Joachim Mohn

Mechanisms of N2O production in biological wastewater treatment under nitrifying and denitrifying conditions

Nitrous oxide (N2O) is an important greenhouse gas and a major sink for stratospheric ozone. In biological wastewater treatment, microbial processes such as autotrophic nitrification and heterotrophic denitrification have been identified as major sources; however, the underlying pathways remain unclear. In this study, the mechanisms of N2O production were investigated in a laboratory batch-scale system with activated sludge for treating municipal wastewater. This relatively complex mixed population system is well representative for full-scale activated sludge treatment under nitrifying and denitrifying conditions. Under aerobic conditions, the addition of nitrite resulted in strongly nitrite-dependent N2O production, mainly by nitrifier denitrification of ammonia-oxidizing bacteria (AOB). Furthermore, N2O is produced via hydroxylamine oxidation, as has been shown by the addition of hydroxylamine. In both sets of experiments, N2O production was highest at the beginning of the experiment, then decreased continuously and ceased when the substrate (nitrite, hydroxylamine) had been completely consumed. In ammonia oxidation experiments, N2O peaked at the beginning of the experiment when the nitrite concentration was lowest. This indicates that N2O production via hydroxylamine oxidation is favored at high ammonia and low nitrite concentrations, and in combination with a high metabolic activity of ammonia-oxidizing bacteria (at 2 to 3 mgO2/l); the contribution of nitrifier denitrification by AOB increased at higher nitrite and lower ammonia concentrations towards the end of the experiment. Under anoxic conditions, nitrate reducing experiments confirmed that N2O emission is low under optimal growth conditions for heterotrophic denitrifiers (e.g. no oxygen input and no limitation of readily biodegradable organic carbon). However, N2O and nitric oxide (NO) production rates increased significantly in the presence of nitrite or low dissolved oxygen concentrations.

Determination of biogenic and fossil CO2 emitted by waste incineration based on 14CO2 and mass balances

A field application of the radiocarbon ((14)C) method was developed to determine the ratio of biogenic vs. fossil CO(2) emissions from waste-to-energy plants (WTE). This methodology can be used to assign the Kyoto relevant share of fossil CO(2) emissions, which is highly relevant for emission budgets and emission trading. Furthermore, heat and electricity produced by waste incinerators might be labelled depending on the fossil or biogenic nature of the primary energy source. The method development includes representative on-site CO(2) absorption and subsequent release in the laboratory. Furthermore, a reference value for the (14)C content of pure biogenic waste (f(M,bio)) was determined as 1.130+/-0.038. Gas samples for (14)CO(2) analysis were taken at three WTEs during one month each. Results were compared to an alternative approach based on mass and energy balances. Both methods were in excellent agreement and indicated a fraction of biogenic CO(2) slightly above 50%.

Isotope Signatures of N2O in a Mixed Microbial Population System: Constraints on N2O Producing Pathways in Wastewater Treatment

We present measurements of site preference (SP) and bulk (15)N/(14)N ratios (δ(15)N(bulk)(N2O)) of nitrous oxide (N(2)O) by quantum cascade laser absorption spectroscopy (QCLAS) as a powerful tool to investigate N(2)O production pathways in biological wastewater treatment. QCLAS enables high-precision N(2)O isotopomer analysis in real time. This allowed us to trace short-term fluctuations in SP and δ(15)N(bulk)(N2O) and, hence, microbial transformation pathways during individual batch experiments with activated sludge from a pilot-scale facility treating municipal wastewater. On the basis of previous work with microbial pure cultures, we demonstrate that N(2)O emitted during ammonia (NH(4)(+)) oxidation with a SP of -5.8 to 5.6 ‰ derives mostly from nitrite (NO(2)(-)) reduction (e.g., nitrifier denitrification), with a minor contribution from hydroxylamine (NH(2)OH) oxidation at the beginning of the experiments. SP of N(2)O produced under anoxic conditions was always positive (1.2 to 26.1 ‰), and SP values at the high end of this spectrum (24.9 to 26.1 ‰) are indicative of N(2)O reductase activity. The measured δ(15)N(bulk)(N2O) at the initiation of the NH(4)(+) oxidation experiments ranged between -42.3 and -57.6 ‰ (corresponding to a nitrogen isotope effect Δδ(15)N = δ(15)N(substrate) - δ(15)N(bulk)(N2O) of 43.5 to 58.8 ‰), which is considerably higher than under denitrifying conditions (δ(15)N(bulk)(N2O) 2.4 to -17 ‰; Δδ(15)N = 0.1 to 19.5 ‰). During the course of all NH(4)(+) oxidation and nitrate (NO(3)(-)) reduction experiments, δ(15)N(bulk)(N2O) increased significantly, indicating net (15)N enrichment in the dissolved inorganic nitrogen substrates (NH(4)(+), NO(3)(-)) and transfer into the N(2)O pool. The decrease in δ(15)N(bulk)(N2O) during NO(2)(-) and NH(2)OH oxidation experiments is best explained by inverse fractionation during the oxidation of NO(2)(-) to NO(3)(-).

