Injun Jeon

AlN and AlGaN layers grown on Si(111) substrate by mixed-source hydride vapor phase epitaxy method

High Al-composition AlGaN and AlN epilayers were grown directly on Si(111) substrate by a hydride vapor phase epitaxy (HVPE) method with a melted mixed source in a graphite boat set in a source zone with high temperatures of T = 700 and 800 °C, respectively. The presence of the Ga material in the mixed source of Ga and Al promoted the growth of AlN and AlGaN epilayers in the growth zone. When the temperature in the source zone was 800 °C, the crystalline quality of the AlN and AlGaN epilayers increased as the ratio of Ga to Al increased, and the optimum mix ratio of Ga to Al for the growth of AlN epilayers was approximately 0.35–0.42, obtained from a numerical fitting analysis of the X-ray diffraction (XRD) data for these epilayers. It appears that they can be grown directly by our melted-mixed-source HVPE method in a high-temperature source zone.

Fabrication of selective-area growth InGaN LED by mixed-source hydride vapor-phase epitaxy

We prepared InGaN light-emitting diodes (LEDs) with the active layers grown from a mixed source of Ga–In–N materials on an n-type GaN substrate by a selective-area growth method and three fabrication steps: photolithography, epitaxial layer growth, and metallization. The preparation followed a previously developed experimental process using apparatus for mixed-source hydride vapor-phase epitaxy (HVPE), which consisted of a multi-graphite boat, for insulating against the high temperature and to control the growth rate of epilayers, filled with the mixed source on the inside and a radio-frequency (RF) heating coil for heating to a high temperature (T > 900 °C) and for easy control of temperature outside the source zone. Two types of LEDs were prepared, with In compositions of 11.0 and 6.0% in the InGaN active layer, and room-temperature electroluminescence measurements exhibited a main peak corresponding to the In composition at either 420 or 390 nm. The consecutive growth of InGaN LEDs by the mixed-source HVPE method provides a technique for the production of LEDs with a wide range of In compositions in the active layer.