Katarzyna Szymczyk

Wettability of polymeric solids by ternary mixtures composed of hydrocarbon and fluorocarbon nonionic surfactants

Contact angle (θ) measurements on poly(tetrafluoroethylene) (PTFE) and polymethyl methacrylate (PMMA) surface were carried out for the systems containing ternary mixtures of surfactants composed of: p-(1,1,3,3-tetramethylbutyl)phenoxypoly(ethylene glycols), Triton X-100 (TX100), Triton X-165 (TX165) and Triton X-114 (TX114), and fluorocarbon surfactants, Zonyl FSN100 (FSN100) and Zonyl FSO100 (FSO100). The aqueous solutions of ternary surfactant mixtures were prepared by adding TX114, FSN100 or FSO100 to binary mixtures of TX100+TX165, where the synergistic effect in the reduction of the surface tension of water (γ(LV)) was determined. From the obtained contact angle values, the relationships between cosθ, the adhesion tension and surface tension of solutions, cosθ and the reciprocal of the surface tension were determined. On the basis of these relationships, the correlation between the critical surface tension of PTFE and PMMA wetting and the surface tension of these polymers as well as the work of adhesion of aqueous solutions of ternary surfactant mixtures to PTFE and PMMA surface were discussed. The critical surface tension of PTFE and PMMA wetting, γ(C), determined from the contact angle measurements of aqueous solutions of surfactants including FSN100 or FSO100 was also discussed in the light of the surface tension changes of PTFE and PMMA under the influence of film formation by fluorocarbon surfactants on the surface of these polymers. The γ(C) values of the studied polymeric solids were found to be different for the mixtures composed of hydrocarbon surfactants in comparison with those of hydrocarbon and fluorocarbon surfactants. In the solutions containing fluorocarbon surfactants, the γ(C) values were different taking into account the contact angle in the range of FSN100 and FSO100 concentration corresponding to their unsaturated monolayer at water-air interface or to that saturated.

Thermodynamics of Micellization of Aqueous Solutions of Binary Mixtures of Two Anionic Surfactants

The thermodynamics of micellization of mixed anionic/anionic surfactant solutions, that is, sodium dodecyl sulfate (SDDS) and sodium decyl sulfate (SDS), have been studied by surface tension, density, and conductivity measurements. The obtained results indicate that the values of critical micelle concentration strongly depend on the composition of the mixture and that the mole fraction of surfactants in the mixed micelle calculated on the basis of Rosen and Villeneuve approaches are different from those in the bulk phase. The small negative deviation from the linear relationship between the critical micelle concentrations and composition of SDDS and SDS mixtures in the bulk phase, the values of the molecular interaction parameters, activity coefficients, and the excess Gibbs energy of mixed micelle formation calculated on the basis of Rosen and Villeneuve approaches and calculations based on the MT theory of Blankschtein proved that there is synergism in mixed micelle formation of aqueous solutions of SDDS and SDS. It was also found that the values of the standard Gibbs energy of micellization for the mixture of these two surfactants which confirm the synergetic effect can be predicted on the basis of the proposed equations which include the values of the mole fraction of surfactant in the mixed micelle and excess Gibbs energy of micellization of SDDS and SDS. Knowing the values of mole fractions of surfactants in the mixed micelle, it is also possible to calculate the volume change of surfactants after the micellization process.

Wetting Behavior of Aqueous Solutions of Binary Surfactant Mixtures to Poly(tetrafluoroethylene)

Measurements of the surface tension (γ LV) and advancing contact angle () on poly(tetrafluoroethylene) (PTFE) were carried out for aqueous solutions of cetyltrimethylammonium bromide (CTAB), cetylpyridynium bromide (CPyB), sodium decylsulfate (SDS), sodium dodecylsulfate (SDDS), p-(1,1,3,3-tetramethylbutyl) phenoxypoly(ethylene glycol)s, Triton X-100 (TX100) and Triton X-165 (TX165) and their mixtures. The results obtained indicate that the values of the surface tension and wettability of PTFE depend on the concentration and composition of the surfactants mixture. In contrast to Zisman finding, there was no linear dependence between cos and the surface tension of aqueous solutions of surfactants and their mixtures for all studied systems, but a linear dependence existed between the adhesional tension and solution surface tension for PTFE in the whole concentration range, the slope of which was –1, indicating that the surface excess concentration of surfactant at the PTFE–solution interface was the same as that at the solution–air interface for a given bulk concentration. It was also found that the work of adhesion of aqueous solutions of surfactants and their mixtures to PTFE surface did not depend on the type of surfactant, its concentration and composition of the mixture. This means that for the studied systems the interaction across PTFE–solution interface was constant, and it was largely of Lifshitz–van der Waals type. On the basis of the surface tension of PTFE and the Young equation and thermodynamic analysis of the work of adhesion of aqueous solutions of surfactants to the polymer surface it was found that in the case of PTFE the changes of the contact angle as a function of the total mixture concentration in the bulk phase resulted only from changes of the polar component of the solution surface tension.

A study of the interactions of ternary surfactant systems at the water-air interface.

