Kjeld Larsen

Volatile metabolites from mold growth on building materials and synthetic media

Mold species which were isolated from damp buildings were grown on sterile building materials and some synthetic media in order to study the microbial volatile organic compounds produced. Patterns of the microbial volatile organic compounds (MVOC) were very media dependent but media which favor terpene biosynthesis may give patterns unique enough for identification of dominant indoor molds.

Acute airway effects of ozone-initiated d-limonene chemistry : Importance of gaseous products

There are concerns about ozone-initiated chemistry, because the formation of gaseous oxidation products and ultrafine particles may increase complaints, morbidity and mortality. Here we address the question whether the gaseous products or the ultrafine particles from the ozone-initiated chemistry of limonene, a common and abundant indoor pollutant, cause acute airway effects. The effects on the airways by d-limonene, a ca. 16s old ozone/d-limonene mixture, and clean air were evaluated by a mice bioassay, from which sensory irritation of the upper airways, airflow limitation, and pulmonary irritation can be obtained. A denuder was inserted to separate the ultrafine particles from the gaseous products prior to the exposure chamber. Reduction of mean respiratory frequency (>30%) and 230% increase of time of brake were observed without denuder, during 30min exposure, to the ozonolyzed d-limonene mixture, which are indicative of prominent sensory effects. The initial concentrations (ppm) were 40 d-limonene and 4 ozone. The exposure concentrations (ppm) were about 35 d-limonene and 0.05 ozone. Formaldehyde and residual d-limonene, the salient sensory irritants, accounted for up to three-fourth of the sensory irritation. The upper airway effects reversed to baseline upon cessation of exposure. An effect on the conducting airways was also significant, which did not reverse completely upon cessation. Airway effects were absent with the denuder inserted, which did not alter the size distribution of ultrafine particles ( approximately 10mg/m(3)), significantly. The result was statistically indistinguishable from clean dry air. It is concluded that ultrafine particles that are generated from ozone-initiated d-limonene chemistry and denuded are not causative of sensory effects in the airways.

Variation of volatile organic compound patterns of mold species from damp buildings

The use of volatile organic compounds (VOCs) to detect mold growth in damp buildings depends on a comprehensive knowledge of the biosynthetic pathways available to indoor molds as well as their biological variation. Recent reports concerning (VOCs) formed during the growth of molds from damp buildings on laboratory substrates indicate considerable variation, presumably because of the sensitivity of mold VOC biosynthesis to environmental conditions or large biological variation.

Volatile organic compounds from garden waste

Abstract About 170 compounds were identified in the headspace or liquid exudate from garden waste. Typical for microbiological growth were branched and straight chain alcohols, carboxylic acids and esters C 2 –C 8 . Several of the substances have been identified in early studies of compost For some waste samples the organosulfur compound concentration (C 1 and C 3 mono-, di- and trisulfides) was ca. 10 mg/m 3 which suggests that these substances may contribute to mucous membrane irritation or nausea reported by waste collection personnel.

Use of thermal desorption gas chromatography-olfactometry/mass spectrometry for the comparison of identified and unidentified odor active compounds emitted from building products containing linseed oil

The emission of odor active volatile organic compounds (VOCs) from a floor oil based on linseed oil, the linseed oil itself and a low-odor linseed oil was investigated by thermal desorption gas chromatography combined with olfactometry and mass spectrometry (TD-GC-O/MS). The oils were applied to filters and conditioned in the micro emission cell, FLEC, for 1-3days at ambient temperature, an air exchange rate of 26.9h(-1) and a 30% relative humidity. These conditions resulted in dynamic headspace concentrations and composition of the odor active VOCs that may be similar to real indoor setting. Emission samples for TD-GC-O/MS analysis from the FLEC were on Tenax TA. Although many volatile VOCs were detected by MS, only the odor active VOCs are reported here. In total, 142 odor active VOCs were detected in the emissions from the oils. About 50 of the odor active VOCs were identified or tentatively identified by GC-MS. While 92 VOCs were detected from the oil used in the floor oil, only 13 were detected in the low-odor linseed oil. The major odor active VOCs were aldehydes and carboxylic acids. Spearmen rank correlation of the GC-O profiles showed that the odor profile of the linseed oil likely influenced the odor profile of the floor oil based on this linseed oil.

Detection of indoor PCB contamination by thermal desorption of dust. A rapid screening method

Although PCB in caulking materials has been forbidden for many years in most of Europe, including Denmark, there has been continued interest to measure PCB levels in the air of contaminated buildings and blood of the occupants (Mengon and Schlatter 1993, Fromme et al. 1996, Ewers et al. 1998, Currado and Harrad 1998, Gabrio et al. 2000). The relatively low priority for investigations of this contamination is probably due to the small quantities inhaled compared to exposure via food, and the rapid metabolism of the most volatile congeners demonstrated by low concentrations of all congeners in the blood of exposed persons (Ewers et al. 1998, Gabrio et al. 2000). There is, however, evidence that PCB containing caulking materials have been used even during the ’90s (Fromme et al. 1996). In Denmark, it is estimated that 75 t PCB is still in buildings (Organization of Sealant Branch’s Manufacturers and Distributors 2000). During an investigation of dust from buildings with excessive microbial growth (including 35 rooms from 9 buildings), the analysis of semivolatile compounds by thermal desorption-GC/MS of samples from a single building surprisingly revealed large amounts of PCBs containing 3, 4 and 5 chlorine atoms, 10–20 times the amounts found in samples from other buildings. Extraction of the dust by SFE followed by GC/ECD analysis for 12 PCB congeners showed that there was ∼ 20 times the total PCB concentrations in dust from the polluted building compared to the levels in the other buildings. Subsequent headspace analysis of caulking material from the polluted building revealed this to be the source. Shelf dust functions as a passive sampling medium and, thus, can be used as a screening method to detect PCB and other semivolatile pollution indoors.