Jangho Kim

Bioactive effects of graphene oxide cell culture substratum on structure and function of human adipose‐derived stem cells

Nanoscale topography of artificial substrates can greatly influence the fate of stem cells including adhesion, proliferation, and differentiation. Thus the design and manipulation of nanoscale stem cell culture platforms or scaffolds are of great importance as a strategy in stem cell and tissue engineering applications. In this report, we propose that a graphene oxide (GO) film is an efficient platform for modulating structure and function of human adipose-derived stem cells (hASCs). Using a self-assembly method, we successfully coated GO on glass for fabricating GO films. The hASCs grown on the GO films showed increased adhesion, indicated by a large number of focal adhesions, and higher correlation between the orientations of actin filaments and vinculin bands compared to hASCs grown on the glass (uncoated GO substrate). It was also found that the GO films showed the stronger affinity for hASCs than the glass. In addition, the GO film proved to be a suitable environment for the time-dependent viability of hASCs. The enhanced differentiation of hASCs included osteogenesis, adipogenesis, and epithelial genesis, while chondrogenic differentiation of hASCs was decreased, compared to tissue culture polystyrene as a control substrate. The data obtained here collectively demonstrates that the GO film is an efficient substratum for the adhesion, proliferation, and differentiation of hASCs.

Graphene-incorporated chitosan substrata for adhesion and differentiation of human mesenchymal stem cells†

A simple method that uses graphene to fabricate nanotopographic substrata was reported for stem cell engineering. Graphene-incorporated chitosan substrata promoted adhesion and differentiation of human mesenchymal stem cells (hMSCs). In addition, we proposed that nanotopographic cues of the substrata could enhance cell-cell and cell-material interactions for promoting functions of hMSCs.

Graphene-Regulated Cardiomyogenic Differentiation Process of Mesenchymal Stem Cells by Enhancing the Expression of Extracellular Matrix Proteins and Cell Signaling Molecules

The potential of graphene as a mesenchymal stem cell (MSC) culture substrate to promote cardiomyogenic differentiation is demonstrated. Graphene exhibits no sign of cytotoxicity for stem cell culture. MSCs are committed toward cardiomyogenic lineage by simply culturing them on graphene. This may be attributed, at least partially, to the regulation of expression levels of extracellular matrix and signaling molecules.

Designing nanotopographical density of extracellular matrix for controlled morphology and function of human mesenchymal stem cells

Inspired by ultrastructural analysis of ex vivo human tissues as well as the physiological importance of structural density, we fabricated nanogrooves with 1:1, 1:3, and 1:5 spacing ratio (width:spacing, width = 550 nm). In response to the nanotopographical density, the adhesion, migration, and differentiation of human mesenchymal stem cells (hMSCs) were sensitively controlled, but the proliferation showed no significant difference. In particular, the osteo- or neurogenesis of hMSCs were enhanced at the 1:3 spacing ratio rather than 1:1 or 1:5 spacing ratio, implying an existence of potentially optimized nanotopographical density for stem cell function. Furthermore, such cellular behaviors were positively correlated with several cell morphological indexes as well as the expression of integrin β1 or N-cadherin. Our findings propose that nanotopographical density may be a key parameter for the design and manipulation of functional scaffolds for stem cell-based tissue engineering and regenerative medicine.

Synergistic effects of nanotopography and co-culture with endothelial cells on osteogenesis of mesenchymal stem cells.

