Juan Luis Guerrero-Rascado

Extreme Saharan dust event over the southern Iberian Peninsula in september 2007: active and passive remote sensing from surface and satellite

Abstract. This study investigates aerosol optical properties during the extreme Saharan dust event detected from 3 to 7 September 2007 over Granada, southern Iberian Peninsula, with both active and passive remote sensing instrumentation from surface and satellite. The intensity of the event was visualized on the aerosol optical depth series obtained by the sun-photometer Cimel CE 318-4 operated at Granada in the framework of AERONET from August 2004 until December 2008 (level 2 data). A combination of large aerosol optical depth (0.86–1.50) at 500 nm, and reduced Angstrom exponent (0.1–0.25) in the range 440–870 nm, was detected on 6 September during daytime. This Saharan dust event also affected other Iberian Peninsula stations included in AERONET (El Arenosillo and Evora stations), and it was monitored by MODIS instrument on board Aqua satellite. Vertically resolved measurements were performed by a ground-based Raman Lidar and by CALIPSO satellite. During the most intense stage, on 6 September, maximum aerosol backscatter values were a factor of 8 higher than other maxima during this Saharan dust event. Values up to 1.5×10−2 km−1 sr−1 at 355 and 532 nm were detected in the layer with the greatest aerosol load between 3–4 km a.s.l., although aerosol particles were also detected up to 5.5 km a.s.l. In this stage of the event, dust particles at these altitudes showed a backscatter-related Angstrom exponent between –0.44 and 0.53 for the two spectral intervals considered. The results from different measurements (active/passive and ground-based/satellite) reveal the importance of performing multi-instrumental measurements to properly characterize the contribution of different aerosol types from different sources during extreme events. The atmospheric stabilization effect of the aerosol particles has been characterized by computing the solar heating rates using SBDART code.

EARLINET observations of the 14-22-May long-range dust transport event during SAMUM 2006: validation of results from dust transport modelling

We observed a long-range transport event of mineral dust from North Africa to South Europe during the Saharan Mineral Dust Experiment (SAMUM) 2006. Geometrical and optical properties of that dust plume were determined with Sun photometer of the Aerosol Robotic Network (AERONET) and Raman lidar near the North African source region, and with Sun photometers of AERONET and lidars of the European Aerosol Research Lidar Network (EARLINET) in the far field in Europe. Extinction-to-backscatter ratios of the dust plume over Morocco and Southern Europe do not differ. Ångström exponents increase with distance from Morocco. We simulated the transport, and geometrical and optical properties of the dust plume with a dust transport model. The model results and the experimental data show similar times regarding the appearance of the dust plume over each EARLINET site. Dust optical depth from the model agrees in most cases to particle optical depth measured with the Sun photometers. The vertical distribution of the mineral dust could be satisfactorily reproduced, if we use as benchmark the extinction profiles measured with lidar. In some cases we find differences. We assume that insufficient vertical resolution of the dust plume in the model calculations is one reason for these deviations.

Aerosol closure study by lidar, Sun photometry, and airborne optical counters during DAMOCLES field campaign at El Arenosillo sounding station, Spain

We present a comparison of aerosol properties derived from in situ and remote sensing instruments during DAMOCLES campaign, aimed at investigating the equivalence between the instrumentation and methodologies employed by several Spanish groups to study atmospheric aerosols at a regional background site. The complete set of instruments available during this closure experiment allowed collecting a valuable high-resolution aerosol measurement data set. The data set was augmented with airborne in situ measurements carried out in order to characterize aerosol particles during the midday of 29 June 2006. This work is focused on aerosol measurements using different techniques of high-quality instruments (ground-based remote sensing and aircraft in situ) and their comparisons to characterize the aerosol vertical profiles. Our results indicate that the variability between the detected aerosol layers was negligible in terms of aerosol optical properties and size distributions. Relative differences in aerosol extinction coefficient profiles were less than 20% at 355 and 532 nm and less than 30% at 1064 nm, in the region with high aerosol concentration. Absolute differences in aerosol optical depth (AOD) were below 0.01 at 532 and 1064 nm and less than 0.02 at 355 nm, less than the uncertainties assumed in the AOD obtained from elastic lidar. Columnar values of the lidar ratio revealed some discrepancies with respect to the in situ aircraft measurements, caused fundamentally by the lack of information in the lowest part of the boundary layer.

