Jeng-Yuan Yang

Theoretical and Experimental Investigations of Direct-Detected RF-Tone-Assisted Optical OFDM Systems

In this paper, we propose and experimentally demonstrate a radio frequency (RF)-tone-assisted optical orthogonal frequency-division multiplexing (OFDM) transmission. By inserting an RF tone at the edge of the signal band and biasing the Mach-Zehnder modulator (MZM) at the null point, the proposed system has a better sensitivity and chromatic dispersion (CD) tolerance compared to the previous intensity-modulated single-sideband OFDM (SSB-OFDM). We show analytically that the majority of the linear channel impairments, such as the transmitter, CD, optical filtering, and receiver, can be compensated for by a simple zero-forcing equalizer. Besides, the optimum value of the important parameter, carrier-to-signal-power ratio (CSPR), is analytically obtained and supported via the experimental results. We also observe that the relatively worse sensitivity of the previous SSB-OFDM can be attributed to the limited CSPR. We experimentally demonstrate a 10-Gb/s, 8 quadrature-amplitude modulation (QAM) RF-tone-assisted OFDM transmission, and show that our system has a ~ 5-dB better sensitivity compared to the previous intensity-modulated SSB-OFDM and exhibits a negligible transmission penalty after 260-km uncompensated standard single-mode fiber (SSMF).

Microring-based modulation and demodulation of DPSK signal.

Ultra-small modulator and demodulator for 10 Gb/s differential phase-shift-keying (DPSK), using silicon-based microrings, are proposed. A single-waveguide microring modulator with over-coupling between ring and waveguide generates a DPSK signal, while a double-waveguide microring filter enables balanced DPSK detection. These modulator and demodulator are characterized. A trade-off between pattern dependence of the Duobinary signal and alternate-mark inversion signal power in demodulator design is discussed. Power penalty of the proposed approach is 0.8 dB relative to baseline using conventional modulation and demodulation techniques.

Silicon-Based Microring Resonator Modulators for Intensity Modulation

We numerically analyze the characteristics of silicon-based microring modulators consisting of a single-ring resonator. Performance of the devices as digital intensity modulators is examined in terms of extinction ratio, pulsewidth, frequency chirp, spectral broadening, and signal quality. Three types of the modulators built in single-waveguide under-/overcoupling and dual-waveguide configurations are discussed. We show that cavity dynamics significantly affect the modulation properties. Data transmission performance over single-mode fibers is also presented. A silicon microring modulator with negative chirp could achieve 0.8 dB power penalty in 80-km fiber transmission without dispersion compensation.

Spectrally efficient direct-detected OFDM transmission employing an iterative estimation and cancellation technique.

We demonstrate a linearly field-modulated, direct-detected virtual SSB-OFDM (VSSB-OFDM) transmission with an RF tone placed at the edge of the signal band. By employing the iterative estimation and cancellation technique for the signal-signal beat interference (SSBI) at the receiver, our approach alleviates the need of the frequency gap, which is typically reserved for isolating the SSBI, and saves half the electrical bandwidth, thus being very spectrally efficient. We derive the theoretical model for the VSSB-OFDM system and detail the signal processing for the iterative approach conducted at the receiver. Possible limitations for this iterative approach are also given and discussed. We successfully transmit a 10 Gbps, 4-quadrature-amplitude-modulation (QAM) VSSB-OFDM signal through 340 km of uncompensated standard single mode fiber (SSMF) with almost no penalty. In addition, the simulated results show that the proposed scheme has an approximately 2 dB optical-signal-to-noise-ratio (OSNR) gain and has a better chromatic dispersion (CD) tolerance compared with the previous intensity-modulated SSB-OFDM system.

Silicon-on-insulator polarization splitter using two horizontally slotted waveguides

We propose and analyze a short-length silicon-on-insulator polarization splitter using two horizontally slotted silicon waveguides. A polarization splitter with a 46.7 microm length and a 22 dB extinction ratio (ER) is achieved. Around 1550 nm, it also exhibits an 18 nm bandwidth for ER>20 dB. The effects of the slot thickness, the waveguide spacing, and the refractive index of the slot on the splitting length and ER are investigated.