Inspired by the aligned nanostructures and co-existence of vascular cells and stem cells in human cancellous bone, we quantitatively investigated the relative contributions of nanotopography and co-culture with human umbilical endothelial cells (HUVECs) to the osteogenesis of human mesenchymal stem cells (hMSCs). Although both nanotopography and co-culture independently enhanced the osteogenesis of hMSCs, osteogenesis was further enhanced by the two factors in combination, indicating the importance of synergistic cues in stem cell engineering. Interestingly, nanotopography provided a larger relative contribution to the osteogenesis of hMSCs than did co-culture with HUVECs. Furthermore, the osteogenesis of hMSCs was also affected by the density of parallel nanogrooves, exhibiting a maximum at a 1:3 spacing ratio, as defined as the ratio of ridge width to groove width. Analysis of (i) biochemical soluble factors, (ii) hMSC-substrate interaction and (iii) hMSC-HUVEC interaction suggests that (ii) and (iii) play a crucial role in mediating osteogenic phenotypes.

In Vitro Effects of Low-Intensity Pulsed Ultrasound Stimulation on the Osteogenic Differentiation of Human Alveolar Bone-Derived Mesenchymal Stem Cells for Tooth Tissue Engineering

Ultrasound stimulation produces significant multifunctional effects that are directly relevant to alveolar bone formation, which is necessary for periodontal healing and regeneration. We focused to find out effects of specific duty cycles and the percentage of time that ultrasound is being generated over one on/off pulse period, under ultrasound stimulation. Low-intensity pulsed ultrasound ((LIPUS) 1 MHz) with duty cycles of 20% and 50% was used in this study, and human alveolar bone-derived mesenchymal stem cells (hABMSCs) were treated with an intensity of 50 mW/cm2 and exposure time of 10 min/day. hABMSCs exposed at duty cycles of 20% and 50% had similar cell viability (O.D.), which was higher (*P < 0.05) than that of control cells. The alkaline phosphatase (ALP) was significantly enhanced at 1 week with LIPUS treatment in osteogenic cultures as compared to control. Gene expressions showed significantly higher expression levels of CD29, CD44, COL1, and OCN in the hABMSCs under LIPUS treatment when compared to control after two weeks of treatment. The effects were partially controlled by LIPUS treatment, indicating that modulation of osteogenesis in hABMSCs was related to the specific stimulation. Furthermore, mineralized nodule formation was markedly increased after LIPUS treatment than that seen in untreated cells. Through simple staining methods such as Alizarin red and von Kossa staining, calcium deposits generated their highest levels at about 3 weeks. These results suggest that LIPUS could enhance the cell viability and osteogenic differentiation of hABMSCs, and could be part of effective treatment methods for clinical applications.

Development of water‐insoluble chitosan patch scaffold to repair traumatic tympanic membrane perforations

Perforated tympanic membranes (TM) and otitis media can be managed with a paper patch or tympanoplasty. However, a paper patch is not biocompatible and tympanoplasty requires complex aseptic surgical procedures. A novel biocompatible patch with a water-insoluble chitosan as the main component was prepared. Optimal mechanical characteristics of a water-insoluble chitosan patch scaffold (CPS) was approximately 40 microm in thickness, 7 MPa in tensile strength, and 107% in percent elongation, even though the characteristics varied significantly depending on the concentrations of chitosan and glycerol. SEM of the CPSs showed a very smooth surface as compared with that of the paper patches. These CPSs showed no cytotoxicity and had a stimulating effect on the proliferation of TM cells in in vitro study. In in vivo study, 4 (21.1%) and 17 (89.5%) TMs out of 19 adult rats with CPSs showed no perforations at 1 and 2 weeks, respectively. However, left control TMs showed healing of 0 (0%) at 1 week and 18 (94.7%) at 2 weeks. TEM findings of regenerated eardrums using CPSs showed thinner, smoother, and more compact tissues than spontaneously healed eardrums. A CPS was more effective than spontaneous healing to repair traumatic TM perforations.

