I. Carpinteiro

Determination of fungicides in wine by mixed-mode solid phase extraction and liquid chromatography coupled to tandem mass spectrometry.

A novel procedure for the determination of nine selected fungicides (metalaxyl-M, azoxystrobin, myclobutanil, flusilazole, penconazole, tebuconazole, propiconazole, diniconazole and difenoconazole) in wine samples is presented. Sample enrichment and purification is simultaneously performed using mixed-mode, anion exchange and reversed-phase, OASIS MAX solid-phase extraction (SPE) cartridges. Analytes were determined by liquid chromatography coupled to tandem mass spectrometry using atmospheric pressure electrospray ionization (LC-ESI-MS/MS). Parameters affecting the chromatographic determination and the extraction-purification processes were thoroughly investigated. Under optimized conditions, 10 mL of wine were firstly diluted 1:1 with ultrapure water and then passed through the mixed-mode SPE cartridge at a flow of ca. 5 mLmin(-1). After a washing step with 5 mL of an aqueous NH(4)OH solution (5%, w:v), analytes were recovered with just 1 mL of methanol and injected in the LC-MS/MS system without any additional purification. The selective extraction process avoided significant changes in the ionization efficiency for red and white wine extracts in comparison with pure standards in methanol. Performance of the method was good in terms of precision (RSDs<11%) and accuracy (absolute recoveries>72%, determined against pure standards in methanol) reporting method LOQs in the range of 0.01-0.79 ngmL(-1) for target compounds, which are far below the EU maxima residue levels (MRLs) for fungicides in vinification grapes and wine. Several commercial wines from different geographic areas in Spain were analyzed. In most samples, metalaxyl-M and azoxystrobin were found at concentrations up to several ngmL(-1).

Pressurized solvent extraction followed by gas chromatography tandem mass spectrometry for the determination of benzotriazole light stabilizers in indoor dust

A novel and sensitive method for the determination of five benzotriazole compounds (commonly used as light stabilizers) in indoor dust is presented. Pressurized liquid extraction (PLE) and gas chromatography followed by tandem in time mass spectrometry (GC-MS/MS) were used as sample preparation and determination techniques, respectively. Extraction and clean-up were integrated on-line and, after an evaporative concentration step, the extract provided by the PLE instrument was injected directly in the GC-MS/MS system. Parameters affecting the performance of the sample preparation process were evaluated using experimental factorial designs. Under optimized conditions, analytes were recovered from 0.5g samples in 3 static extraction cycles of 10min, using a hexane:dichloromethane (7:3) mixture, at 90 degrees C. Silica (1g) was placed in the bottom of the extraction cells as clean-up sorbent. The recoveries of the method varied from 82 to 122%, with standard deviations below 13. The inter-day precision ranged from 9 to 12%, and the limits of quantification (LOQs) remained below 10ngg(-1) for all species. For the first time, four of the five investigated species were found in dust from indoor environments. Their mean concentrations ranged from 71 to 780ngg(-1).

Mixed-mode solid-phase extraction followed by dispersive liquid-liquid microextraction for the sensitive determination of ethylphenols in red wines.

Selectivity of mixed-mode solid-phase extraction (SPE) was combined with the concentration power of dispersive liquid-liquid microextraction (DLLME) to obtain a sensitive, low solvent consumption method for gas chromatography-mass spectrometry determination of ethylphenol off-flavours (4-ethylphenol, EP; 4-ethylguaicol, EG and 4-ethylcathecol, EC) in complex red wine samples. Under optimized conditions, limits of quantification (LOQs) between 0.3 and 0.8 ng mL(-1) were obtained using just 5 mL of wine and 0.06 mL of 1,1,1-trichloroethane (TCE) as extractant in the DLLME step. Analytes were acetylated after SPE and previously to DLLME concentration to enhance the performance of their GC-MS determination. The overall extraction efficiency of the method was unaffected by the particular characteristics of each wine; thus, accurate results (relative recoveries from 89 to 109% for samples spiked at concentrations from 20 to 1000 ng mL(-1)) were obtained using matrix-matched standards, without requiring the use of the time consuming standard addition quantification methodology. The applicability of the method was demonstrated with the analysis of different red wines. Analytes concentrations varied from 6 to 2265 ng mL(-1) (EP), 0.8 to 251 ng mL(-1) (EG) and non-detected to 158 ng mL(-1) (EC).

