Ignatius K. Lee

Comparison of in vivo Human Dental Plaque pH Changes within Artificial Fissures and at Interproximal Sites

Ion-sensitive field-effect transistor (ISFET) pH electrodes were used to monitor changes in plaque pH at the base of artificial occlusal surface fissures and at interproximal sites. Bovine enamel was used to construct fissures (1.5 x 0.1 x 1.0 mm) containing a small ISFET electrode. The fissures were fixed to carrier appliances and worn by 4 human volunteers. After plaque accumulation for 4 days changes in pH were monitored by wire telemetry following 1-min rinses with 10% solutions of either sorbitol or sucrose. Results were compared to data obtained from interproximal sites in the same subjects. Responses to sorbitol in the fissure and on the proximal surfaces were minimal and showed no significant difference in minimum pH (5.9 +/- 0.4 and 6.1 +/- 0.3, respectively) and area under pH 7.0. The response to sucrose at the two sites was very different revealing unique pH profiles which were statistically significantly different with regard to minimum pH (5.0 +/- 0.3, fissure and 4.3 +/- 0.2, proximal) and area under pH 5.7. Thus, the acidogenic potential of fermentable carbohydrate at two caries-prone sites in the human dentition is significantly different and conclusions based on interproximal telemetry measurements may not be applicable to occlusal surface fissures.

Effect of Chewing Gum Containing Sodium Bicarbonate on Human Interproximal Plaque pH

The effect of chewing sorbitol gum containing sodium bicarbonate on interproximal plaque pH was determined by use of an ion-sensitive field-effect transistor (ISFET) electrode system with four human volunteers. Plaque pH was lowered by 2 min of chewing of a sucrose-containing toffee. After 20 min, either sodium bicarbonate or control gum was chewed for 10 min, and the pH was followed for an additional 20 min. The minimum pH after toffee chewing was elevated by both the control gum (4.5 ± 0.3 to 5.2 ± 0.5) and the sodium-bicarbonate-containing product (4.3 ± 0.3 to 6.1 ± 0.6) to levels which were significantly different (p<0.01). The rate of rise in pH was 2.6 times faster with the gum containing buffer compared with the control gum. In comparison with the control gum, the sodium bicarbonate gum caused the pH to remain at a higher level, approximately 0.5 pH units, for 20 min after gum chewing. The addition of sodium bicarbonate to gum containing sorbitol markedly enhanced its capacity to cause and maintain an elevation of interproximal plaque pH previously lowered by exposure to fermentable carbohydrate. Sodium bicarbonate may be useful in products designed to reduce the acidogenic challenge to the teeth following food ingestion.

Effect of dental plaque age and bacterial composition on the pH of artificial fissures in human volunteers.

Changes in sucrose-induced plaque pH profiles and the microbial composition of occlusal tooth surface fissures were analyzed using wire telemetry and bacterial culturing techniques. Four human volunteers wore appliances containing artificial fissures constructed with ion-sensitive field-effect transistor (ISFET) electrodes for 1, 2 and 4 days; 1 subject kept the electrode for 3 weeks. After monitoring the plaque pH response at the base of the fissure to a 10% (w/v) sucrose rinse the plaque was removed and analyzed for total viable bacteria, total and specific streptococci, lactobacilli and Actinomyces spp. One-day-old plaque showed a rapid drop in plaque pH to a minimum of 4.8 +/- 0.2, with 2-day-old plaque showing the most acidogenic pH profile (minimum pH 4.6 +/- 0.2). The 4-day-old plaque response was less acidogenic (minimum pH 5.0 +/- 0.3) than the results from days 1 and 2. Responses from 13- and 21-day-old fissure plaques showed greatly decreased acidogenic responses (day 21 minimum pH 5.7). Viable bacteria recovered from the fissure increased from approximately 4 x 10(6) colony-forming units on day 1 to 1.2 x 10(7) on days 2 and 4 and 1.7 x 10(7) on day 21. Streptococci (greater than 50%) and Actinomyces (greater than 10%) dominated in the fissure plaques and their levels were related to minimum pH. Since fissure plaque of all ages tested contained high concentrations of acidogenic bacteria, the decreased acidogenic response at the base of fissures with increasing plaque age suggests that maturing fissure plaques provide an increasingly greater diffusion barrier to fermentable carbohydrates.

Immunoglobulins in Milk from Cows Immunized with Oral Strains of Actinomyces, Prevotella, Porphyromonas, and Fusobacterium

Immunization of pregnant cows with bacteria leads to the presence of high concentrations of specific antibodies in colostrum and milk. A total of 14 cows was immunized with single strains of heat-killed oral bacteria or pools of strains of Actinomyces, Porphyromonas, Prevotella, and Fusobacterium. Two cows were treated with adjuvant alone. The mean percentages of IgGl, IgG2, IgM, and IgA in all of the milks were 83.8, 3.8, 9.3, and 3.1, respectively. ELISA and whole cell agglutination assays demonstrated high titers in the milks from the cows immunized with either individual strains or the bacterial pools. The highest titers determined by ELISA belonged to the IgGl isotype and in several milks were 64-fold greater than titers in milk from cows treated with adjuvant alone. The concentrations of all antibodies and the titers determined by ELISA and whole cell agglutination assays markedly decreased from the first to the sixth milkings. The functional specificity of the antibodies was demonstrated by agglutination tests against a wide range of bacteria including members of Actinomyces, Fusobacterium, Porphyromonas, Prevotella, Streptococcus, Eubacterium, Propionibacterium,Peptostreptococcus,Bacteroides,Actinobacillus, Haemophilus, Capnocytophaga, and Wolinella. Minimal cross-reactions with bacteria in other genera were observed with all of the milks. High-titer milk preparations have been obtained from immunized cows, and the capacity of the bovine antibodies to agglutinate target bacteria indicates their potential usefulness in oral passive immunization studies.

The effect of dentin pre-treatment and heat-augmented cure on marginal gap formation of a dentin bonding agent

This study evaluated the effect of enhancing the cure of a DBA and the effect of dentin surface pre-treatment on marginal gap formation. Dentin cavities were prepared on extracted teeth and were pre-treated either with EDTA or phosphoric acid. Marginal leakage was expressed as percent length of margins with gaps. The mean percent length of margins with gaps for the chemically cured groups ranged from a maximum of 97% to a minimum of 85%. For the chemical/thermal-cured group, the mean percent length of margins with gaps was 95%, 95%, 73%, 35%, and 65%, corresponding to the following: pretreatment, no pre-treatment, EDTA, and phosphoric acid for 60, 15, or five s, respectively. SEM micrographs showed partial removal of one smear layer with EDTA and total removal of the smear layers with phosphoric acid. It is concluded that dentin pre-treatment methods have an effect on the percent length of margins with gaps when the DBA used had its cure supplemented with heat.