Retrieving aerosol microphysical properties by Lidar‐Radiometer Inversion Code (LIRIC) for different aerosol types

LIRIC (Lidar-Radiometer Inversion Code) is applied to combined lidar and Sun photometer data from Granada station corresponding to different case studies. The main aim of this analysis is to evaluate the stability of LIRIC output volume concentration profiles for different aerosol types, loadings, and vertical distributions of the atmospheric aerosols. For this purpose, in a first part, three case studies corresponding to different atmospheric situations are analyzed to study the influence of the user-defined input parameters in LIRIC when varied in a reasonable range. Results evidence the capabilities of LIRIC to retrieve vertical profiles of microphysical properties during daytime by the combination of the lidar and the Sun photometer systems in an automatic and self-consistent way. However, spurious values may be obtained in the lidar incomplete overlap region depending on the structure of the aerosol layers. In a second part, the use of a second Sun photometer located in Cerro Poyos, in the same atmospheric column as Granada but at higher altitude, allowed us to obtain LIRIC retrievals from two different altitudes with independent Sun photometer measurements in order to check the self-consistency and robustness of the method. Retrievals at both levels are compared, providing a very good agreement (differences below 5 µm3/cm3) in those cases with the same aerosol type in the whole atmospheric column. However, some assumptions such as the height independency of parameters (sphericity, size distribution, or refractive index, among others) need to be carefully reviewed for those cases with the presence of aerosol layers corresponding to different types of atmospheric aerosols.

Statistical analysis of aerosol optical properties retrieved by Raman lidar over Southeastern Spain

In this work, a statistical study of aerosol optical properties retrieved from Raman lidar profiles has been addressed at the EARLINET station of Granada, Spain, during the period 2008–2010. Lidar measurements were performed during day- and night-time. Mean values and variances of the aerosol extinction and backscatter coefficient profiles in the troposphere have been computed. These profiles evidenced that during autumn–winter, most of the particles are confined to the first kilometres above the surface (below 3500 m above sea level), while a major presence of aerosol at higher altitudes is observed during spring–summer. Moreover, a study of the planetary boundary layer (PBL) height and aerosol stratification has been performed for the whole studied period. Monthly mean β-related Angström exponent values have been obtained for aerosols in the PBL and in the free troposphere. Furthermore, monthly mean lidar ratio values at 532 nm have been retrieved from Raman profiles during night-time. A detailed study of these intensive properties has allowed characterizing the aerosol present over our station. The results evidenced a predominance of large and scattering particles during spring and summer and an increase of small and absorbing particles during autumn and winter.

Analysis of lidar depolarization calibration procedure and application to the atmospheric aerosol characterization

A Raman lidar system is used to monitor the aerosol depolarization features of the urban atmosphere at the Andalusian Centre for Environmental Research (CEAMA), in Granada, southeastern Spain. The lidar system was upgraded in 2010 to enable the application of the ±45° calibration method, which does not require any external optical device. We analyse the method and classify the atmospheric aerosol following the criteria based on depolarization. Backscatter coefficient, backscatter-related Angström exponent (å β), volume linear depolarization ratio (δv), and particle linear depolarization ratio (δp) profiles are studied in Saharan dust and biomass burning smoke events during the summer of 2010. The strength of these events was visualized in the aerosol optical depth (AOD) series obtained by Sun and star photometers operated at CEAMA. During the analysed events, the AOD at 440 nm ranged between 0.2 and 0.3, although the Angström exponent (å AOD) retrieved by the Sun photometer was considerably lower during the Saharan dust event (å AOD = 0.4 ± 0.1) than during the biomass burning event (å AOD = 1.4 ± 0.1). Regarding å β profiles, å β values were similar along the vertical profiles and comparable to å AOD values for each event. In contrast, the particle linear depolarization ratio (δp) at 532 nm showed an opposite behaviour to å β, changing along the vertical profiles. In fact, the aerosol layers located in the free troposphere showed mean values of δp of 0.13 ± 0.08 and 0.03 ± 0.01 in the Saharan dust and biomass burning events, respectively. These results show that the use of depolarization techniques enables an accurate aerosol typing and the understanding of the layers composition in the atmosphere.

