Lilian C. Trevizan

Focused-microwave-assisted strategies for sample preparation

Abstract In this work a general discussion is presented about extraction and digestion procedures, assisted by focused-microwave radiation. Applications involving inorganic, organic, and organometallic analytes in different types of samples are presented, taking into account recent literature data. The main advantages of using focused-microwave radiation are highlighted, such as safety, versatility, control of microwave energy released to the sample, and programmed addition of solutions. All these features can be applied properly in sample preparation for speciation analysis. New routes of development are discussed considering partial digestion by acid-vapor and gradual addition of a liquid sample to hot concentrated acids. Some preliminary results using these strategies are presented to demonstrate their potentiality.

Evaluation of inductively coupled plasma optical emission spectrometers with axially and radially viewed configurations

b ´ Abstract The analytical performance of two inductively coupled plasma optical emission spectrometers with axially and radially viewed configurations, equipped with charge coupled device solid-state detectors was evaluated using Ar, Ba, Mg, and Ni as test elements. Both instruments have similar Echelle optical arrangements and radio-frequency generators, differing only in the viewing mode and in the diameter of the central injector tube, i.e. 2.3 for the axially and 1.4 mm for the radially viewed ICP. The figures of merit evaluated were: warm-up time, short- and long-term stabilities, UV and VIS spectral resolution and limit of detection (LOD) for Ni in 0.14 moll HNO and 1000 y1 3

Evaluation of Femtosecond Laser-Induced Breakdown Spectroscopy for Analysis of Animal Tissues

The aim of this work was to evaluate the performance of femtosecond laser-induced breakdown spectroscopy (fs-LIBS) for the determination of elements in animal tissues. Sample pellets were prepared from certified reference materials, such as liver, kidney, muscle, hepatopancreas, and oyster, after cryogenic grinding assisted homogenization. Individual samples were placed in a two-axis computer-controlled translation stage that moved in the plane orthogonal to a beam originating from a Ti:Sapphire chirped-pulse amplification (CPA) laser system operating at 800 nm and producing a train of 840 μJ and 40 fs pulses at 90 Hz. The plasma emission was coupled into the optical fiber of a high-resolution intensified charge-coupled device (ICCD)–echelle spectrometer. Time-resolved characteristics of the laser-produced plasmas showed that the best results were obtained with delay times between 80 and 120 ns. Data obtained indicate both that it is a matrix-independent sampling process and that fs-LIBS can be used for the determination of Ca, Cu, Fe, K, Mg, Na, and P, but efforts must be made to obtain more appropriate detection limits for Al, Sr, and Zn.

Optimization and validation of a LIBS method for the determination of macro and micronutrients in sugar cane leaves.

Laser induced breakdown spectrometry (LIBS) was applied for the determination of macro (P, K, Ca, Mg) and micronutrients (B, Cu, Fe, Mn and Zn) in sugar cane leaves, which is one of the most economically important crops in Brazil. Operational conditions were previously optimized by a neuro-genetic approach, by using a laser Nd:YAG at 1064 nm with 110 mJ per pulse focused on a pellet surface prepared with ground plant samples. Emission intensities were measured after 2.0 μs delay time, with 4.5 μs integration time gate and 25 accumulated laser pulses. Measurements of LIBS spectra were based on triplicate and each replicate consisted of an average of ten spectra collected in different sites (craters) of the pellet. Quantitative determinations were carried out by using univariate calibration and chemometric methods, such as PLSR and iPLS. The calibration models were obtained by using 26 laboratory samples and the validation was carried out by using 15 test samples. For comparative purpose, these samples were also microwave-assisted digested and further analyzed by ICP OES. In general, most results obtained by LIBS did not differ significantly from ICP OES data by applying a t-test at 95% confidence level. Both LIBS multivariate and univariate calibration methods produced similar results, except for Fe where better results were achieved by the multivariate approach. Repeatability precision varied from 0.7 to 15% and 1.3 to 20% from measurements obtained by multivariate and univariate calibration, respectively. It is demonstrated that LIBS is a powerful tool for analysis of pellets of plant materials for determination of macro and micronutrients by choosing calibration and validation samples with similar matrix composition.

