.404 N° and 129.274 E°) from May 1, 2002 to March 29, 2005 were used as the input wave spectrum for the performance estimation of the dual-buoy WEC. The suggested WEC, a point absorber type, consists of two concentric floating circular cylinders (an inner and a hollow outer buoy). Multiple resonant frequencies in proposed WEC affect the Power Ttake-off (PTO) performance of the WEC. Based on the numerical results, several design strategies are proposed to further enhance the extraction efficiency, including intentional mismatching among the heave natural frequencies of dual buoys, the natural frequency of the internal fluid, and the peak frequency of the input wave spectrum.