Laura A. MacManus-Spencer

Binding of perfluorocarboxylates to serum albumin: a comparison of analytical methods.

Perfluorochemicals are globally pervasive contaminants that are persistent, bioaccumulative, and toxic. Perfluorocarboxylic acids (PFCAs) with 8-13 carbons accumulate in the liver and blood of aquatic organisms; PFCA-protein interactions may explain this accumulation pattern. Here, the interactions between PFCAs with 8-11 carbons and serum albumin are examined using three experimental approaches: surface tension titrations, (19)F NMR spectroscopy, and fluorescence spectroscopy. Surface tension titrations indicate complex formation at high (mM) PFCA concentrations. Secondary association constants ranging from 10(2) to 10(4) M(-1) were determined from (19)F NMR titrations at high PFCA:albumin mole ratios. Fluorescence measurements indicate that PFCA-albumin interactions alter the protein conformation at low PFCA:albumin mole ratios (up to 5:1) and suggest two binding classes with association constants around 10(5) and 10(2) M(-1). While (19)F NMR and fluorescence provide both qualitative and quantitative information about PFCA-albumin interactions, surface tension provides only qualitative information. Limitations associated with instrumentation and methods require high PFCA concentrations in both surface tension and (19)F NMR experiments; in contrast, fluorescence allows for analysis of a wider range of PFCA concentrations and PFCA:albumin mole ratios. Results from this study indicate that fluorescence, though an indirect method, offers a more comprehensive picture of the nature of PFCA-albumin interactions.

Noncovalent Interactions of Long-Chain Perfluoroalkyl Acids with Serum Albumin

Preferential distribution of long-chain perfluoroalkyl acids (PFAAs) in the liver, kidney, and blood of organisms highlights the importance of PFAA-protein interactions in PFAA tissue distribution patterns. A serum protein association constant may be a useful parameter to characterize the bioaccumulative potential and in vivo bioavailability of PFAAs. In this work, association constants (K(a)) and binding stoichiometries for PFAA-albumin complexes are quantified over a wide range of PFAA:albumin mole ratios. Primary association constants for perfluorooctanoate (PFOA) or perfluorononanoate (PFNA) with the model protein bovine serum albumin (BSA) determined via equilibrium dialysis are on the order of 10(6) M(-1) with one to three primary binding sites. PFNA was greater than 99.9% bound to BSA or human serum albumin (HSA) at a physiological PFAA:albumin mole ratio (<10(-3)), corresponding to a high protein-water distribution coefficient (log K(PW) > 4). Nanoelectrospray ionization mass spectrometry (nanoESI-MS) data reveal PFAA-BSA complexes with up to eight occupied binding sites at a 4:1 PFAA:albumin mole ratio. Association constants estimated by nanoESI-MS are on the order of 10(5) M(-1) for PFOA and PFNA and 10(4) M(-1) for perfluorodecanoate and perfluorooctanesulfonate. The results reported here suggest binding through specific high affinity interactions at low PFAA:albumin mole ratios.

Strong associations of short‐chain perfluoroalkyl acids with serum albumin and investigation of binding mechanisms

Interactions of perfluoroalkyl acids (PFAAs) with tissue and serum proteins likely contribute to their tissue distribution and bioaccumulation patterns. Protein-water distribution coefficients (K(PW) ) based on ligand associations with bovine serum albumin (BSA) as a model protein were recently proposed as biologically relevant parameters to describe the environmental behavior of PFAAs, yet empirical data on such protein binding behavior are limited. In the present study, associations of perfluoroalkyl carboxylates (PFCAs) with two to 12 carbons (C₂-C₁₂) and perfluoroalkyl sulfonates with four to eight carbons (C₄, C₆, and C₈) with BSA are evaluated at low PFAA:albumin mole ratios and various solution conditions using equilibrium dialysis, nanoelectrospray ionization mass spectrometry, and fluorescence spectroscopy. Log K(PW) values for C₄ to C₁₂ PFAAs range from 3.3 to 4.3. Affinity for BSA increases with PFAA hydrophobicity but decreases from the C₈ to C₁₂ PFCAs, likely due to steric hindrances associated with longer and more rigid perfluoroalkyl chains. The C₄-sulfonate exhibits increased affinity relative to the equivalent chain-length PFCA. Fluorescence titrations support evidence that an observed dependence of PFAA-BSA binding on pH is attributable to conformational changes in the protein. Association constants determined for perfluorobutanesulfonate and perfluoropentanoate with BSA are on the order of those for long-chain PFAAs (K(a) ∼10⁶/M), suggesting that physiological implications of strong binding to albumin may be important for short-chain PFAAs.