Aerosol transport over the western Mediterranean basin: Evidence of the contribution of fine particles to desert dust plumes over Alborán Island

Eight months (June 2011 to January 2012) of aerosol property data were obtained at the remote site of Alboran Island (35.95°N, 3.03°W) in the western Mediterranean basin. The aim of this work is to assess the aerosol properties according to air mass origin and transport over this remote station with a special focus on air mass transport from North Africa. For air masses coming from North Africa, different aerosol properties showed strong contributions from mineral dust lifted from desert areas. Nevertheless, during these desert dust intrusions, some atmospheric aerosol properties are clearly different from pure mineral dust particles. Thus, Angstrom exponent α(440–870) presents larger values than those reported for pure desert dust measured close to dust source regions. These results combine with α(440, 670) − α(670, 870) ≥ 0.1 and low single scattering albedo (ω(λ)) values, especially at the largest wavelengths. Most of the desert dust intrusions over Alboran can be described as a mixture of dust and anthropogenic particles. The analyses support that our results apply to North Africa desert dust air masses transported from different source areas. Therefore, our results indicate a significant contribution of fine absorbing particles during desert dust intrusions over Alboran arriving from different source regions. The aerosol optical depth data retrieved from Sun photometer measurements have been used to check Moderate Resolution Imaging Spectroradiometer retrievals, and they show reasonable agreement, especially for North African air masses.

Infrared lidar overlap function: an experimental determination.

The most recent works demonstrate that the lidar overlap function, which describes the overlap between the laser beam and the receiver field of view, can be determined experimentally for the 355 and 532 nm channels using Raman signals. Nevertheless, the Raman channels cannot be used to determine the lidar overlap for the infrared channel (1064 nm) because of their low intensity. In addition, many Raman lidar systems only provide inelastic signals with reasonable signal-to-noise ratio at nighttime. In view of this fact, this work presents a modification of that method, based on the comparison of attenuated backscatter profiles derived from lidar and ceilometer, to retrieve the overlap function for the lidar infrared channel. Similarly to the Raman overlap method, the approach presented here allows to derive the overlap correction without an explicit knowledge of all system parameters. The application of the proposed methodology will improve the potential of Raman lidars to investigate the aerosol microphysical properties in the planetary boundary layer, extending the information of 1064 nm backscatter profiles to the ground and allowing the retrieval of microphysical properties practically close to the surface.

Aerosol Lidar Intercomparison in the Framework of SPALINET—The Spanish Lidar Network: Methodology and Results

A group of eight Spanish lidars was formed in order to extend the European Aerosol Research Lidar Network-Advanced Sustainable Observation System (EARLINET-ASOS) project. This study presents intercomparisons at the hardware and software levels. Results of the system intercomparisons are based on range-square-corrected signals in cases where the lidars viewed the same atmospheres. Comparisons were also made for aerosol backscatter coefficients at 1064 nm (2 systems) and 532 nm (all systems), and for extinction coefficients at 532 nm (2 systems). In total, three field campaigns were carried out between 2006 and 2007. Comparisons were limited to the highest layer found before the free troposphere, i.e., either the atmospheric boundary layer or the aerosol layer just above it. Some groups did not pass the quality assurance criterion on the first attempt. Following modification and improvement to these systems, all systems met the quality criterion. The backscatter algorithm intercomparison consisted of processing lidar signal profiles simulated for two types of atmospheric conditions. Three stages with increasing knowledge of the input parameters were considered. The results showed that all algorithms work well when all inputs are known. They also showed the necessity to perform, when possible, additional measurements to attain better estimation of the lidar ratio, which is the most critical unknown in the elastic lidar inversion.

Study of mineral dust entrainment in the planetary boundary layer by lidar depolarization technique

Measurements on 27 June 2011 were performed over the Southern Iberian Peninsula at Granada EARLINET station, using active and passive remote sensing and airborne and surface in-situ data in order to study the entrainment processes between aerosols in the free troposphere and those in the planetary boundary layer (PBL). To this aim the temporal evolution of the lidar depolarisation, backscatter-related Angström exponent and potential temperature profiles were used in combination with the PBL contribution to the aerosol optical depth (AOD). Our results show that the mineral dust entrainment in the PBL was caused by the convective processes which ‘trapped’ the lofted mineral dust layer, distributing the mineral dust particles within the PBL. The temporal evolution of ground-based in-situ data evidenced the impact of this process at surface level. Finally, the amount of mineral dust in the atmospheric column available to be dispersed into the PBL was estimated by means of POLIPHON (Polarizing Lidar Photometer Networking). The dust mass concentration derived from POLIPHON was compared with the coarse-mode mass concentration retrieved with airborne in-situ measurements. Comparison shows differences below 50 µg/m3 (30% relative difference) indicating a relative good agreement between both techniques.