Effects of Electromagnetic Fields on Osteogenesis of Human Alveolar Bone-Derived Mesenchymal Stem Cells

This study was performed to investigate the effects of extremely low frequency pulsed electromagnetic fields (ELF-PEMFs) on the proliferation and differentiation of human alveolar bone-derived mesenchymal stem cells (hABMSCs). Osteogenesis is a complex series of events involving the differentiation of mesenchymal stem cells to generate new bone. In this study, we examined not merely the effect of ELF-PEMFs on cell proliferation, alkaline phosphatase (ALP) activity, and mineralization of the extracellular matrix but vinculin, vimentin, and calmodulin (CaM) expressions in hABMSCs during osteogenic differentiation. Exposure of hABMSCs to ELF-PEMFs increased proliferation by 15% compared to untreated cells at day 5. In addition, exposure to ELF-PEMFs significantly increased ALP expression during the early stages of osteogenesis and substantially enhanced mineralization near the midpoint of osteogenesis within 2 weeks. ELF-PEMFs also increased vinculin, vimentin, and CaM expressions, compared to control. In particular, CaM indicated that ELF-PEMFs significantly altered the expression of osteogenesis-related genes. The results indicated that ELF-PEMFs could enhance early cell proliferation in hABMSCs-mediated osteogenesis and accelerate the osteogenesis.

Enhanced Osteogenesis of Human Alveolar Bone-Derived Mesenchymal Stem Cells for Tooth Tissue Engineering Using Fluid Shear Stress in a Rocking Culture Method

This study instituted a simple approach to stimulate alveolar bone regeneration for tooth tissue engineering by controlling effects of low fluid dynamic shear stress (LFDSS) on growth and differentiation in vitro. Human alveolar bone-derived mesenchymal stem cells (hABMSCs) harvested from human mandibular alveolar bone were cultured with LFDSS to generate cultures containing bone-like formations. To distinguish between osteodifferentiation and bone-like formation, cells were cultured either with or without fluid shear stress. The calcium content and alkaline phosphatase (ALP) activity of hABMSCs were used as indicators of osteogenesis. Cell viability and proliferation after stimulating with LFDSS for 10-60 min/day were higher than with longer stimulations. Mineralized nodules formed when osteoblasts were cultured with an induction medium, a marker of osteogenic differentiation. ALP activity tended to increase after 10 and 60 min/day of stimulation. In addition, LFDSS conditions also increased gene expression of IBSP, RUNX2, COL-I, ALP, OCN, and OPN, as shown by reverse transcriptase-polymerase chain reaction. From the results of a proteomics array, LFDSS groups were intensely expressed with several factors (EGF, HGF, IGF, TGF, and PDGF). Furthermore, CD146 and Stro-1 expression increased in cells treated with 30 min/day and decreased in cells treated with 120 min/day, as determined by cell surface antigen analysis by fluorescence-activated cell-sorting analysis. These results strongly showed that LFDSS at the proper intensity and time enhanced the differentiation and maturation of hABMSCs. In conclusion, an appropriate level of LFDSS can potently and positively modulate proliferation and differentiation in hABMSCs.

Bio-inspired configurable multiscale extracellular matrix-like structures for functional alignment and guided orientation of cells.

Inspired by the hierarchically organized protein fibers in extracellular matrix (ECM) as well as the physiological importance of multiscale topography, we developed a simple but robust method for the design and manipulation of precisely controllable multiscale hierarchical structures using capillary force lithography in combination with an original wrinkling technique. In this study, based on our proposed fabrication technology, we approached a conceptual platform that can mimic the hierarchically multiscale topographical and orientation cues of the ECM for controlling cell structure and function. We patterned the polyurethane acrylate-based nanotopography with various orientations on the microgrooves, which could provide multiscale topography signals of ECM to control single and multicellular morphology and orientation with precision. Using our platforms, we found that the structures and orientations of fibroblast cells were greatly influenced by the nanotopography, rather than the microtopography. We also proposed a new approach that enables the generation of native ECM having nanofibers in specific three-dimensional (3D) configurations by culturing fibroblast cells on the multiscale substrata. We suggest that our methodology could be used as efficient strategies for the design and manipulation of various functional platforms, including well-defined 3D tissue structures for advanced regenerative medicine applications.