Kerstina Ohlsson

An assessment of neck and upper extremity disorders by questionnaire and clinical examination

To study the usefulness of a screening questionnaire for neck/upper extremity complaints, 165 women in either repetitive industrial, or mobile and varied work, were studied by the questionnaire and by a detailed clinical physical examination. A total of 94 subjects recorded complaints in the questionnaire. In 140 subjects findings were recorded at the examination. Most subjects with findings at the clinical examination of shoulders reported complaints in the questionnaire (sensitivity 80%). For the other anatomical regions, the sensitivity was rather low (42-65%). For all regions, most subjects without findings reported no complaints (specificity 77-97%). A total of 75 subjects were given clinical diagnoses according to a set of predetermined diagnostic criteria. The capacity of the questionnaire to identify diagnoses of shoulders was higher (sensitivity 92%) than for the other regions (66-79%). Of subjects who did not qualify for diagnosis, a majority (specificity 71-81%) did not report complaints in the questionnaire. We conclude that the questionnaire approach gives a fairly good picture of the neck/upper extremity status of a working female population. However, a clear view of the size of a problem is obtained only by a detailed clinical examination, particularly as regards the neck, elbows and hands, for which the questionnaire gave an underestimate.

Goniometer measurement and computer analysis of wrist angles and movements applied to occupational repetitive work

In epidemiological studies of occupational musculoskeletal disorders there is a need for quantitative exposure measurements of the physical work load. In studies of neck and upper limb disorders the so-called cumulative trauma disorders (CTDs), in particular the carpal tunnel syndrome, the positions and movements of the wrist are of special interest. A biaxial flexible electrogoniometer was used to measure continuously, with a sampling rate of 20 Hz, wrist flexion/extension and abduction/adduction angles up to 27 min. Evaluation of the influence of rotation on the goniometer showed some inherent crosstalk, which, however, did not invalidate the results. For occupational repetitive work, 99.5% of the signal power was contained in the 0-5 Hz band. Two-dimensional angle distributions and power spectra gave comprehensive information about wrist postures and movements. Measures reflecting both static and dynamic properties were derived from time and frequency domains. These measures give quantitative information on different potential risk factors and are therefore useful in epidemiological studies. Mean power frequency (MPF) is suggested as a generalized measure of repetitiveness. The method was applied in field studies of fish processing industry workers with highly repetitive work and risk of CTD.

Disorders of the neck and upper limbs in women in the fish processing industry

OBJECTIVE--The aim was to study the association between personal factors and physical and psychosocial work environment factors and disorders of the neck or upper limbs among women in the fish processing industry. METHODS--A cross sectional study was performed on 206 women in the fish processing industry and 208 control women. Several physical and psychosocial work environment factors were evaluated. Subjective complaints about the neck or upper limbs were assessed by questionnaire and by a clinical examination. RESULTS--The study showed a high prevalence (35%) of diagnoses in the neck or shoulders of the exposed women. All prevalence odds ratios (PORs) were substantially higher in young women. There was a pronounced dose-response relation between disorders of the neck or shoulders and duration of employment for women < 45 years old. When studying 322 former workers, the proportion who claimed musculoskeletal complaints as the reason for leaving was highest among the older women. Muscular tension, stress or worry, work strain, and the largest fraction of the work time spent with highly repetitive work tasks were clearly associated with disorders of the neck or shoulders. The measurements of the wrist movements also showed that the work was performed almost without any pauses and that the median flexion and extension velocity was high (41 degree/s). The results of observation showed good agreement with the measurements of wrist motion. CONCLUSION--Work in the fish processing industry is a risk factor for disorders of the neck and upper limbs. Due to the homogenity of the physical work load in the exposed group, we could not show any associations between the objective measurements and disorders. In cross sectional studies the risk may be underestimated due to a healthy worker effect.

