Jingjie Shen

Effects of alloying elements (Sn, Nb, Cr, and Mo) on the microstructure and mechanical properties of zirconium alloys

The alloying effects of Sn, Nb, Cr, and Mo on zirconium alloys were elucidated and compared. Electron backscatter diffraction, transmission electron microscopy, tensile test, and fractographic observation were jointly utilized to carry out detailed microstructural characterization and mechanical property evaluation. Results show that Mo is the most effective among these elements from the viewpoints of strengthening and reducing grain size. The strengthening mechanism for each element is also discussed. The order of solid-solution strengthening of these alloying elements is Cr > Nb > Sn, and the sequence is Cr ≈ Mo > Nb when precipitation strengthening is considered. Further, as far as the ability to impede dislocation motion is concerned, the sequence is Mo > Cr > Nb > Sn. The experimental results demonstrate that minor amount of Mo addition in zirconium alloys is greatly effective in strengthening the alloy and reducing the grain size.

A comparative study of hydride-induced embrittlement of Zircaloy-4 fuel cladding tubes in the longitudinal and hoop directions

ABSTRACT In this work, the mechanical behavior of as-received and hydrogenated Zircaloy-4 fuel claddings was investigated by the newly developed advanced expansion due to compression (A-EDC) test and the conventional uniaxial tension (UT) test at room temperature, in order to, respectively, understand the hydride-induced embrittlement in tube longitudinal and hoop directions. The UT experimental results showed that the mechanical strength in the longitudinal direction slightly increased with hydrogen content, whereas the maximum strain decreased greatly with hydrogen increasing. In the case of A-EDC tests, the mechanical performance in the hoop direction seemed insensitive to the hydrogen content; no obvious decline in maximum strain was observed until 800 ppm H. The comparison between these two tests clearly reveals that the hydride-induced embrittlement is preferential to occur in the longitudinal direction, compared with the sluggish response in the hoop direction, which implied the enhanced ductility anisotropy due to hydrides. In the post-tests observation, the fracture morphologies became gradually distinct for the as-received and hydrided samples examined by UT and A-EDC methods, and different orientation relationships between the applied stresses and hydrides distribution would be responsible for that distinction.