Aqueous photolysis of the organic ultraviolet filter chemical octyl methoxycinnamate.

Organic UV filter chemicals are the active ingredients in personal care products designed to protect the skin from UV radiation, and hundreds of tons are estimated to be produced annually. Despite their entrance into the aquatic environment by both direct and indirect routes and their detection in surface waters and fish, little is known about their environmental fate. UV filter chemicals are designed to be photostable, but some undergo transformation upon exposure to UV light. Octyl methoxycinnamate (OMC), a commonly used UV filter chemical, degrades rapidly by direct photolysis; previous studies have focused on its photoisomerization, and a few investigators have reported the formation of cyclodimers. Here, we present the kinetics and quantum efficiency of the direct photolysis of OMC and confirm that dimerization occurs as a result of direct photolysis in aqueous solution. Likely identities of the dimers are offered based on comparison to reported results for other cinnamate derivatives. We have identified additional products of direct photolysis that have not been previously reported and investigated their photostability, as well as the mechanism of product formation. There is also some evidence of indirect photolysis in the presence of dissolved natural organic matter.

Pyridylpyrrolides as alternatives to cyclometalated phenylpyridine ligands: synthesis and characterization of luminescent zinc and boron pyridylpyrrolide complexesElectronic supplementary information (ESI) available: Beer?s Law plots and emission peak area vs. concentration plots for complexes; comparison of excitation and absorbance spectra; effect of triplet quencher isoprene on luminescence intensity. See http://www.rsc.org/suppdata/dt/b3/b315523d/

The synthesis, structure, and properties of six luminescent pyridylpyrrolide complexes and the first structural characterization of pyridylpyrrolide metal complexes are reported. A series of new zinc complexes, bis(pyridylpyrrolyl)zinc, (R2PyrPy)2Zn (R = Me, Et, iPr, tBu, and Ph), that vary in their substituents on the pyrrole ring (Me, Et, iPr, tBu, and Ph), were prepared. Pyrrole substitution produced small structural changes in the complexes and affected the fluorescence properties very little. The zinc complexes were found to be luminescent, emitting at 495 nm (Phi = 0.32, 0.32 0.31, 0.19 and 0.57, respectively). A boron analog, (Me2PyrPy)BF2, was prepared and was found to share the luminescent properties with the zinc complexes, emitting at 505 nm (Phi = 0.22), but not their water-sensitivity. A total of four crystal structures are reported, tBu2PyrPyH, (Me2PyrPy)2Zn, (tBu2PyrPy)2Zn, and (Me2PyrPy)BF2. tBu2PyrPyH crystallizes as a doubly hydrogen bonded dimer with non-coplanar pyridine and pyrrole rings. The solid-state structures of (Me2PyrPy)2Zn and (tBu2PyrPy)2Zn revealed that despite the large change in steric bulk, the two compounds have very similar structures. The structure of (Me2PyrPy)BF2 showed changes that are expected with the interaction between a smaller atom (B as compared to Zn). Molecular orbital calculations were performed on Me2PyrPyH, (Me2PyrPy)BF2, and (Me2PyrPy)2Zn using Gaussian 98 methods. It was found that the main transition (HOMO-LUMO) for all three molecules is a pi-->pi* transition and that in the inorganic complexes, the metal atom (zinc or boron) present has very little effect on transition, evidence that the optical properties are largely ligand based and that the B or Zn atoms main effect is lowering of the LUMO relative energy.

