Leena Pitkänen

Oxidation of Polysaccharides by Galactose Oxidase

Galactose oxidase was used as a catalyst to oxidize selectively the C-6 hydroxyls of terminal galactose to carbonyl groups. The polysaccharides studied included spruce galactoglucomannan, guar galactomannan, larch arabinogalactan, corn fiber arabinoxylan, and tamarind seed xyloglucan, with terminal galactose contents varying from 6% to 40%. A multienzyme system was used, with catalase and horseradish peroxidase to enhance the action of galactose oxidase. An analysis technique was developed for the quantification of the reactive aldehydes with GC-MS, utilizing NaBD4 reduction and acidic methanolysis. The best oxidation degrees of terminal galactosyls were obtained with xyloglucan (85% of galactose) and spruce galactoglucomannan (65% of galactose). The highest oxidation degree based on total carbohydrates was achieved with guar gum (28%), which had the highest galactose content. The oxidation resulted in changes in the physicochemical properties of the polysaccharide solutions, and the changes observed varied between the polysaccharides. The clearest change was in tamarind xyloglucan, which formed a gel after the oxidation. After the oxidation, larger particles were present in the solution of spruce galactoglucomannan, but changes in its rheological properties were not observed.

Comprehensive multidetector HPSEC study on solution properties of cereal arabinoxylans in aqueous and DMSO solutions.

The water-soluble arabinoxylans from wheat flour (high, medium, and low viscosity samples) and rye flour (high viscosity sample) were characterized by (1)H NMR spectroscopy and HPSEC with refractive index, light scattering, and viscometric detectors. These cereal arabinoxylans have recently been used as model arabinoxylans in various studies, but their solution properties have not been previously investigated. In this study, two HPSEC eluent systems were used: the water-based system and DMSO-based system. DMSO seemed to be a better solvent than water, especially for arabinoxylans containing a low amount of arabinose substituents. (1)H NMR spectroscopy indicated the structural differences between the analyzed arabinoxylan samples that also affected the hydrodynamic parameters obtained with HPSEC. Influence of arabinose side groups on the solution conformation of arabinoxylans could not be excluded based on our data, despite the role of arabinose substituents being questioned in previous investigations concerning arabinoxylan conformation in solution.

Functional and Anionic Cellulose-Interacting Polymers by Selective Chemo-Enzymatic Carboxylation of Galactose-Containing Polysaccharides

Carboxylated, anionic polysaccharides were selectively prepared using a combination of enzymatic and chemical reactions. The galactose-containing polysaccharides studied were spruce galactoglucomannan, guar galactomannan, and tamarind galactoxyloglucan. The galactosyl units of the polysaccharides were first oxidized with galactose oxidase (EC 1.1.3.9) and then selectively carboxylated, resulting in the galacturonic acid derivatives with good conversion and yield. The degrees of oxidation (DO) of the products were determined by gas chromatography-mass spectrometry (GC-MS). A novel feasible electrospray ionization-mass spectrometry (ESI-MS) method was also developed for the determination of DO. The solution properties and charge densities of the products were investigated. The interaction of the products with cellulose was studied by two methods, bulk sorption onto bleached birch kraft pulp and adsorption onto nanocellulose ultrathin films by quartz crystal microbalance with dissipation (QCM-D). To study the effect of the location of the carboxylic acid groups on the physicochemical properties, polysaccharides were also oxidized by 2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO)-mediated reaction producing polyuronic acids. The chemo-enzymatically oxidized galacturonic polysaccharides with an unmodified backbone had a better ability to interact with cellulose than the TEMPO-oxidized products. The selectively carboxylated polysaccharides can be further exploited, as such, or in the targeted functionalization of cellulose surfaces.

