James Colless

Dispersive readout of a few-electron double quantum dot with fast RF gate sensors.

We report the dispersive charge-state readout of a double quantum dot in the few-electron regime using the in situ gate electrodes as sensitive detectors. We benchmark this gate sensing technique against the well established quantum point contact charge detector and find comparable performance with a bandwidth of ∼ 10 MHz and an equivalent charge sensitivity of ∼ 6.3 × 10(-3) e/sqrt[Hz]. Dispersive gate sensing alleviates the burden of separate charge detectors for quantum dot systems and promises to enable readout of qubits in scaled-up arrays.

Cryogenic Control Architecture for Large-Scale Quantum Computing

Solid-state qubits have recently advanced to the level that enables them, in-principle, to be scaled-up into fault-tolerant quantum computers. As these physical qubits continue to advance, meeting the challenge of realising a quantum machine will also require the engineering of new classical hardware and control architectures with complexity far beyond the systems used in todays few-qubit experiments. Here, we report a micro-architecture for controlling and reading out qubits during the execution of a quantum algorithm such as an error correcting code. We demonstrate the basic principles of this architecture in a configuration that distributes components of the control system across different temperature stages of a dilution refrigerator, as determined by the available cooling power. The combined setup includes a cryogenic field-programmable gate array (FPGA) controlling a switching matrix at 20 millikelvin which, in turn, manipulates a semiconductor qubit.

Frequency multiplexing for readout of spin qubits

We demonstrate a low loss, chip-level frequency multiplexing scheme for readout of scaled-up spin qubit devices. By integrating separate bias tees and resonator circuits on-chip for each readout channel, we realise dispersive gate-sensing in combination with charge detection based on two radio frequency quantum point contacts. We apply this approach to perform multiplexed readout of a double quantum dot in the few-electron regime and further demonstrate operation of a 10-channel multiplexing device. Limitations for scaling spin qubit readout to large numbers of multiplexed channels are discussed.

On-Chip Microwave Quantum Hall Circulator

Circulators are non-reciprocal circuit elements integral to technologies including radar systems, microwave communication transceivers, and the readout of quantum information devices. Their non-reciprocity arises from the interference of microwaves over the centimetre-scale of the signal wavelength in the presence of bulky magnetic media that break time-reversal symmetry. Here we realize a completely passive on-chip microwave circulator with size one-thousandth the wavelength by exploiting the chiral, slow-light response of a 2-dimensional electron gas (2DEG) in the quantum Hall regime. For an integrated GaAs device with 330 um diameter and 1 GHz centre frequency, a non-reciprocity of 25 dB is observed over a 50 MHz bandwidth. Furthermore, the direction of circulation can be selected dynamically by varying the magnetic field, an aspect that may enable reconfigurable passive routing of microwave signals on-chip.

Cryogenic high-frequency readout and control platform for spin qubits

We have developed a cryogenic platform for the control and readout of spin qubits that comprises a high density of dc and radio frequency sample interconnects based on a set of coupled printed circuit boards. The modular setup incorporates 24 filtered dc lines, 14 control and readout lines with bandwidth from dc to above 6 GHz, and 2 microwave connections for excitation to 40 GHz. We report the performance of this platform, including signal integrity and crosstalk measurements and discuss design criteria for constructing sample interconnect technology needed for multi-qubit devices.

Suppressing on-chip electromagnetic crosstalk for spin qubit devices

We report the development and performance of on-chip interconnects designed to suppress electromagnetic crosstalk in spin qubit device architectures with the large number of gate electrodes needed for multi-qubit operation. Our design improves the performance of typical device interconnects via the use of miniaturised ohmic contacts and interspersed ground guards. Low-temperature measurements and numerical simulation confirm that control and readout signal crosstalk can be suppressed to levels of order 1%, from dc to 1 GHz.

Raman phonon emission in a driven double quantum dot

The compound semiconductor gallium-arsenide (GaAs) provides an ultra-clean platform for storing and manipulating quantum information, encoded in the charge or spin states of electrons confined in nanostructures. The absence of inversion symmetry in the zinc-blende crystal structure of GaAs however, results in a strong piezoelectric interaction between lattice acoustic phonons and qubit states with an electric dipole, a potential source of decoherence during charge-sensitive operations. Here we report phonon generation in a GaAs double quantum dot, configured as a single- or two-electron charge qubit, and driven by the application of microwaves via surface gates. In a process that is a microwave analogue of the Raman effect, phonon emission produces population inversion of the two-level system and leads to rapid decoherence of the qubit when the microwave energy exceeds the level splitting. Comparing data with a theoretical model suggests that phonon emission is a sensitive function of the device geometry.

Zero-field edge plasmons in a magnetic topological insulator

Incorporating ferromagnetic dopants into three-dimensional topological insulator thin films has recently led to the realisation of the quantum anomalous Hall effect. These materials are of great interest since they may support electrical currents that flow without resistance, even at zero magnetic field. To date, the quantum anomalous Hall effect has been investigated using low-frequency transport measurements. However, transport results can be difficult to interpret due to the presence of parallel conductive paths, or because additional non-chiral edge channels may exist. Here we move beyond transport measurements by probing the microwave response of a magnetised disk of Cr-(Bi,Sb)2Te3. We identify features associated with chiral edge plasmons, a signature that robust edge channels are intrinsic to this material system. Our results provide a measure of the velocity of edge excitations without contacting the sample, and pave the way for an on-chip circuit element of practical importance: the zero-field microwave circulator.Direct measurement of edge transport in the quantum anomalous Hall effect can be made difficult due to the presence of parallel conductive paths. Here, Mahoney et al. report features associated with chiral edge plasmons, a signature of robust edge states, by probing the zero-field microwave response of a magnetised disk of Cr-(Bi,Sb)2Te3.