Jindan Shi

All-Optical Logic Gate for XOR Operation Between 40-Gbaud QPSK Tributaries in an Ultra-Short Silicon Nanowire

We demonstrate an all-optical XOR logic gate for 40-Gbaud quadrature phase-shift keying (QPSK) tributaries in a silicon nanowire for the first time. The XOR logic operation is realized based on four-wave mixing (FWM) in the C-band. Experimental results show negligible power penalty at a bit error ratio (BER) of 10-6 compared with the back-to-back signals. The BER floor appears at BER of 10-6 for both I and Q tributaries of the logic operation, and the main reasons are the optical signal-to-noise ratio (OSNR) deterioration caused by nonlinear loss due to free carrier absorption (FCA) and two-photon absorption (TPA) and the cross-phase modulation (XPM)-induced phase impairments.

Highly efficient Raman distributed feedback fibre lasers

We demonstrate highly efficient Raman distributed feedback (DFB) fibre lasers for the first time with up to 1.6 W of continuous wave (CW) output power. The DFB Bragg gratings are written directly into two types of commercially available passive germano-silica fibres. Two lasers of 30 cm length are pumped with up to 15 W of CW power at 1068 nm. The threshold power is ~2 W for a Raman-DFB (R-DFB) laser written in standard low-NA fibre, and only ~1 W for a laser written in a high-NA fibre, both of which oscillate in a narrow linewidth of <0.01 nm at ~1117 nm and ~1109 nm, respectively. The slope efficiencies are ~74% and ~93% with respect to absorbed pump power in the low-NA fibre and high-NA fibre respectively. Such high conversion efficiency suggests that very little energy is lost in the form of heat through inefficient energy transfer. Our results are supported by numerical simulations, and furthermore open up for the possibility of having narrow linewidth all-fibre laser sources in wavelength bands not traditionally covered by rare-earth doped silica fibres. Simulations also imply that this technology has the potential to produce even shorter R-DFB laser devices at the centimetre-level and with mW-level thresholds, if Bragg gratings formed in fibre materials with higher intrinsic Raman gain coefficient than silica are used. These materials include for example tellurite or chalcogenide glasses. Using glasses like these would also open up the possibility of having narrow linewidth fibre sources with DFB laser oscillating much further into the IR than what currently is possible with rare-earth doped silica glasses.

Sub-watt threshold, kilohertz-linewidth Raman distributed-feedback fiber laser

We report a low-threshold, narrow linewidth Raman distributed-feedback (R-DFB) fiber laser at 1109.54 nm based on a 30 cm long center π phase-shifted Bragg grating written directly in a commercially available germano-silica (Ge/Si) fiber. The R-DFB was pumped by a continuous-wave (CW) linearly polarized fiber source at 1064 nm, and the threshold power, full width at half-maximum (FWHM) linewidth and slope efficiency with respect to the incident pump power are measured to be 440 mW, <2.5  kHz (measured with a 29.75 km fiber delay line) and 13.5%, respectively. An rf spectrum analyzer confirms that the R-DFB fiber laser exhibits single-frequency performance.

1.06

We investigate efficient broadband infrared supercontinuum generation in meter-length single-mode small-core tellurite holey fiber. The fiber is pumped by 1.06 μm picosecond pulses in the normal dispersion region. The high Raman gain coefficient and the broad Raman gain bands of the tellurite glass are exploited to generate a cascade of Raman Stokes orders, which initiate in the highly normal dispersion region and quickly extend to longer wavelengths across the zero dispersion wavelength with increasing pump power. A broadband supercontinuum from 1.06 μm to beyond 1.70 μm is generated. The effects of the pump power and of the fiber length on the spectrum and on the power conversion efficiency from the pump to the supercontinuum are discussed. Power scaling indicates that using this viable normal dispersion pumping scheme, 9.5 W average output power of infrared supercontinuum and more than 60% conversion efficiency can be obtained from a 1 m long tellurite fiber with a large mode area of 500 μm2 .

\mu

We report the fabrication of new dehydrated halo-tellurite glass fibers with low OH content (1ppm in weight) and low OH-induced attenuation of 10dB/m in 3-4 µm region. It shows halo-tellurite glass fibers a promising candidate for nonlinear applications in 2-5µm region.

m Picosecond Pulsed, Normal Dispersion Pumping for Generating Efficient Broadband Infrared Supercontinuum in Meter-Length Single-Mode Tellurite Holey Fiber With High Raman Gain Coefficient

We experimentally demonstrate phase-sensitive amplification in a highly nonlinear lead-silicate W-type fibre. A phase-sensitive gain swing of 6dB was observed in a 1.56m sample of the fibre for a total launched power of 33dBm.

Halo-tellurite glass fiber with low OH content for 2-5µm mid-infrared nonlinear applications

We experimentally demonstrate phase regeneration of a 40-Gb/s differential phase shift keying (DPSK) signal in a 1.7-m long highly nonlinear lead silicate W-type fiber using a degenerate two-pump phase-sensitive amplifier (PSA). Results show an improvement in the Error Vector Magnitude (EVM) and a reduction of almost a factor of 2 in the phase noise of the signal after regeneration for various noise levels at the input.

Phase sensitive amplification in a highly nonlinear lead-silicate fibre

We both experimentally and numerically studied the ultra-compact wavelength conversion by using the four-wave mixing (FWM) process in Raman distributed-feedback (R-DFB) fiber lasers. The R-DFB fiber laser is formed in a 30 cm-long commercially available Ge/Si standard optical fiber. The internal generated R-DFB signal acts as the pump wave for the FWM process and is in the normal dispersion range of the fiber. Utilizing a tunable laser source as a probe wave, FWM frequency conversion up to ~40 THz has been demonstrated with conversion efficiency > -40 dB. The principle of such a wide bandwidth and high conversion efficiency in such a short R-DFB cavity has been theoretically analyzed. The simulation results match well with the experimental data.

Phase regeneration of DPSK signals in a highly nonlinear lead-silicate W-type fiber

We report ultrawide-range and highly efficient wavelength conversion by exploiting four-wave mixing (FWM) in Raman distributed-feedback (R-DFB) fiber lasers. The lasers are 30 cm long center π phase-shifted DFB gratings UV written in commercially available germano-silica (Ge/Si) single-mode fibers (PS980 from Fibercore Ltd., and UHNA4 from Nufern). The R-DFB lasing signal acts as a pump wave for the FWM process within the DFB cavity, and the obtained FWM conversion efficiency is around -25 dB with a maximum wavelength conversion range of 112 nm.

Detailed study of four-wave mixing in Raman DFB fiber lasers.

We report on the first fabrication of a glass fiber based laser-induced crystalline waveguide. The glass and crystal are based on the stoichiometric composition of (La,Yb)BGeO(5). A laser induced waveguide has been fabricated on the surface of a ribbon glass fiber using milliwatt-level continuous wave UV laser radiation at a fast scanning speed. Evidence of crystallinity in the created structure was observed using micro-Raman spectroscopy and scanning electron microscopy. Preliminary investigations on the waveguiding behavior and the nonlinear performance in the crystalline waveguide are reported.