Konstantinos Papoutsis

Impact of different solvents on the recovery of bioactive compounds and antioxidant properties from lemon (Citrus limon L.) pomace waste

The effects of different solvents on the recovery of (i) extractable solids (ES), (ii) total phenolic compounds (TPC), (iii) total flavonoid content (TFC), (iv) vitamin C, and (v) antioxidant activity from lemon pomace waste were investigated. The results revealed that solvents significantly affected the recovery of ES, TPC, TFC, and antioxidant properties. Absolute methanol and 50% acetone resulted in the highest extraction yields of TPC, whereas absolute methanol resulted in the highest extraction of TFC, and water had the highest recovery of vitamin C. 50% ethanol, and 50% acetone had higher extraction yields for TPC, and TFC, as well as higher antioxidant activity compared with their absolute solvents and water. TPC and TFC were shown to be the major components contributing to the antioxidant activity of lemon pomace.

Enhancing the Total Phenolic Content and Antioxidants of Lemon Pomace Aqueous Extracts by Applying UV-C Irradiation to the Dried Powder

Several studies have shown that UV-C (ultraviolet C) irradiation promotes the bioactive compounds and antioxidants of fresh fruits and vegetables. The aim of this study was to apply UV irradiation in dried lemon pomace powder for enhancing its phenolic content and antioxidant properties, thus more bioactive compounds should be available for extraction and utilization. Lemon pomace dried powder was placed under a UV lamp and treated with dosages of 4, 19, 80 and 185 kJ·m−2, while untreated powder was used as a control. UV-C irradiation significantly affected the total phenolic content, total flavonoid content, proanthocyanidins, and antioxidant capacity measured by cupric reducing antioxidant capacity (CUPRAC) and ferric reducing antioxidant power (FRAP) of the lemon pomace dried powder, while it did not affect the vitamin C content. UV-C irradiation of 19 kJ·m−2 resulted in 19% higher total phenolic content than the control, while UV-C irradiation of 180 kJ·m−2 resulted in 28% higher total flavonoid content than the control. The antioxidant capacity was reduced when UV-C irradiation more than 4 kJ·m−2 was applied. The results of this study indicate that UV-C treatment has the potential to increase the extraction of bioactive compounds of dried lemon pomace at relatively high dosages.

Postharvest UV-C treatment combined with 1-methylcyclopropene 1 (1-MCP), followed by storage in continuous low level ethylene atmosphere improves the quality of tomatoes

ABSTRACT Mature green tomatoes (Solanum lycopersicum L. cv Neang Pich) were exposed to 13.6 kJ m−2 UV-C or 0.5 μL L−1 1-MCP or combination of 13.6 kJ m−2 UV-C and 0.5 μL L−1 1-MCP, with appropriate untreated controls. After treatment, tomatoes were stored in air containing 0.1 μL L−1 ethylene at 20°C and 100% RH. The untreated fruit ripened significantly faster than those of all other treatments. UV-C treatment alone was able to delay fruit ripening by up to 5 days longer compared to untreated fruits whilst the additional of 1-MCP further delayed fruit ripening. UV-C and 1-MCP treatments alone or in combination had significantly slower ethylene production rates throughout the storage period. The fruit treated with the combination of 1-MCP and UV-C was significantly firmer and had higher total phenolic content compared to that of the other treatments. However, there was no difference between treatments in soluble solids content/titratable acids ratio, chlorophyll content, lycopene content and total antioxidant activity. These results show that UV-C and 1-MCP treatment delay ripening and improve the quality of tomatoes in the presence of low-level ethylene during storage. This new treatment could be used to extend the shelf-life of mature green tomatoes through the supply chain without the use of refrigeration.

Pretreatment of citrus by-products affects polyphenol recovery: a review

ABSTRACT A large amount of citrus waste is generated annually. This waste is of great economic worth, since it contains high levels of polyphenols, which have attracted scientific interest due to their potent antimicrobial and antiradical activities. Pretreatment is a crucial step that precedes the extraction process and influences the yields and quality of polyphenols. This review emphasizes the effect of different drying processes, such as freeze drying, hot-air drying, vacuum drying, microwave drying, infrared drying, and high-speed drying, on the polyphenol retention in citrus by-products. Further treatments of the dried citrus by-products for assisting the liberation of bound polyphenols are also provided and comprehensively discussed.

Encapsulation of Citrus By-Product Extracts by Spray-Drying and Freeze-Drying Using Combinations of Maltodextrin with Soybean Protein and ι-Carrageenan

The effect of different combinations of maltodextrin (MD) coating agents (MD, MD + soybean protein, and MD + ι-carrageenan) on the encapsulation of lemon by-product aqueous extracts using freeze-drying and spray-drying were investigated. The total phenolic content (TPC), total flavonoid content (TFC), and ferric ion reducing antioxidant power (FRAP) of the microparticles were evaluated. Freeze-drying with the mixture of MD + soybean protein resulted in the highest retention of TPC, TFC, and FRAP (1.66 ± 0.02 mg GAE/g d.b., 0.43 ± 0.02 mg CE/g d.b., and 3.70 ± 0.05 mM TE/g, respectively). Freeze-drying resulted in microparticles with lower moisture content (MC) and water activity (aw) than those produced by spray-drying. Specifically, the MC and aw of the microparticles produced by freeze-drying ranged from 1.15 to 2.15% and 0.13 to 0.14, respectively, while the MC and aw of the microparticles produced by spray-drying ranged from 6.06% to 6.60% and 0.33 to 0.40, respectively. Scanning electron microscopy revealed that spray-drying resulted in the formation of spherical particles of different sizes regardless of the type of coating agent. Although freeze-drying resulted in microparticles with amorphous glassy shapes, the mixture of MD + soybean protein resulted in the formation of spherical porous particles. X-ray diffraction revealed a low degree of crystallinity for the samples produced by both techniques.