Kirsty J. Shaw

Rapid PCR amplification using a microfluidic device with integrated microwave heating and air impingement cooling

A microwave heating system is described for performing polymerase chain reaction (PCR) in a microfluidic device. The heating system, in combination with air impingement cooling, provided rapid thermal cycling with heating and cooling rates of up to 65 degrees C s(-1) and minimal over- or under-shoot (+/-0.1 degrees C) when reaching target temperatures. In addition, once the required temperature was reached it could be maintained with an accuracy of +/-0.1 degrees C. To demonstrate the functionality of the system, PCR was successfully performed for the amplification of the Amelogenin locus using heating rates and quantities an order of magnitude faster and smaller than current commercial instruments.

Comparison of the effects of sterilisation techniques on subsequent DNA profiling.

It is important that contamination from extraneous DNA should be minimised on items used at crime scenes and when dealing with exhibits within the laboratory. Four sterilisation techniques (UV, gamma and beta radiation and ethylene oxide treatment) were examined for their potential to degrade contaminating DNA to such an extent that subsequent DNA profiling was impossible. This work indicated that the most successful technique to reduce DNA contamination was ethylene oxide treatment. Of the radiation techniques tested in this study, gamma was the most successful at eradicating DNA and UV radiation was the least. None of the contaminated samples treated with ethylene oxide and subsequently subjected to DNA analysis met the DNA profile criteria necessary for acceptance on the UK National DNA Database. Contaminated cotton swabs and micro-centrifuge tubes treated with ethylene oxide showed a marked decrease in amplifiable DNA post-treatment. Ethylene oxide treatment to sterile swabs and tubes did not significantly affect subsequent DNA analysis.

The use of carrier RNA to enhance DNA extraction from microfluidic-based silica monoliths

DNA extraction was carried out on silica-based monoliths within a microfluidic device. Solid-phase DNA extraction methodology was applied in which the DNA binds to silica in the presence of a chaotropic salt, such as guanidine hydrochloride, and is eluted in a low ionic strength solution, such as water. The addition of poly-A carrier RNA to the chaotropic salt solution resulted in a marked increase in the effective amount of DNA that could be recovered (25ng) compared to the absence of RNA (5ng) using the silica-based monolith. These findings confirm that techniques utilising nucleic acid carrier molecules can enhance DNA extraction methodologies in microfluidic applications.

Development of a bi-functional silica monolith for electro-osmotic pumping and DNA clean-up/extraction using gel-supported reagents in a microfluidic device

A silica monolith used to support both electro-osmotic pumping (EOP) and the extraction/elution of DNA coupled with gel-supported reagents is described. The benefits of the combined EOP extraction/elution system were illustrated by combining DNA extraction and gene amplification using the polymerase chain reaction (PCR) process. All the reagents necessary for both processes were supported within pre-loaded gels that allow the reagents to be stored at 4 degrees C for up to four weeks in the microfluidic device. When carrying out an analysis the crude sample only needed to be hydrodynamically introduced into the device which was connected to an external computer controlled power supply via platinum wire electrodes. DNA was extracted with 65% efficiency after loading lysed cells onto a silica monolith. Ethanol contained within an agarose gel matrix was then used to wash unwanted debris away from the sample by EOP (100 V cm(-1) for 5 min). The retained DNA was subsequently eluted from the monolith by water contained in a second agarose gel, again by EOP using an electric field of 100 V cm(-1) for 5 min, and transferred into the PCR reagent containing gel. The eluted DNA in solution was successfully amplified by PCR, confirming that the concept of a complete self-contained microfluidic device could be realised for DNA sample clean up and amplification, using a simple pumping and on-chip reagent storage methodology.

Simple practical approach for sample loading prior to DNA extraction using a silica monolith in a microfluidic device

A novel DNA loading methodology is presented for performing DNA extraction on a microfluidic system. DNA in a chaotropic salt solution was manually loaded onto a silica monolith orthogonal to the subsequent flow of wash and elution solutions. DNA was successfully extracted from buccal swabs using electro-osmotic pumping (EOP) coupled with in situ reagents contained within a 1.5% agarose gel matrix. The extracted DNA was of sufficient quantity and purity for polymerase chain reaction (PCR) amplification.