Surface tension measurements were carried out for the systems containing ternary mixtures of cetyltrimethylammonium bromide (CTAB) and p-(1,1,3,3-tetramethylbutyl)phenoxypoly(ethylene glycols), Triton X-100 (TX100) and Triton X-165 (TX165). The aqueous solution of ternary surfactant mixtures were prepared by adding the third surfactant to the binary mixture of the surfactants where the synergetic effect in the reduction of the surface tension of water were determined to compare the influence of the third surfactants on the adsorption of this binary mixture at the water-air interface. The obtained results and calculations indicate that the synergetic effect in the reduction of the surface tension of water was deepened after adding the third surfactant to the binary mixture at the composition at which this effect was observed. The best synergetic effect in the gamma(LV) reduction was determined on the basis of the values of the molecular interaction parameter for aqueous solutions of ternary mixtures of CTAB+TX165 (alpha CTAB = 0.2) (gamma(LV) = 50 mN/m, C = 4.3 x 10(-5) M) +TX100 (C=10(8)-10(-2) M).

Effect of two hydrocarbon and one fluorocarbon surfactant mixtures on the surface tension and wettability of polymers.

The advancing contact angle of water, formamide and diiodomethane on polytetrafluoroethylene (PTFE) and polymethyl methacrylate (PMMA) surfaces covered with the film of ternary mixtures of surfactants including p-(1,1,3,3-tetramethylbutyl) phenoxypoly(ethyleneglycols), Triton X-100 (TX100) and Triton X-165 (TX165) and the fluorocarbon surfactants, Zonyl FSN-100 (FSN100) or Zonyl FSO-100 (FSO100) was measured. The obtained results were used for the surface tension of PTFE and PMMA covered with this film determination from the Young equation on the basis of van Oss et al. and Neumann et al. approaches to the interfacial tension. The surface tension of PTFE and PMMA was also determined using the Neumann et al. equation and the contact angle values for the aqueous solutions of the above mentioned ternary surfactants mixtures which were taken from the literature. As follows from our calculations mainly the presence of the fluorocarbon surfactant in the mixture considerably changes the surface properties of PTFE and PMMA causing that in contrast to hydrocarbon surfactants and their mixtures there is no linear dependence between adhesion and surface tension in the whole range of concentration of the ternary mixtures of surfactants including the fluorocarbon one. The behavior of fluorocarbon surfactants at the polymer-air and polymer-water interfaces is quite different from those of hydrocarbons. In the case of fluorocarbon surfactants not only adsorption but also sorption can occur on the polymer surface.

Wettability of polytetrafluoroethylene and polymethyl methacrylate by aqueous solutions of TX-100 and TX-165 mixture with propanol

The measurements of the contact angle of the aqueous solutions of TX-100 and TX-165 mixture with propanol on polytetrafluoroethylene (PTFE) and polymethyl methacrylate (PMMA) were carried out. On the basis of the obtained results, the dependence between the cosine of contact angle and surface tension as well as between the adhesion and surface tension of the solutions in the light of the work of adhesion of the solutions to the PTFE and PMMA surface was discussed. The dependence between the adhesion and surface tension for PMMA was correlated to the surface concentration of propanol as well as TX-100 and TX-165 mixture concentration determined from the Frumkin equation at the PMMA-air, PMMA-solution and solution–air interfaces. For this purpose, the surface tension of PMMA covered by a surface active agent film was determined using the Neumann et al. equation and next the PMMA–solution interface tension was evaluated from the Young equation. The values of the surface tension of PMMA covered by propanol and surfactants mixture layer were applied to describe the changes of the adhesion work of solutions to PMMA surface as a function of propanol and surfactants mixture concentration. The adhesion work of the aqueous solutions of TX-100 and TX-165 mixture with propanol to the PTFE and PMMA surfaces was discussed in the light of the adhesion work of particular components of the solutions. On the basis of the results obtained from the contact angle measurements, the standard Gibbs free energy of adsorption of particular components of solution was also considered.

Macroscopic and Microscopic Properties of Some Surfactants and Biosurfactants

The adsorption of surfactants at the water-air and solid-water interfaces and their wetting properties decide their practical applications. Therefore the adsorption of monorhamnolipid, surfactin, n-octyl-β-d-glucopyranoside, n-dodecyl-β-d-glucopyranoside, n-dodecyl-β-d-maltoside, sucrose monodecanoate, sucrose monododecanoate, Tween 20, Tween 60, and Tween 80 at the water-air, polytetrafluoroethylene-water, polyethylene-water, poly(methyl methacrylate)-water, polyamide-water, and quartz-water interfaces, their tendency to form micelles as well as their wetting properties, were considered in the light of their microscopic properties. For this purpose, the components and parameters of the surfactant tail and head, water and solids surface tension, and surfactant contactable area with adherent medium were applied for prediction of surfactant-surfactant and surfactant-solid interactions through the water phase with regard to their adsorption, micellization, and wetting processes. Next, the Gibbs free energy of interactions was compared to the Gibbs free energy of surfactant adsorption at the water-air and solid-water interfaces as well as the micellization. It appeared that from the surfactant-surfactant and surfactant-solid interactions through the water phase determined on the basis of the tail and head of surfactant surface tension, it is possible to predict the surfactant tendency to adsorb at the water-air and solid-water interfaces, as well as to form micelles.