An efflux transporter PbrA and a phosphatase PbrB cooperate in a lead-resistance mechanism in bacteria

The gene cluster pbrTRABCD from Cupriavidus metallidurans CH34 is thought to encode a unique, specific resistance mechanism for lead. However, the exact functions of these genes are unknown. In this study we examine the metal specificity and functions of pbrABCD by expressing these genes in different combinations and comparing their ability to restore Pb2+, Zn2+ and Cd2+ resistance in a metal‐sensitive C. metallidurans strain DN440. We show that lead resistance in C. metallidurans is achieved through the cooperation of the Zn/Cd/Pb‐translocating ATPase PbrA and the undecaprenyl pyrophosphate phosphatase PbrB. While PbrA non‐specifically exported Pb2+, Zn2+ and Cd2+, a specific increase in lead resistance was observed when PbrA and PbrB were coexpressed. As a model of action for PbrA and PbrB we propose a mechanism where Pb2+ is exported from the cytoplasm by PbrA and then sequestered as a phosphate salt with the inorganic phosphate produced by PbrB. Similar operons containing genes for heavy metal translocating ATPases and phosphatases were found in several different bacterial species, suggesting that lead detoxification through active efflux and sequestration is a common lead‐resistance mechanism.

Synthesis and Antioxidant Activity of Hydroxycinnamic Acid Xylan Esters

Naturally occurring hydroxycinnamic acids, such as ferulic and sinapic acids, are known to possess antioxidant activity. In this study, ferulic acid and sinapic acid were covalently attached to oat spelt arabinoxylan and birch wood glucuronoxylan by esterification in a two-step feasible synthesis to generate modified xylans with various degrees of substitution. The obtained derivatives were fully analyzed by FT-IR, NMR, and HPSEC experiments to confirm the esterification of xylans and the degree of substitution. The antioxidative potential of the conjugates was evaluated using the emulsion lipid oxidation test. The results demonstrate that the derivatized xylans inhibited lipid oxidation notably better than the native oat spelt and birch wood xylans. It was found that ferulic acid esters of glucuronoxylan were more efficient antioxidants than those of arabinoxylan and that sinapic acid xylan esters were more efficient than their ferulic acid counterparts.

Challenges in analysis of high-molar mass dextrans: Comparison of HPSEC, AsFlFFF and DOSY NMR spectroscopy

Dilute solutions of various dextran standards, a high-molar mass (HMM) commercial dextran from Leuconostoc spp., and HMM dextrans isolated from Weissella confusa and Leuconostoc citreum were analyzed with high-performance size-exclusion chromatography (HPSEC), asymmetric flow field-flow fractionation (AsFlFFF), and diffusion-ordered NMR spectroscopy (DOSY). HPSEC analyses were performed in aqueous and dimethyl sulfoxide (DMSO) solutions, while only aqueous solutions were utilized in AsFlFFF and DOSY. The study showed that all methods were applicable to dextran analysis, but differences between the aqueous and DMSO-based solutions were obtained for HMM samples. These differences were attributed to the presence of aggregates in aqueous solution that were less prevalent in DMSO. The study showed that DOSY provides an estimate of the size of HMM dextrans, though calibration standards may be required for each experimental set-up. To our knowledge, this is the first study utilizing these three methods in analyzing HMM dextrans.

Structural comparison of arabinoxylans from two barley side-stream fractions.

The structures of barley ( Hordeum vulgare) arabinoxylans isolated from two industrial side fractions, barley husks (BH) and barley fiber (BF), were characterized. Arabinoxylans were extracted with saturated barium hydroxide after enzymatic pretreatment. Barium hydroxide was selective toward arabinoxylans, and only a minor amount of glucose-containing material was coextracted. Acid methanolysis followed by gas chromatography, 1H NMR spectroscopy, and specific enzymatic treatments followed by anion exchange chromatography with pulse amperometric detection (HPAEC-PAD) revealed that the chemical structure of barley husk arabinoxylan (BHAX) clearly differed from that of barley fiber arabinoxylan (BFAX). BFAX was more branched, containing more beta-D-xylopyranosyl (beta-D-Xylp) residues carrying alpha-L-arabinofuranosyl (alpha-L-Araf) units at both O-2 and O-3 positions. BHAX, on the other hand, contained more 2-O-beta-D-Xyl p-alpha-L-Ara f substituents than BFAX. BHAX and BFAX also differed with respect to the hydrodynamic properties investigated with multidetector size exclusion chromatography. BFAX had a higher weight-average molar mass and larger hydrodynamic volume, the latter indicating less dense conformation than BHAX. Mn, Mw /Mn, Rh, and the Mark-Houwink a value were also determined for both arabinoxylans.