Integrated RNA extraction and RT-PCR for semi-quantitative gene expression studies on a microfluidic device

This paper describes the development of a microfluidic methodology, using RNA extraction and reverse transcription PCR, for investigating expression levels of cytochrome P450 genes. Cytochrome P450 enzymes are involved in the metabolism of xenobiotics, including many commonly prescribed drugs, therefore information on their expression is useful in both pharmaceutical and clinical settings. RNA extraction, from rat liver tissue or primary rat hepatocytes, was performed using a silica-based solid-phase extraction technique. Following elution of the purified RNA, amplification of target sequences for the housekeeping gene, glyceraldehyde-3-phosphate dehydrogenase (GAPDH) and the cytochrome P450 gene CYP1A2, was carried out using a one-step reverse transcription PCR. Once the microfluidic methodology had been optimized, analysis of control and 3-methylcholanthrene-induced primary rat hepatocytes were used to evaluate the system. As expected, GAPDH was consistently expressed, whereas CYP1A2 levels were found to be raised in the drug-treated samples. The proposed system offers an initial platform for development of both rapid throughput analyzers for pharmaceutical drug screening and point-of-care diagnostic tests to aid provision of drug regimens, which can be tailor-made to the individual patient.

Improved DNA extraction efficiency from low level cell numbers using a silica monolith based micro fluidic device

The evaluation of a micro fluidic system with an integrated silica monolith for performing DNA extraction from limited biological samples has been carried out. Low DNA target concentrations usually require the addition of carrier RNA to ensure desired extraction efficiencies. Here, we demonstrate a micro fluidic extraction system with increasingly efficient extraction performances for biological samples containing <15 ng of total DNA without the need of adding carrier nucleic acids. All extracted DNA showed successful amplification via the polymerase chain reaction demonstrating both the effectiveness of the proposed system at removing potential inhibitors and yielding good quality DNA. The work presented here beneficially identifies reduced sample volumes/concentrations as suitable for processing with respect to downstream analysis by enabling pre-concentration of the biological sample, particularly important when dealing with clinical or forensic specimens.

Integrated DNA extraction and amplification using electrokinetic pumping in a microfluidic device

An integrated system employing anion exchange for the extraction of DNA from biological samples prior to polymerase chain reaction DNA amplification has been developed, based on microfluidic methodology utilising electrokinetic pumping. In this system, the biological samples were added directly to chitosan-coated silica beads to facilitate DNA immobilisation. The purified, pre-concentrated DNA was then eluted using a combination of electro-osmotic flow enhanced with electrophoretic mobility, which enable DNA to be transported by both mechanisms into the DNA amplification chamber. Through optimisation of the DNA elution conditions, average DNA extraction efficiencies of 69.1% were achievable. Subsequent DNA amplification performed on the microfluidic system demonstrated not only the ability to use electrokinetic movement to integrate the two processes on a single device, but also that the quality and quantity of DNA eluted was suitable for downstream analysis. This work offers an attractive real-world to chip interface and a route to simpler Lab-on-a-Chip technology which eliminates the need for moving parts.

Microsystems for personalized biomolecular diagnostics

The development of microfluidic methodology that can be used in conjunction with drug screening and biomolecular diagnostics offers a route to evidence‐based personalized medical care. Ideally, all personal diagnostics are best carried out in a rapid and frequent manner and a microfluidic interface can provide appropriate methodology. The ability to perform genetic analysis or biomarker detection at point‐of‐care would allow the clinician to decide on the most informed course of treatment. Microfluidic systems for biomolecular analysis at all levels, from genes to whole tissue biopsies, have been proposed. Much of the work presented here is at an early stage of development but will consider the range of design considerations together with the plethora of potential applications of integrated microfluidic technology.

Direct processing of clinically relevant large volume samples for the detection of sexually transmitted infectious agents from urine on a microfluidic device

Urine is a preferred specimen for nucleic acid-based detection of sexually transmitted infections (STIs) but represents a challenge for microfluidic devices due to low analyte concentrations. We present an extraction methodology enabling rapid on-chip nucleic acid purification directly from clinically relevant sample volumes up to 1 ml and subsequent PCR amplification detection.