Kai Mo Ng

High-impact polystyrene/halloysite nanocomposites prepared by emulsion polymerization using sodium dodecyl sulfate as surfactant

High-impact polystyrene (PS) nanocomposites filled with individually dispersed halloysite nanotubes (HNTs) were prepared by emulsion polymerization of styrene in the presence of HNTs with sodium dodecyl sulfate (SDS) as the emulsifier. The SDS is a good dispersing agent for HNTs in aqueous solution. The emulsion polymerization resulted in the formation of polystyrene nanospheres separating individual HNTs. Transmission electron microscopy revealed that the HNTs were uniformly dispersed in the PS matrix. Differential scanning calorimetry, Fourier-transform infrared spectroscopy and thermogravimetry were used to characterize the PS/HNT nanocomposites. The impact strength of the PS/HNTs nanocomposites was 300% higher than that of the neat PS. This paper presents a simple yet feasible method for the preparation of high-impact PS/halloysite nanocomposites.

Growth process of homogeneously and heterogeneously nucleated spherulites as observed by atomic force microscopy

A poly(bisphenol A octane ether) (BA-C8) was synthesized. The isothermal spherulitic growth process was studied in situ using atomic force microscopy (AFM) at room temperature. For spherulites formed by homogeneous nucleation, the growth process includes the birth of a primary nucleus, the development of a founding lamella and the growth of the founding lamella into a spherulite. An embryo below a critical size is unstable. A stable embryo grows into a founding lamella. There is only one founding lamella in each spherulite. All other lamellae originate from this founding lamella. Two eyes can be seen at the center of a spherulite. For spherulites formed through heterogeneous nucleation, many lamellae grow at the nucleus surface and propagate outward radially. The spherulites acquire spherical symmetry at the early stage of crystallization. No eyes are found for this kind of spherulites.

Characterization of hydrogenated graphite powder by X-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry

Hydrogenated graphite powder was obtained through Birch reduction of graphite powder and characterized by X-ray photoelectron spectroscopy (XPS) and time-of-flight secondary ion mass spectrometry (ToF-SIMS) at 500 °C. The sp3 carbons formed at the edges of the surface of the hydrogenated graphite powder exhibited an sp3 carbon peak in the XPS C1s spectrum. The sp3-to-sp2 carbon ratio calculated from the XPS spectra increased from 0.08 to 1.19 after hydrogenation. Two sets of peaks, the Cx− and CxH− ion series (where x = 1, 2, 3…), were identified in the ToF-SIMS spectra of both the graphite powder and hydrogenated graphite powder. The difference between these two spectra represented an increase in the normalized intensities of the H− and CxH− ions in the spectrum of the hydrogenated graphite powder, indicating the formation of more sp3 carbons on the surface.