Hu Jiansheng

Removal of Particles by ICRF Cleaning in HT-7 Superconducting Tokamak

The ICRF (Ion Cyclotron Range Frequency) cleaning technique has been used as a routine wall cleaning method in the HT-7 superconducting tokamak. In a wide range of toroidal field, the removal rate of residual gas by ICRF cleaning was about twenty times higher than that of glow discharge cleaning (GDC). At different gas pressure and RF power levels, the ICRF cleaning is studied carefully. A good impurity cleaning effect and a very high hydrogen removal rate were obtained. The removal rate of hydrogen by 5 kW ICRF cleaning achieved was 1.6 × 10-5 Torr.l/s. And the relationships among pressure P, outgassing rate Q, atomic layers L absorbed on surface and the cleaning mode were discussed briefly.

Design of the Pumping Stations and the Gas Puffing Systems for the Superconducting Tokamak HT-7U

The design of the pumping stations and the gas injection systems for the inner chamber and the cryostat on HT-7U superconducting tokamak is described in this paper.

First Results of Pellet Injection Experiments on EAST

A new pellet injection system was installed on the EAST tokamak and preliminary experiments were performed during the 2012 run campaign. Typical phenomena associated with deuterium pellet injection into a plasma discharge have been observed including sudden increases of the electron density and Hα/Dα emission intensity as well as a significant decrease in plasma electron temperature. Profiles have been studied in order to understand the influence of pellet fuelling on EAST discharges. Even though the injector was specifically designed for plasma fuelling, ELM triggering using the pellet injection has also been tested. In order to find appropriate parameters for triggering ELMs in H-mode plasmas, scanning of the pellet injection speed was employed for pellets injected from both the high field side and low field side of the plasma column. It has been observed that low-speed pellets injected into H-mode plasma from the low-field side could trigger an ELM followed by a number of smaller induced ELMs at about 300 Hz.

Integrated Behavior of Carbon and Copper Alloy Heat Sink Under Different Heat Loads and Cooling Conditions

An actively water-cooled limiter has been designed for the long pulse operation of an HT-7 device, by adopting an integrated structure-doped graphite and a copper alloy heat sink with a super carbon sheet serving as a compliant layer between them. The behaviors of the integrated structure were evaluated in an electron beam facility under different heat loads and cooling conditions. The surface temperature and bulk temperature distribution were carefully measured by optical pyrometers and thermocouples under a steady state heat flux of 1 to 5 MW/m2 and a water flow rate of 3 m3/h, 4.5 m3/h and 6 m3/h, respectively. It was found that the surface temperature increased rapidly with the heat flux rising, but decreased only slightly with the water flow rate rising. The surface temperature reached approximately 1200°C at 5 MW/m2 of heat flux and 6 m3/h of water flow. The primary experimental results indicate that the integrated design meets the requirements for the heat expelling capacity of the HT-7 device. A set of numerical simulations was also completed, whose outcome was in good accord with the experimental results.