Gas chromatography quadrupole time-of-flight mass spectrometry determination of benzotriazole ultraviolet stabilizers in sludge samples

In this research, a simplified procedure for the selective determination of nine benzotriazole UV stabilizers (BUVSs) in sludge from urban sewage treatment plants is presented. Analytes were extracted from the sample using the matrix solid-phase dispersion (MSPD) technique and further determined by gas chromatography (GC) with quadrupole time-of-flight mass spectrometry (QTOF-MS). Highly selective chromatographic records were attained considering a mass window of 0.005Da, centred in the quantification product ion corresponding to each compound. Moreover, the availability of accurate ion product scan MS/MS spectra permitted to confirm the identities of peaks observed in extracted ion MS/MS chromatograms. As a result, a straightforward sample preparation procedure combining extraction and clean-up in the same step, and consuming just 10mL of ethyl acetate, sufficed to deal with complex sludge samples. The developed method attained limits of quantification (LOQs) between 2ngg(-1) and 10ngg(-1), referred to freeze-dried sludge, and recoveries from 70% to 111%, with standard deviations from 2% to 13%. Analysis of sludge samples and certified reference materials confirmed the existence of residues of eight out of nine BUVSs. UV-326, UV-328 and UV-234 displayed the highest occurrence frequencies and individual concentrations above 100ngg(-1) in several samples.

Sorptive extraction with in-sample acetylation for gas chromatography–mass spectrometry determination of ethylphenol species in wine samples

An inexpensive and effective sample preparation procedure for the determination of three ethylphenolic off-flavours (4-ethylphenol, 4-ethylguaiacol and 4-ethylcathecol) in wine samples is presented. Analytes were in situ acetylated and concentrated using a disposable silicone sorbent (DSS) exposed to the diluted sample. After that, the analytes were recovered with ethyl acetate and determined by gas chromatography with mass spectrometry. The influence of different parameters (volume of acetic anhydride, basic catalyst, ionic strength, sorbent format, sampling mode and extraction time) on the efficiency of derivatization and extraction steps is discussed. Under optimized conditions, 2 mL of wine were diluted with 15 mL of an aqueous solution of potassium bicarbonate (5%, m/v) in a 22 mL vessel, containing 2 g of sodium chloride. The volume of acetic anhydride and the extraction time were set at 90 μL and 2 h, and the extraction was carried out at room temperature (20±2°C). Analytes were concentrated using a silicone disc (5 mm diameter × 0.5 mm thickness) and further desorbed with 0.2 mL of ethyl acetate. The achieved limits of quantification (LOQs), defined as the concentration of each compound providing a signal 10 times higher than the baseline noise, stayed between 5 and 15 ng mL(-1). The method provided a linear response range of up to 5000 ng mL(-1) and relative recoveries from 91% to 116%. The 4-ethylphenol off-flavour was detected in most red wine samples at concentrations of up to 2700 ng mL(-1).