Determination of N2O isotopomers with quantum cascade laser based absorption spectroscopy

We present an analytical technique based on direct absorption laser spectroscopy for high precision and simultaneous determination of the mixing ratios of the most abundant nitrous oxide isotopic species: (14)N(15)N(16)O, (15)N(14)N(16)O and (14)N(2) (16)O. A precision of 0.5 ??? was achieved for the site specific isotope ratios of N(2)O at 90 ppm using an averaging time of 300 s.

Interlaboratory assessment of nitrous oxide isotopomer analysis by isotope ratio mass spectrometry and laser spectroscopy: current status and perspectives.

RATIONALE In recent years, research and applications of the N2O site-specific nitrogen isotope composition have advanced, reflecting awareness of the contribution of N2O to the anthropogenic greenhouse effect, and leading to significant progress in instrument development. Further dissemination of N2O isotopomer analysis, however, is hampered by a lack of internationally agreed gaseous N2O reference materials and an uncertain compatibility of different laboratories and analytical techniques. METHODS In a first comparison approach, eleven laboratories were each provided with N2O at tropospheric mole fractions (target gas T) and two reference gases (REF1 and REF2). The laboratories analysed all gases, applying their specific analytical routines. Compatibility of laboratories was assessed based on N2O isotopocule data for T, REF1 and REF2. Results for T were then standardised using REF1 and REF2 to evaluate the potential of N2O reference materials for improving compatibility between laboratories. RESULTS Compatibility between laboratories depended on the analytical technique: isotope ratio mass spectrometry (IRMS) results showed better compatibility for δ(15)N values, while the performance of laser spectroscopy was superior with respect to N2O site preference. This comparison, however, is restricted by the small number of participating laboratories applying laser spectroscopy. Offset and two-point calibration correction of the N2O isotopomer data significantly improved the consistency of position-dependent nitrogen isotope data while the effect on δ(15)N values was only minor. CONCLUSIONS The study reveals that for future research on N2O isotopocules, standardisation against N2O reference material is essential to improve interlaboratory compatibility. For atmospheric monitoring activities, we suggest N2O in whole air as a unifying scale anchor.

Novel laser spectroscopic technique for continuous analysis of N2O isotopomers--application and intercomparison with isotope ratio mass spectrometry.

RATIONALE Nitrous oxide (N(2)O), a highly climate-relevant trace gas, is mainly derived from microbial denitrification and nitrification processes in soils. Apportioning N(2)O to these source processes is a challenging task, but better understanding of the processes is required to improve mitigation strategies. The N(2)O site-specific (15)N signatures from denitrification and nitrification have been shown to be clearly different, making this signature a potential tool for N(2)O source identification. We have applied for the first time quantum cascade laser absorption spectroscopy (QCLAS) for the continuous analysis of the intramolecular (15)N distribution of soil-derived N(2)O and compared this with state-of-the-art isotope ratio mass spectrometry (IRMS). METHODS Soil was amended with nitrate and sucrose and incubated in a laboratory setup. The N(2)O release was quantified by FTIR spectroscopy, while the N(2)O intramolecular (15)N distribution was continuously analyzed by online QCLAS at 1 Hz resolution. The QCLAS results on time-integrating flask samples were compared with those from the IRMS analysis. RESULTS The analytical precision (2σ) of QCLAS was around 0.3‰ for the δ(15)N(bulk) and the (15)N site preference (SP) for 1-min average values. Comparing the two techniques on flask samples, excellent agreement (R(2)= 0.99; offset of 1.2‰) was observed for the δ(15)N(bulk) values while for the SP values the correlation was less good (R(2 )= 0.76; offset of 0.9‰), presumably due to the lower precision of the IRMS SP measurements. CONCLUSIONS These findings validate QCLAS as a viable alternative technique with even higher precision than state-of-the-art IRMS. Thus, laser spectroscopy has the potential to contribute significantly to a better understanding of N turnover in soils, which is crucial for advancing strategies to mitigate emissions of this efficient greenhouse gas.