A liquid chromatographytandem mass spectrometry assay for the detection and quantification of trehalose in biological samples

Trehalose is an important disaccharide that is used as a cellular protectant by many different organisms, helping these organisms better survive extreme conditions, such as dehydration, oxidative stress, and freezing temperatures. Methods to detect and accurately measure trehalose from different organisms will help us gain a better understanding of the mechanisms behind trehaloses ability to act as a cellular protectant. A liquid chromatography-tandem mass spectrometry (LC-MS/MS) assay using selected reaction monitoring mode for the detection and quantification of trehalose using maltose as an internal standard has been developed. This assay uses a commercially available LC column for trehalose separation and a standard triple quadrupole mass spectrometer, thus allowing many scientists to take advantage of this simple assay. The calibration curve from 3 to 100μM trehalose was fit best by a single polynomial. This LC-MS/MS assay directly detects and accurately quantifies trehalose, with an instrument limit of detection (LOD) that is 2-1000 times more sensitive than the most commonly-used assays for trehalose detection and quantification. Furthermore, this assay was used to detect and quantify endogenous trehalose produced by Escherichia coli (E. coli) cells, which were found to have an intracellular concentration of 8.5±0.9mM trehalose. This method thus shows promise for the reliable detection and quantification of trehalose from different biological sources.

2-(2?-Pyridyl)pyrroles: Part I. Structure and energetics of pyridylpyrroles, their dimers, complexes and excited statesElectronic supplementary information (ESI) available: NOESY spectra for Me2PyrPy and 1?1 Me2PyrPy?MeOH (Figs. 1S and 2S). See http://www.rsc.org/suppdata/cp/b4/b401824a/

Structural and energetic evaluations of substituted 2-(2′-pyridyl)pyrroles were performed through a combination of computational and experimental methods. In conjunction with experimental absorbance and fluorescence studies, the data were analyzed with respect to hydrogen bonding ability, complex formation with alcohols, dimerization, excited state behavior, and potential for proton transfer. Experimental and theoretical evidence show the importance of the pyrrole substituent groups in both structural and spectral properties of the molecules and their complexes. Low temperature NMR experiments and full solution phase DFT optimizations support the formation of a cyclically bridged alcohol complex for the 3,5-dimethyl-2-(2′-pyridyl)pyrrole species with a nearly coplanar ring system, whereas the full DFT optimization of the 3,5-di-tert-butyl-2-(2′-pyridyl)pyrrole:methanol complex shows a break in the planarity of the ring system.

2-(2?-Pyridyl)pyrroles: Part II. Spectroscopic investigation of pyridylpyrrole alcohol complexesElectronic supplementary information (ESI) available: Titration data fit with single or double complexation model (Figs. S1?S8). See http://www.rsc.org/suppdata/cp/b4/b401859c/

A homologous series of 2-(2′-pyridyl)pyrroles were studied as a possible model system for intermolecular hydrogen bonding interactions in molecules that can act as both hydrogen bond donors and acceptors. Steady state spectroscopic methods were used to assess the importance of intermolecular hydrogen bonding interactions in dilute solutions of 2-(2′-pyridyl)pyrroles in the absence and presence of alcohols. The absorption and fluorescence properties of such solutions were investigated to determine the relevance of such hydrogen bonding interactions in the ground and excited state behavior of the 2-(2′-pyridyl)pyrroles. Over the concentration range studied, no evidence was found for the formation of hydrogen-bonded 2-(2′-pyridyl)pyrrole dimers. However, it was determined that 3,5-dimethyl-2-(2′-pyridyl)pyrrole forms weak (K ∼ 5–12 M−1) 1∶1 hydrogen-bonded complexes with methanol and t-butyl alcohol in the ground state, and 3,5-di-tert-butyl-2-(2′-pyridyl)pyrrole forms both 1∶1 and 1∶2 complexes with the same alcohols. Despite the formation of hydrogen-bonded 2-(2′-pyridyl)pyrrole alcohol complexes, no experimental evidence was found for excited state proton transfer in such complexes.