Lars Hagedorn Frandsen

Strained silicon as a new electro-optic material.

For decades, silicon has been the material of choice for mass fabrication of electronics. This is in contrast to photonics, where passive optical components in silicon have only recently been realized. The slow progress within silicon optoelectronics, where electronic and optical functionalities can be integrated into monolithic components based on the versatile silicon platform, is due to the limited active optical properties of silicon. Recently, however, a continuous-wave Raman silicon laser was demonstrated; if an effective modulator could also be realized in silicon, data processing and transmission could potentially be performed by all-silicon electronic and optical components. Here we have discovered that a significant linear electro-optic effect is induced in silicon by breaking the crystal symmetry. The symmetry is broken by depositing a straining layer on top of a silicon waveguide, and the induced nonlinear coefficient, χ(2) ≈ 15 pm V-1, makes it possible to realize a silicon electro-optic modulator. The strain-induced linear electro-optic effect may be used to remove a bottleneck in modern computers by replacing the electronic bus with a much faster optical alternative.

Photonic crystal waveguides with semi-slow light and tailored dispersion properties.

We demonstrate a concept for tailoring the group velocity and dispersion properties for light propagating in a planar photonic crystal waveguide. By perturbing the holes adjacent to the waveguide core it is possible to increase the useful bandwidth below the light-line and obtain a photonic crystal waveguide with either vanishing, positive, or negative group velocity dispersion and semi-slow light. We realize experimentally a silicon-on-insulator photonic crystal waveguide having nearly constant group velocity ~c(0)/34 in an 11-nm bandwidth below the silica-line.

A compact two-dimensional grating coupler used as a polarization splitter

We demonstrate a novel polarization splitter based on a two-dimensional grating etched in a silicon-on-insulator waveguide. The device couples orthogonal modes from a single-mode optical fiber into identical modes of two planar ridge waveguides. The extinction ratio is better than 18 dB in the wavelength range of 1530-1560 nm and the coupling efficiency is approximately 20%. The device is very compact and couples light only to transverse-electric modes of the planar waveguides. Therefore, it may be used in a polarization diversity configuration to implement a polarization insensitive photonic integrated circuit based on photonic crystal waveguides.

Photonic-crystal waveguide biosensor.

A photonic-crystal waveguide sensor is presented for biosensing. The sensor is applied for refractive index measurements and detection of protein-concentrations. Concentrations around 10 mug/ml (0.15muMolar) are measured with excellent signal to noise ratio, and a broad, dynamic refractive index sensing range extending from air to high viscous fluids is presented.

Topology optimization and fabrication of photonic crystal structures

Topology optimization is used to design a planar photonic crystal waveguide component resulting in significantly enhanced functionality. Exceptional transmission through a photonic crystal waveguide Z-bend is obtained using this inverse design strategy. The design has been realized in a silicon-on-insulator based photonic crystal waveguide. A large low loss bandwidth of more than 200 nm for the bandgap polarization is experimentally confirmed.

Comprehensive FDTD modelling of photonic crystal waveguide components

Planar photonic crystal waveguide structures have been modelled using the finite-difference-time-domain method and perfectly matched layers have been employed as boundary conditions. Comprehensive numerical calculations have been performed and compared to experimentally obtained transmission spectra for various photonic crystal waveguides. It is found that within the experimental fabrication tolerances the calculations correctly predict the measured transmission levels and other major transmission features.

Photonic crystal nanostructures for optical biosensing applications.

We present the design, fabrication and optical investigation of photonic crystal (PhC) nanocavity drop filters for use as optical biosensors. The resonant cavity mode wavelength and Q-factor are studied as a function of the ambient refractive index and as a function of adsorbed proteins (bovine serum albumin) on the sensor surface. Experiments were performed by evanescent excitation of the cavity mode via a PhC waveguide. This in turn is coupled to a ridge waveguide that allows the introduction of a fluid flow cell on a chip. A response of partial delta lambda/delta c=(4.54+/-0.66)x10(5)nm/M is measured leading to a measured detection limit as good as Delta m=4.0+/-0.6 fg or Delta m/Delta A=(4.9+/-0.7)x10(2)pg/mm(2)in the sensitive area.

Wavelength-division demultiplexing using photonic crystal waveguides

We demonstrate a new device concept for wavelength division demultiplexing based on planar photonic crystal waveguides. The filtering of wavelength channels is realized by shifting the cutoff frequency of the fundamental photonic bandgap mode in consecutive sections of the waveguide. The shift is realized by modifying the size of the border holes. Simulations and an experimental realization of a four-channel coarse wavelength division demultiplexer are described.

Ultralow-loss 3-dB photonic crystal waveguide splitter

A photonic crystal waveguide splitter that exhibits ultralow-loss 3-dB splitting for TE-polarized light is fabricated in silicon-on-insulator material by use of deep UV lithography. The high performance is achieved by use of a Y junction, which is designed to ensure single-mode operation, and low-loss 60 degrees bends. Zero-loss 3-dB output is experimentally obtained in the range 1560-1585 nm. Results from three-dimensional finite-difference time-domain modeling with no adjustable parameters are found to be in excellent agreement with the experimental results.

Silicon photonic crystal nanostructures for refractive index sensing

The authors present the fabrication and optical investigation of silicon on insulator photonic crystal drop filters for use as refractive index sensors. Two types of defect nanocavities (L3 and H1−r) are embedded between two W1 photonic crystal waveguides to evanescently route light at the cavity mode frequency between input and output waveguides. Optical characterization of the structures in air and various liquids demonstrates detectivities in excess of Δn/n=0.018 and Δn/n=0.006 for the H1−r and L3 cavities, respectively. The measured cavity frequencies and detector refractive index responsivities are in good agreement with simulations, demonstrating that the method provides a background free transducer signal with frequency selective addressing of a specific area of the sensor chip.