Fossil and biogenic CO2 from waste incineration based on a yearlong radiocarbon study

We describe the first long-term implementation of the radiocarbon (¹⁴C) method to study the share of biogenic (%Bio C) and fossil (%Fos C) carbon in combustion CO₂. At five Swiss incinerators, a total of 24 three-week measurement campaigns were performed over 1 year. Temporally averaged bag samples were analyzed for ¹⁴CO₂ by accelerator mass spectrometry. Significant differences between the plants in the share of fossil CO₂ were observed, with annual mean values from 43.4 ± 3.9% to 54.5 ± 3.1%. Variations can be explained by the waste composition of the respective plant. Based on our dataset, an average value of 48 ± 4%Fos C was determined for waste incineration in Switzerland. No clear annual trend in %Fos C was observed for four of the monitored incinerators, while one incinerator showed considerable variations, which are likely due to the separation and temporary storage of bulky goods.

Time-resolved ammonia measurement in vehicle exhaust

The objective of this study was to identify the influence of sampling and analytical approach on the quality of NH3 emission data of a gasoline-fuelled three-way catalyst vehicle. NH3 concentration measurements have been performed in the tailpipe and in the diluted exhaust after a constant volume sampling (CVS) system during five different test cycles. Chemical ionisation mass spectrometry (CI-MS) and Fourier transform infrared spectroscopy (FTIR) were used to acquire ammonia concentrations in real-time. Independently, NH3 emission rates were determined by continuous absorption of a flow-proportional sample of exhaust gas in diluted sulphuric acid and subsequent ion chromatography (IC). Ammonia emission rates ranged from 22–94 mg km-1. The results of the three compared techniques are in good agreement. Furthermore, time-resolved ammonia emission profiles recorded by CI-MS and FTIR coincided with respect to emission levels as well as emission dynamics. However, in the dilution tunnel, severe ammonia adsorption was observed leading to long lasting memory effects or even analyte loss. Therefore, neither ammonia real-time emission data nor NH3 emission rates should be acquired after a CVS system.

Continuous field measurements of δ13C–CO2 and trace gases by FTIR spectroscopy

Continuous analysis of the 13C/12C ratio of atmospheric CO2 (δ13C–CO2) is a powerful tool to quantify CO2 flux strengths of the two major ecosystem processes assimilation and respiration. Traditional laboratory techniques such as isotope ratio mass spectrometry (IRMS) in combination with flask sampling are subject to technical limitations that do not allow to fully characterising variations of atmospheric δ13C–CO2 at all relevant timescales. In our study, we demonstrate the strength of Fourier transform infrared (FTIR) spectroscopy in combination with a PLS-based calibration strategy for online analysis of δ13C–CO2 in ambient air. The ability of the instrument to measure δ13C–CO2 was tested on a grassland field-site and compared with standard laboratory-based IRMS measurements made on field-collected flask samples. Both methods were in excellent agreement, with an average difference of 0.4‰ (n=81). Simultaneously, other important trace gases such as CO, N2O and CH4 were analysed by FTIR spectroscopy.

Real-time analysis of δ13C- and δD-CH4 in ambient air with laser spectroscopy: method development and first intercomparison results

In situ and simultaneous measurement of the three most abundant isotopologues of methane using midinfrared laser absorption spectroscopy is demonstrated. A field-deployable, autonomous platform is realized by coupling a compact quantum cascade laser absorption spectrometer (QCLAS) to a preconcentration unit, called trace gas extractor (TREX). This unit enhances CH4 mole fractions by a factor of up to 500 above ambient levels and quantitatively separates interfering trace gases such as N2O and CO2. The analytical precision of the QCLAS isotope measurement on the preconcentrated (750 ppm, parts-per-million, μmole mole) methane is 0.1 and 0.5 ‰ for δCand δDCH4 at 10 min averaging time. Based on repeated measurements of compressed air during a 2-week intercomparison campaign, the repeatability of the TREX–QCLAS was determined to be 0.19 and 1.9 ‰ for δC and δD-CH4, respectively. In this intercomparison campaign the new in situ technique is compared to isotoperatio mass spectrometry (IRMS) based on glass flask and bag sampling and real time CH4 isotope analysis by two commercially available laser spectrometers. Both laser-based analyzers were limited to methane mole fraction and δC-CH4 analysis, and only one of them, a cavity ring down spectrometer, was capable to deliver meaningful data for the isotopic composition. After correcting for scale offsets, the average difference between TREX–QCLAS data and bag/flask sampling–IRMS values are within the extended WMO compatibility goals of 0.2 and 5 ‰ for δCand δD-CH4, respectively. This also displays the potential to improve the interlaboratory compatibility based on the analysis of a reference air sample with accurately determined isotopic composition.