Independent and Simultaneous Monitoring of Chromatic and Polarization-Mode Dispersion in OOK and DPSK Transmission

We propose and demonstrate a novel technique for a simultaneous chromatic and first-order polarization-mode-dispersion (PMD) monitoring method using a partial bit delay Mach-Zehnder interferometer (MZI) with radio-frequency (RF) clock tone monitoring. RF clock tones at the output of the two branches of the MZI behave oppositely with increasing chromatic dispersion (CD) which improves the sensitivity of the measurement. The technique increases CD monitoring sensitivity over standard clock tone methods by a factor of two for a nonreturn-to-zero intensity modulation format and a factor of five for a differential-phase-shift-keying modulation format. The accuracy of PMD monitoring is also enhanced. Moreover, the partial bit delay allows the signal to pass through the constructive branch of the MZI with no observable degradation of the signal quality, allowing it to be normally detected by a receiver

Coupled-ring-resonator-based silicon modulator for enhanced performance.

A compact silicon coupled-ring modulator structure is proposed. Two rings are coupled to each other, and only one of these rings is actively driven and over-coupled to a waveguide, which enables high modulation speed. The resultant notch filter profile is steeper than that of the single ring and has exhibited a smaller resonance shift and lower driving electrical power. Simulation results include: (i) potentially 60-Gb/s non-return-to-zero (NRZ) data modulation and over 20-dB extinction ratio can be achieved by shifting the active ring by a 20 GHz resonance shift, (ii) the frequency chirp of the modulated signals can be adjusted by varying the coupling coefficient between the two rings, and (iii) dispersion tolerance at 0.5-dB power penalty is extended from 18 to 85 ps/nm, for a 40-Gb/s NRZ signal.

Fiber structure to convert a Gaussian beam to higher-order optical orbital angular momentum modes

We propose a fiber structure of a square core and ring refractive index profile that converts an input circular polarized Gaussian mode into optical orbital angular momentum (OAM) modes. By breaking the circular symmetry of the waveguide, the input circularly polarized fundamental mode in the square core can be coupled into the ring region to generate higher-order OAM modes, corresponding to the transference of spin angular momentum and orbital angular momentum. We show, by using simulation, the generation of OAM modes with a topological charge l up to 9 using <10 mm long fiber. The mode purity is above 96.4% and the extinction ratio can be 30 dB.

Continuously-tunable, bit-rate variable OTDM using broadband SBS slow-light delay line

We conceptually compare the advantages of the proposed slow-light-based tunable OTDM to conventional fiber-based fixed OTDM multiplexer. We experimentally demonstrate continuously-controllable OTDM of two 2.5-Gb/s return-to-zero (RZ) signals using broadband SBS-based slow-light as the tunable optical delay line. We show that the time slot of one signal path can be manipulated relative to the other by as much as 75-ps. This continuous slow light tunability dramatically enhances the OTDM system performance which results in a power penalty reduction of 9-dB for the multiplexed data stream. We also demonstrate variable-bit-rate OTDM by dynamically adjusting the tunable slow-light delay according to the input bit-rates. We show efficient two-by-one optical time multiplexing of three different input data streams at 2.5-Gb/s, 2.67-Gb/s and 5-Gb/s.

Fiber coupler for generating orbital angular momentum modes

We propose a fiber coupler consisting of a central ring and four external cores to generate up to ten orbital angular momentum (OAM) modes. Four coherent input lights are launched into the external cores and then coupled into the central ring waveguide to generate OAM modes. By changing the size of the external cores, one can selectively excite a high-order OAM mode. The quality of the generated OAM modes can be enhanced by adjusting the polarization state and the phase of input lights. We show the generation of OAM modes with odd charge numbers of -9 to +9 (i.e., 10 modes totally) with mode purity of >99% using <2 mm long fiber. This fiber coupler design can be extended to enable all-fiber spatial-mode (de)multiplexing.