Sensitivity of trapezius electromyography to differences between work tasks — influence of gap definition and normalisation methods

Surface electromyography (EMG) has been used extensively to estimate muscular load in studies of work related musculoskeletal disorders, especially for the trapezius muscle. The occurrences of periods of EMG silence (gaps), the time below a predetermined threshold level (muscular rest) and various percentiles of the amplitude distribution (APDF) are commonly used summary measures. However, the effects of the criteria used to calculate these measures (e.g., gap duration, threshold level, normalisation method) on the sensitivity of these measures to accurately differentiate work loads is not well known. Bilateral trapezius EMG was recorded, for a full workday, for 58 subjects following both maximal (MVE) and submaximal (RVE) reference contractions. Gap frequency, muscular rest, and percentiles were derived for eight fundamental work tasks. The calculations were performed using different gap duration criteria, threshold levels and normalisation methods.A gap duration of less than 1/2 s, and threshold level approximately 0.3% MVE for gap frequency, and approximately 0.5% MVE for muscular rest, were the criteria that optimised sensitivity to task differences. Minimal sensitivity to tasks and a high sensitivity to individuals was obtained using gap frequency with a threshold level of approximately 1% MVE. Normalisation to RVE, rather than MVE, improved sensitivity to differences between tasks, and reduced undesirable variability. Muscular rest was more sensitive to task differences than APDF percentiles.

Fish processing work: the impact of two sex dependent exposure profiles on musculoskeletal health

OBJECTIVES: To evaluate the impact of work tasks, physical exposure, and psychosocial factors on the risk of musculoskeletal disorders in men and women, in a defined industrial setting. METHODS: 116 male and 206 female fish industry workers were compared with 129 men and 208 women with more varied work. Physical and psychosocial work load as well as musculoskeletal complaints were recorded by a questionnaire. A physical examination was performed and an observation method was used for work evaluation. 196 male and 322 female former fish processing workers received a postal questionnaire. RESULTS: The women workers in the fish industry had worse working conditions than the men for repetitiveness, constrained neck postures, and psychosocial work environment. They also had higher prevalences of complaints of the neck and shoulder (prevalence odds ratio (POR) 1.9; 95% confidence interval (95% CI) 1.1 to 3.2), neck and shoulder and elbow and hand complaints (POR 2.9; 95% CI 1.8 to 4.7 and POR 2.8; 95% CI 1.6 to 4.7, respectively). The women more often than the men left the industry because of neck and upper limb complaints. Also, women in other work had a higher prevalence of complaints of the neck and shoulder (POR 2.3; 95% CI 1.1 to 5.1) than the men. The men in the fish processing industry had a higher prevalence of complaints of the neck and shoulder than the men in other work (POR 3.6; 95% CI 1.6 to 8.0). This difference was not shown up by the questionnaire. CONCLUSIONS: Despite superficially similar work, there were clear sex differences in physical exposure and psychosocial work environment. Work in the fish processing industry was associated with a high risk of neck and upper limb disorders in women, which was probably mainly due to their extremely repetitive work tasks; the corresponding men had less repetitive work and less disorders. Also, a healthy worker effect on neck and upper limb disorders was found. The advantage of a physical examination compared with a questionnaire is clearly shown.

Muscular rest and gap frequency as EMG measures of physical exposure : the impact of work tasks and individual related factors

Owing to an orderly recruitment of motor units, low threshold type I fibres are presumed to be vulnerable in contractions of long duration. To study load on these fibres muscular rest was registered as the time fraction of electromyographic (EMG) activity below a threshold. Moreover, the frequency of periods with muscular rest, EMG gaps, was derived, since a low gap frequency has been shown to be a risk factor for musculoskeletal disorders. Trapezius EMG was registered in 24 female hospital cleaners, 21 female office workers and 13 male office workers during one working day. Cleaners have a high risk of neck/shoulder pain and had much less muscular rest than office workers measured as a percentage of total registered time (median value= 1.5%, range= 0.2-13% vs. median value= 12%, range= 0.0-32%, respectively). Gap frequency showed no difference between the two occupational groups. Both measures displayed a wide inter-individual variation. For the cleaners, some of the variance was explained by body mass index (BMI) and age, with lower values of muscular rest for older subjects with a high BMI. Among the office workers, low values of muscular rest and a high gap frequency were registered in subjects with a low subjective muscular tension tendency. Gender, strength, smoking, job strain, employment time and musculoskeletal symptoms had no impact on either EMG measure.

Impact of physical exposure on neck and upper limb disorders in female workers

Physical workload [muscular load of the trapezius and infraspinatus muscles using electromyography (EMG), wrist positions and movements by electrogoniometers] and neck and upper limb disorders (from, for example, a physical examination) were studied in women with repetitive industrial work (n = 95) and referents (n = 74). The repetitive work displayed higher ratings for wrist movements, but not for EMG. The prevalences of neck, shoulder and wrist/hand disorders were elevated for women with repetitive work [age-adjusted prevalence odds ratios (PORs) 2.0-7.5]. For the left hand, high frequency of wrist movements (mean power frequency 0.53 Hz) was associated with a high prevalence of disorders (56%), as compared to low (0.28 Hz and 26%; POR 3.5). We found no consistent and significant effect of muscular load, on either neck or shoulder disorders. However, selection and other bias may have diminished our possibility to observe such effects. Psychosocial work environment factors were not confounding the results. Measurements of wrist movements may be used for identification of high-risk work tasks.