Liquid chromatography time‐of‐flight mass spectrometry evaluation of fungicides reactivity in free chlorine containing water samples

Liquid chromatography (LC) combined with tandem mass spectrometry (MS/MS), based on the use of a hybrid quadrupole-time-of-flight mass analyzer, was used to investigate the reactivity of nine fungicides in free chlorine-containing water samples. Three of the selected compounds (fenhexamid, FEN; pyrimethanil, PYR; and cyprodinil, CYP) displayed a poor stability in presence of moderate chlorine levels; thus, the effects of different parameters on their half-lives (t(1/2)) were evaluated. Sample pH, bromide traces, and the water matrix affected their relative stabilities. Despite such variations, the three fungicides are degraded at significant rates not only in ultrapure, but also in surface water spiked with chlorine levels up to 2 µg ml(-1), and when mixed with chlorinated tap water, generating several transformation products (TPs). The time-course of precursor species and their TPs was followed in the LC-MS mode, using the information contained in accurate, full scan mass spectra (MS) to propose the empirical formulae of TPs. Thereafter, their ion product scan (MS/MS) spectra were considered to set their chemical structures; allowing, in some cases, to distinguish between isomeric TPs. The reaction pathway of FEN, the less stable fungicide, involved just an electrophilic substitution of hydrogen per chlorine, or bromine, and cleavage of the molecule to render an amide. PYR and CYP shared common reaction routes consisting of halogenation, hydroxylation, and condensation processes leading to complex mixtures of TPs, which were relatively stable to further transformations.

Optimization of matrix solid‐phase dispersion conditions for organic fungicides determination in soil samples

A simplified sample preparation method, based on the matrix solid-phase dispersion technique, is proposed for the sensitive determination of 15 organic fungicides in vineyard soils by gas chromatography-mass spectrometry (GC-MS). Under final working conditions, sieved samples (0.5 g) were blended and dispersed with 2 g of C18 and transferred to a polypropylene syringe containing 1 g of diatomaceous earth. Analytes were recovered using 10 mL of ethyl acetate, this extract was concentrated to 1 mL and fungicides determined by GC-MS, without additional cleanup. The method provided recoveries in the range from 74 to 122% for soils with total carbon contents up to 5.5% and it allowed the use of external standard as quantification technique. Inter-day precision, given as relative standard deviations, stayed between 3 and 13%, and the limits of quantification were comprised between 0.6 and 15 ng g(-1). Several fungicides were found in the top layer of vineyard soils with the highest detection frequency and maximum concentration corresponding to iprovalicarb. Some real samples were also submitted to pressurized liquid extraction. Measured concentrations were in excellent agreement with those obtained by matrix solid-phase dispersion, which reinforces the accuracy of the latter methodology.

Free chlorine reactions of angiotensin II receptor antagonists: Kinetics study, transformation products elucidation and in-silico ecotoxicity assessment

Angiotensin II receptor antagonists (ARA II) are widely employed in the treatment of hypertension-related diseases. Because of their partial metabolization and limited biodegradability, these drugs have become ubiquitous pollutants in the aquatic environment, including surface water. This research evaluated the reactivity of the ARA II drugs: irbesartan (IRB), losartan (LOS) telmisartan (TEL) and valsartan (VAL) with free chlorine. Responses of parent compounds and their transformation products (TPs) were followed by liquid chromatography (LC) with quadrupole (Q) time-of-flight (TOF) mass spectrometry. Degradation experiments were carried out using ultrapure and river water samples, adjusted at different pHs and, in some cases, adding a small amount (ng mL-1 level) of bromide salts. Whilst TEL and VAL remained stable in presence of relatively high concentrations of free chlorine (10 mg L-1), IRB and LOS were removed according to a pseudo-first order kinetics model. Considering an initial chlorine concentration of 10 mg L-1, their half-lives varied between 6 and 734 min, depending mostly on the water pH. IRB reacted with free chlorine through hydroxylation processes, with and without molecular cleavage and re-arrangements in the imidazolone ring. Its TPs showed a lower in-silico predicted toxicity than the parent drug. In case of LOS, two major competitive degradation routes were identified. They involved replacement of the methanol group attached to the imidazole cycle by chlorine or bromine, and the cleavage of this cycle with removal of the chlorinated carbon and the nitrogen in alpha position. The TPs generated following the first route are predicted to be more toxic than LOS.