REVIEW: Iodine Determination by Inductively Coupled Plasma Spectrometry

Abstract Iodine is a chemical element with critical physiological roles and its determination using instrumental analysis is not trivial. Inductively coupled plasma spectrometry associated with either optical emission (ICP-OES) or mass spectrometry (ICP-MS) may be employed, but each alternative presents limitations considering iodine behavior in argon plasma and the occurrence of interferences. Sample preparation is also a critical issue when using sample introduction by pneumatic nebulization due to memory effects. This critical review discusses the literature dealing with sample preparation followed by ICP-OES or ICP-MS for iodine determination in a plethora of samples. It is shown that the best figures of merit may be reached using sample preparation in alkaline medium followed by ICP-MS measurements.

Inductively coupled plasma optical emission spectrometry with axially viewed configuration: an overview of applications

It is generally assumed that inductively coupled plasma optical emission spectrometers (ICP OES) with axial configuration present severe matrix effects when compared to radially viewed ones, although lower detection limits are obtained. However, the development of solid state detectors associated with a Littrow optical arrangement with an echelle grating and proper interfaces for plasma tail cut off led to an increase of analytical applications based on axially viewed configuration. In this review, papers published from 1999 to 2006 using this configuration for matrix effects evaluation, optimization of the operating conditions and analysis of complex samples, such as slurries, are discussed.

Single vessel procedure for acid vapor partial digestion of bovine liver in a focused microwave: multielement determination by ICP-OES.

An acid vapor partial digestion procedure for bovine liver is proposed using a focused microwave oven and a laboratory-made PTFE support. The support is equipped with three cups of approximately 4 ml volume each one and the cups were adapted to the glass reaction vessel of the microwave oven. A mixture containing HNO(3) plus H(2)SO(4) is heated to 120 degrees C to generate acid vapor. Bovine liver (50-90 mg) were directly weighed into the cups followed by addition of a mixture containing NaClO+H(2)O(2). Samples were exposed to acid vapor during 15-25 min and then diluted with distilled and deionized water to final masses of 3.0 g. Recoveries of Al, Ca, Cu, Fe, Mg, Mn, and Zn were evaluated using an ICP-OES with axially-viewed configuration. The effects of both particle sizes and acid vapor exposure time were evaluated and recoveries of most elements were quantitative when using 25 min of heating and 50 mg of samples. Slightly better recoveries were reached using particles smaller than 44 mum, but this effect was mainly observed for hardly extracted elements such as Al and Fe.

Uso de scanner em espectrofotometria de absorção molecular: aplicação em experimento didático enfocando a determinação de ácido ascórbico

Quantitative analysis of colored substances is generally performed using a spectrophotometer for detection of radiation. However, the combination of digital images and mathematical conversion of colors is an alternative for quantitative procedures based on colored chemical reactions. This work proposes a didactic experiment using a scanner for determination of ascorbic acid in medicines based on the formation of the Prussian blue complex. Results were in good agreement with a conventional spectrophotometer method and the procedure is attractive for instrumental analysis undergraduate courses.

Avaliação de ICP OES com configuração axial ou radial para determinação de iodo em sal de cozinha

The performance of inductively-coupled plasma optical emission spectrometers with axial and radial views for determination of iodine in table salt was evaluated. Interference and memory effects in nitric acid and water-soluble tertiary amines (CFA-C) media were studied. Based on a factorial experiment, one optimum instrument operational condition for axial configuration, and two optima conditions for radial configuration was established. The ICP OES with axial view was 5-fold more sensitive than the radial view. Both matrix matching and standard addition methods were used for iodine quantification and for most samples, both strategies of calibration led to similar results. Recoveries ranged from 104 to 114%.

INTEGRAÇÃO DE TÉCNICAS ANALÍTICAS E PROPOSTA DE EXPERIMENTOS PARA CURSOS DE GRADUAÇÃO EM ANÁLISE INSTRUMENTAL: USO DE ESPECTRÔMETRO DE ABSORÇÃO ATÔMICA PARA MEDIDAS DE ABSORÇÃO MOLECULAR

Simple experiments are proposed for measuring molecular absorption of chromate and dichromate ions using an atomic absorption spectrometer. The experiments can help undergraduate students in instrumental analysis courses understand important aspects involving conceptual and instrumental similarities and differences between frequently used analytical techniques. Hollow cathode lamps were selected with wavelengths in the region of molecular absorption of chromate and dichromate. Calibration curves were obtained and the linear dynamic range was evaluated. Results were compared with those obtained in a molecular absorption spectrometer. The molar absorptivities obtained were also compared.