J.-G. Provost

Recent Advances on InAs/InP Quantum Dash Based Semiconductor Lasers and Optical Amplifiers Operating at 1.55

This paper summarizes recent advances on InAs/InP quantum dash (QD) materials for lasers and amplifiers, and QD device performance with particular interest in optical communication. We investigate both InAs/InP dashes in a barrier and dashes in a well (DWELL) heterostructures operating at 1.5 mum. These two types of QDs can provide high gain and low losses. Continuous-wave (CW) room-temperature lasing operation on ground state of cavity length as short as 200 mum has been achieved, demonstrating the high modal gain of the active core. A threshold current density as low as 110 A/cm2 per QD layer has been obtained for infinite-length DWELL laser. An optimized DWELL structure allows achieving of a T0 larger than 100 K for broad-area (BA) lasers, and of 80 K for single-transverse-mode lasers in the temperature range between 25degC and 85degC. Buried ridge stripe (BRS)-type single-mode distributed feedback (DFB) lasers are also demonstrated for the first time, exhibiting a side-mode suppression ratio (SMSR) as high as 45 dB. Such DFB lasers allow the first floor-free 10-Gb/s direct modulation for back-to-back and transmission over 16-km standard optical fiber. In addition, novel results are given on gain, noise, and four-wave mixing of QD-based semiconductor optical amplifiers. Furthermore, we demonstrate that QD Fabry-Perot (FP) lasers, owing to the small confinement factor and the three-dimensional (3-D) quantification of electronic energy levels, exhibit a beating linewidth as narrow as 15 kHz. Such an extremely narrow linewidth, compared to their QW or bulk counterparts, leads to the excellent phase noise and time-jitter characteristics when QD lasers are actively mode-locked. These advances constitute a new step toward the application of QD lasers and amplifiers to the field of optical fiber communications

\mu

The modulation bandwidth has been identified as a specific limitation of quantum-dot or quantum-dash (QDash) lasers for direct modulation application. Solutions using tunnel injection and p-doping have already been demonstrated to increase the modulation bandwidth above 10 GHz, but with complex tunnel injection design and p-doping induced high internal losses. We show in this letter that the use of optimized QDashes and waveguide structure is sufficient to reach such high bandwidth at 1.55 mum. The device is validated by a large signal modulation demonstration at 10 Gb/s.

m

This paper reports on the tolerance of low-dimensional InAs/InP quantum-dash- and quantum-dot-based semiconductor lasers to optical feedback in the 1.55 mum window. For this purpose, the onset of coherence collapse (CC) is experimentally determined and systematically investigated as a function of different laser parameters, such as the injection current, differential gain, temperature, and photon lifetime. It is in particular found that for both material systems the onset of CC increases with the injection current in a similar way to bulk or quantum-well-based devices. Of most importance, we experimentally show that the differential gain plays a key role in the optical feedback tolerance. It is indeed shown to determine not only the range of the onset of CC but also the dependence of this threshold both on the temperature and laser cavity length. Increasing the operating temperature from 25degC to 85degC leads to a decrease of the onset of CC by a factor of only ~3 dB, well accounted for by the variation of the differential gain in this temperature range. We find no difference in the tolerance to external reflections of a truly 3-D confined quantum-dot-based laser and a quantum dash device of the same cavity length, which have similar differential gains. A tentative analysis of our data is finally carried out, based on existing models.

High Bandwidth Operation of Directly Modulated Laser Based on Quantum-Dash InAs–InP Material at 1.55

Among the new semiconductor materials for telecom devices, the GaInNAs-GaAs structure presents interesting properties for low-cost applications, like high differential gain and high T/sub 0/. Another key aspect of the performance is the behavior of the GaInNAs-GaAs based lasers under high bit rate direct modulation. Here, we demonstrate the dynamic capabilities of GaInNAs-GaAs three-quantum-well ridge structure through 2.5-Gb/s directly modulated laser emission and transmission on standard fiber, in the temperature range 25/spl deg/C-85/spl deg/C. Besides transmission is demonstrated up to 10 Gb/s at 25/spl deg/C on the same fiber, without penalty and bit-error-rate floor.

\mu

Tolerance to optical feedback is investigated on quantum-dash-based lasers emitting at 1.51 mum. The onset of coherence collapse regime is experimentally determined using three criteria: optical spectrum broadening, relative intensity noise increase, and bit-error-rate degradation. Measurements were first performed in static operation at different current values, using the first and second criteria. The onset of coherence collapse was found to increase from ~-41 to -27 dB with the bias current. Then tolerance to optical feedback was assessed in dynamic operation at 10 Gb/s, using the third criterion. In spite of a relatively high linewidth enhancement factor , (alphaH ~4.5) a -32-dB onset of coherence collapse corresponding to -24-dB maximum optical return loss tolerance was achieved at 10-Gb/s rate.

m

By enhancing excitonic absorption in a new design of a polarization independent EA modulator, a 50 nm flat absorption spectrum, 42 GHz bandwidth devices together with 14-30 dB/V modulation sensitivity are obtained for 75 /spl mu/m long devices.

Optical Feedback Tolerance of Quantum-Dot- and Quantum-Dash-Based Semiconductor Lasers Operating at 1.55

The temperature dependence of microwave properties—relaxation frequency and Henry factor—of undoped and p-type doped ten InAs∕GaAs quantum-dot layer lasers is reported in the 20–80°C range. It is shown that the linewidth enhancement factor of the p-type doped devices is temperature insensitive while that of the undoped lasers shows a strong dependence for temperatures above 40°C.

\mu

For high speed remote colorless modulation in FTTH technology, a new 10Gbit/s monolithically integrated amplified reflective electroabsorption modulator (R-EAM-SOA) is demonstrated over 50nm spectral range and over 20°C-60°C, with excellent eye diagrams.

m

Electrical spectrum line-width is reduced in mode-locked FP 1.55 μm-QD laser diode through optical confinement factor optimization. From optimized structures, we obtained nearly Fourier-transform limited pulses at 10 GHz, with an averaged width of 8 ps over 10 nm.

Floor free 10-Gb/s transmission with directly modulated GaInNAs-GaAs 1.35-/spl mu/m laser for metropolitan applications

Compact parallel transmitters and receivers with an aggregate capacity of 107 Gb/s are built through hybrid integration of arrays of ten 100-GHz spaced directly modulated lasers, arrays of ten avalanche photodiodes, and high-index contrast silica arrayed waveguide grating multi- and demultiplexers. Unamplified transmission over 75 km of standard single-mode fiber and 155-km amplified links is demonstrated in the C-band, by using a modulation format based on spectral offset filtering and electronic dispersion compensation.