Keigo Taniguchi

Validity of fascicle length estimation in the vastus lateralis and vastus intermedius using ultrasonography

The purpose of this study was to determine the validity of fascicle length estimation in the vastus lateralis (VL) and vastus intermedius (VI) using ultrasonography. The fascicle lengths of the VL and VI muscles were measured directly (dFL) using calipers, and were estimated (estmFL) using ultrasonography, in 10 legs from five Thiels embalmed cadavers. To determine the validity of the estmFLs, FL was estimated using five previously published models and compared with dFL. The intraclass correlation coefficients (ICCs) of two of the five models were>0.75, indicating that these estimates were valid. Both of these models combined measurement of the length of the visible part of the fascicle with linear extrapolation of the length of the part of the fascicle that was not visible on the sonographic image. The ICCs and absolute% difference were best in models that used appropriate pennation angles. These results suggest that two of the five previously published models are valid for obtaining estmFL of the VL and VI using ultrasonography.

Analysis of Muscle Activity and Ankle Joint Movement During the Side-Hop Test

Yoshida, M, Taniguchi, K, and Katayose, M. Analysis of muscle activity and ankle joint movement during the side-hop test. J Strength Cond Res 25(8): 2255-2264, 2011—Functional performance tests (FPTs) that consist of movements, such as hopping, landing, and cutting, provide useful measurements. Although some tests have been established for kinematic studies of the knee joint, very few tests have been established for the ankle joint. To use the FPT as a test battery for patients with an ankle sprain, it is necessary to document typical patterns of muscle activation and range of motion (ROM) of the ankle joint during FPTs. Therefore, the purpose of this study was to investigate the pattern of the ROM of the ankle inversion/eversion and the muscle activity of the peroneus longus muscle (PL) and the tibial anterior muscle (TA) in normal subjects during the side-hop test. To emphasize the characteristics of ROM and electromyography (EMG) at each phase, the side-hop tests were divided into 4 phases: lateral-hop contact phase (LC), lateral-hop flight phase (LF), medial hop contact phase (MC), and medial hop flight phase (MF), and the ROM of ankle inversion/eversion, a peak angle of ankle inversion, and Integral EMG (IEMG) of PL and TA compared among 4 phases. Fifteen male subjects with no symptoms of ankle joint problems participated in this research. The ROM of ankle inversion/eversion during the side-hop test was 27 ± 3.8° (mean ± SD), and there was a significant difference in the ROM of ankle inversion/eversion among 4 phases (p < 0.05). The phase in which the widest ROM was presented was the MF. A peak angle of the ankle inversion at MC was significantly greater than at LC and MF (p <0.05). A peak angle of the ankle inversion at LF was significantly greater than at LC and MF. The PL remained contracting with 50-160% of maximal voluntary contraction (MVC). The IEMGs of PL in both the contact phases were significantly greater than in both the flight phases (p < 0.05). In addition, the PL activity at LC was significantly greater than at MC. The TA remained contracting at 50-80% of MVC through the side-hop test. The IEMG of TA at both the contact phases was significantly greater than at 2 flight phases. However, there was no significant difference between LC and MF. Results of this study could be useful as basic data when evaluating the validity of the side-hop test for patients with ankle sprain.

A Multi-modality Approach Towards Elucidation of the Mechanism for Human Achilles Tendon Bending During Passive Ankle Rotation

The in vitro unconstrained Achilles tendon is nearly straight, while in vivo experiments reveal that the proximal region of the Achilles tendon, adjacent to Kager’s fat pad, bends ventrally during plantarflexion but remains nearly straight during dorsiflexion. Tendon bending is an important factor in determining the displacement of the foot compared to the shortening of the muscle fibers. The objective of this study was to elucidate the various mechanisms that could cause tendon bending, which currently remain unknown. Examination of Thiel-embalmed cadavers, with preservation of native articular joint mobility, revealed that the Achilles tendon still bent ventrally even when its surrounding tissues, including the skin surface, Kager’s fat pad, and distal portions of the soleus muscle were removed. Shear modulus and collagen fiber orientation were distributed homogeneously with respect to the longitudinal line of the tendon, minimizing their causative contributions to the bending. Given that tendon bending is not caused by either the nature of the deformations of the tissues surrounding the Achilles tendon or its physical properties, we conclude that it results from the geometric architecture of the Achilles tendon and its configuration with respect to the surrounding tissues.

Estimation of quadriceps femoris muscle dysfunction in the early period after surgery of the knee joint using shear-wave elastography

Objectives Orthopaedic surgery of the knee joint results in functional deterioration of the quadriceps femoris muscle. However, little is known about quadriceps femoris muscle dysfunction in the early postsurgical period. Therefore, we examined the stiffness of the quadriceps femoris muscle in the early postsurgical period. Methods Seven patients and seven healthy controls performed quadriceps contraction exercises. In resting and contraction conditions, the shear modulus, muscle thickness and pennation angle were measured for the vastus medialis (VM), vastus lateralis (VL) and the rectus femoris (RF) using ultrasound elastography. Results The shear moduli of the VM, VL and RF in the control group did not significantly interact, while the shear moduli in the patient group did show a significant interaction. In the resting condition, there was no difference between the unaffected and affected sides in the patient group, but the shear moduli of the VM and VL in the contraction condition was significantly lower on the affected side than the unaffected side. The contraction ratios between muscles by limbs did not significantly interact. However, there were main effects due to muscle and limb factors. The VM and VL had a significantly higher contraction ratio than the RF, and the control and unaffected limbs had a higher contraction ratio than the affected limb. Conclusion The results demonstrated a decrease in muscle stiffness during contraction in patients with quadriceps femoris dysfunction. Measurement of the shear modulus has potential as a new evaluation index and with high sensitivity to decreases in muscle contraction.

THREE-DIMENSIONAL ANALYSIS OF THE TIBIOTALAR JOINT OF INTACT MALE FEET UNDER UNLOADED AND AXIAL-LOADED CONDITIONS

Purpose: We investigated the distribution of three-axis rotational directions of the tibiotalar joint in intact feet under axial loading and categorized them according to the combinations of the three-axis rotational directions of the tibiotalar joint as three-dimensional (3D) rotational patterns. Methods: The differences in rotational orientation of the talus relative to the tibia under unloaded and axial-loaded conditions were calculated from the 3D models of the tibiotalar joint that were reconstructed from magnetic resonance (MR) images in 27 intact male feet. Results: In the sagittal plane, the talus rotated into plantarflexion in 63% of the feet and into dorsiflexion in 30%. In the coronal plane, the talus rotated into inversion in 37% of the feet and into eversion in 33%. In the transverse plane, the talus rotated into adduction in 85% of the feet and into abduction in 4%. A total of 10 3D tibiotalar joint rotational patterns were observed under axial loading. There were no significant differences in the frequencies of the 10 tibiotalar joint rotational patterns (p > 0.05). Conclusions: The 3D tibiotalar joint rotational patterns under axial loading were consolidated into 10 directions, which provides insight into the subject-specific kinematics of the tibiotalar joint.