Molecular characterization and solution properties of enzymatically tailored arabinoxylans

Two α-L-arabinofuranosidases with different substrate specificities were used to modify the arabinose-to-xylose ratio of cereal arabinoxylans: one enzyme (AXH-m) removed the L-arabinofuranosyl substituents from the monosubstituted xylopyranosyl residues and the other (AXH-d3) the (1→3)-linked L-arabinofuranosyl units from the disubstituted xylopyranosyl residue. In this study, we noticed that not only the arabinose-to-xylose ratio but also the position of the arabinofuranosyl substituents affects the water-solubility of arabinoxylans. The AXH-d3 treatment had no significant effect on the solution conformation of arabinoxylans, but the density of the arabinoxylan molecules decreased in DMSO solution after AXH-m modification. The possible heterogeneity of arabinoxylans complicated the interpretation of data describing the macromolecular properties of the enzymatically modified samples.

Behavior of polysaccharide assemblies in field-flow fractionation and size-exclusion chromatography

Asymmetric flow field-flow fractionation (AsFlFFF) and high-performance size-exclusion chromatography (HPSEC) are techniques for separating and characterizing macromolecules; until now the latter is more utilized for analyzing polysaccharides. The demand for characterizing complex, high-molar-mass polysaccharides has raised interest in the use of AsFlFFF in analyzing polymeric carbohydrates in addition to HPSEC. In this paper, we compare the behavior of arabinoxylan aggregates present in aqueous solution in AsFlFFF and HPSEC and their effect on the obtained molecular characteristics (molar mass averages and size). Although the amount of aggregates in aqueous arabinoxylan solutions may be low, their role needs to be understood to avoid erroneous interpretations of AsFlFFF and HPSEC data. When these two separation systems were compared, AsFlFFF seemed to possess more separation power for the differentiation of aggregates from individual chains than HPSEC. To our knowledge, this is the first report on the characterization of xylans with AsFlFFF.

Polysaccharide characterization by hollow-fiber flow field-flow fractionation with on-line multi-angle static light scattering and differential refractometry

Accurate characterization of the molar mass and size of polysaccharides is an ongoing challenge, oftentimes due to architectural diversity but also to the broad molar mass (M) range over which a single polysaccharide can exist and to the ultra-high M of many polysaccharides. Because of the latter, many of these biomacromolecules experience on-column, flow-induced degradation during analysis by size-exclusion and, even, hydrodynamic chromatography (SEC and HDC, respectively). The necessity for gentler fractionation methods has, to date, been addressed employing asymmetric flow field-flow fractionation (AF4). Here, we introduce the coupling of hollow-fiber flow field-flow fractionation (HF5) to multi-angle static light scattering (MALS) and differential refractometry (DRI) detection for the analysis of polysaccharides. In HF5, less stresses are placed on the macromolecules during separation than in SEC or HDC, and HF5 can offer a higher sensitivity, with less propensity for system overloading and analyte aggregation, than generally found in AF4. The coupling to MALS and DRI affords the determination of absolute, calibration-curve-independent molar mass averages and dispersities. Results from the present HF5/MALS/DRI experiments with dextrans, pullulans, and larch arabinogalactan were augmented with hydrodynamic radius (RH) measurements from off-line quasi-elastic light scattering (QELS) and by RH distribution calculations and fractogram simulations obtained via a finite element analysis implementation of field-flow fractionation theory by commercially available software. As part of this study, we have investigated analyte recovery in HF5 and also possible reasons for discrepancies between calculated and simulated results vis-à-vis experimentally determined data.