Risk of musculoskeletal disorders among females and males in repetitive/constrained work

This paper combines epidemiological data on musculoskeletal morbidity in 40 female and 15 male occupational groups (questionnaire data 3720 females, 1241 males, physical examination data 1762 females, 915 males) in order to calculate risk for neck and upper limb disorders in repetitive/constrained vs. varied/mobile work and further to compare prevalence among office, industrial and non-office/non-industrial settings, as well as among jobs within these. Further, the paper aims to compare the risk of musculoskeletal disorders from repetitive/constrained work between females and males. Prevalence ratios (PR) for repetitive/constrained vs. varied/mobile work were in neck/shoulders: 12-month complaints females 1.2, males 1.1, diagnoses at the physical examination 2.3 and 2.3. In elbows/hands PRs for complaints were 1.7 and 1.6, for diagnoses 3.0 and 3.4. Tension neck syndrome, cervicalgia, shoulder tendonitis, acromioclavicular syndrome, medial epicondylitis and carpal tunnel syndrome showed PRs > 2. In neck/shoulders PRs were similar across office, industrial and non-office/non-industrial settings, in elbows/hands, especially among males, somewhat higher in industrial work. There was a heterogeneity within the different settings (estimated by bootstrapping), indicating higher PRs for some groups. As in most studies, musculoskeletal disorders were more prevalent among females than among males. Interestingly, though, the PRs for repetitive/constrained work vs. varied/mobile were for most measures approximately the same for both genders. In conclusion, repetitive/constrained work showed elevated risks when compared to varied/mobile work in all settings. Females and males showed similar risk elevations. This article enables comparison of risk of musculoskeletal disorders among many different occupations in industrial, office and other settings, when using standardised case definitions. It confirms that repetitive/constrained work is harmful not only in industrial but also in office and non-office/non-industrial settings. The reported data can be used for comparison with future studies.

Electromyographic fatigue in neck/shoulder muscles and endurance in women with repetitive work

EMG was recorded with surface electrodes from the trapezius and deltoid muscles during a static endurance test at approximately 20% of maximal voluntary contraction. Objective parameters for localized muscular fatigue were derived from the time course of the root mean square (RMS) and mean power frequency (MPF) of the EMG recordings. Isotonic regression is introduced as a tool for assessment of such parameters. The most pronounced sign of fatigue for trapezius was an increase in the RMS values, while for deltoid it was a decrease in the MPF values. This could be explained by the different functions of the two muscles. The endurance time for a group of 11 women in industrial work with repetitive short-cycled work tasks who were diagnosed with neck/shoulder disorders (tension neck) was significantly shorter (p less than 0.05) than for a group with the same work, but without neck/shoulder disorders (n = 11), and shorter than for a control group (n = 11). Regarding the EMG fatigue measures, there were no significant differences between the three groups. We did not find any relationships between endurance time and the EMG parameters. The results indicate that neck/shoulder disorders were not associated with divergent mechanisms for developing fatigue in the muscles, as recorded with surface EMG.

Physical workload on neck and upper limb using two CAD applications.

The aim was to evaluate (1) the physical workload on neck and upper limb in computer-aided design (CAD) work; (2) the impact of two applications (PROFESSIONAL-CADAM and PRO/Engineering) and (3) two input devices (computer mouse and keyboard), as well as (4) sitting and standing work positions. Fifteen CAD operators were interviewed and examined physically. For nine subjects, the physical workload was measured: electromyography (EMG) of trapezius and forearm extensor muscles, inclinometry of the head, the upper back and upper arms, as well as wrist goniometry. The muscular load was low in CAD work, but the inter-individual variation was considerable. Neither the positions were extreme, nor the movements. The applications, per se, did not have a large impact on the workload, but because of the need for different input devices the effect was strong. Using a keyboard meant higher angular velocities than using a mouse. Hence, when choosing a new software, which requires mainly a mouse as input device, this has to be balanced against the risk of disorders.