Linhua Xia

Methylene blue adsorption on graphene oxide/calcium alginate composites.

Graphene oxide has been used as an adsorbent in wastewater treatment. However, the dispersibility in aqueous solution and the biotoxicity to human cells of graphene oxide limits its practical application in environmental protection. In this research, a novel environmental friendly adsorbent, calcium alginate immobilized graphene oxide composites was prepared. The effects of pH, contact time, temperature and dosage on the adsorption properties of methylene blue onto calcium alginate immobilized graphene oxide composites were investigated. The equilibrium adsorption data were described by the Langmuir and Freundlich isotherms. The maximum adsorption capacity obtained from Langmuir isotherm equation was 181.81 mg/g. The pseudo-first order, pseudo-second order, and intraparticle diffusion equation were used to evaluate the kinetic data. Thermodynamic analysis of equilibriums indicated that the adsorption reaction of methylene blue onto calcium alginate immobilized graphene oxide composites was exothermic and spontaneous in nature.

An ionic liquid-modified graphene based molecular imprinting electrochemical sensor for sensitive detection of bovine hemoglobin.

A novel kind of molecular imprinted polymers based on ionic liquid-functionalized graphene (MIPs/IL/GR) was prepared by electro-polymerization, which was applied as a molecular recognition element to modify glassy carbon electrode (GCE) to construct an electrochemical sensor (MIPs/IL/GR/GCE) for sensitive detection of bovine hemoglobin (BHb). The fabrication conditions that affect the performance of the imprinted sensor, such as pyrrole concentration, scan cycles and scan rates, have been discussed. Under the optimized conditions, the prepared molecular imprinting electrochemical sensor showed a fast rebinding dynamics, which was successfully applied to BHb detection with a wide linear range from 1.0 × 10(-10) to 1.0 × 10(-3)g/L (R=0.998) and a detection limit of 3.09 × 10(-11)g/L. Moreover, the fabricated sensor possessed a good selectivity and stability, providing a promising tool for immunoassays and clinical applications.

Mechanical and dye adsorption properties of graphene oxide/chitosan composite fibers prepared by wet spinning.

Graphene oxide/chitosan composite fibers were prepared by a wet spinning method, and their mechanical properties were investigated. Experimental results showed that the introduction of graphene oxide at 4 wt% loading can improve the tensile strengths of chitosan fibers. Batch adsorption experiments were carried out to study the effect of various parameters, such as the initial pH value, adsorbent dosage, contact time and temperature on adsorption of fuchsin acid dye. The Langmuir model was used to fit the experimental data of adsorption isotherm, and kinetic studies showed that the adsorption data followed the pseudo-second order model. Thermodynamic studies indicated that the adsorption of fuchsin acid dye on graphene oxide/chitosan fibers was a spontaneous and exothermic process. Our results indicate that the graphene oxide/chitosan fibers have excellent mechanical properties and can serve as a promising adsorbent for the removal of dyes from aqueous solutions.

Macroscopic, flexible, high-performance graphene ribbons.

Tailoring the structure and properties of graphene fibers is an important step toward practical applications. Here, we report macroscopic, long graphene ribbons formed by combining electrostatic interaction and shear stress during the wet-spinning process. The graphene ribbons are flexible and can be woven into complex structures, and the ribbon morphology can be tailored by controlling the orientation of wrinkles to obtain elasticity within a modest strain. We demonstrate several potential applications of pure or Pt-graphene hybrid ribbons as elastic strain sensors, counter electrodes for dye-sensitized fiber solar cells with cell efficiencies reaching 4.69% under standard illumination and 6.41% with a back reflector, and woven fabric supercapacitor electrodes. Our method can directly fabricate meter-long graphene ribbons with controlled structure and high performance as both energy conversion and energy storage materials.

Fabrication and characterization of a triple functionalization of graphene oxide with Fe3O4, folic acid and doxorubicin as dual-targeted drug nanocarrier.

A novel triple functionalized drug delivery system was synthesized by encapsulation of superparamagnetic graphene oxide (GO) and doxorubicin (DOX) with folic acid (FA) conjugated chitosan (CHI). The carrier exhibited a high loading efficiency (0.98 mg/mg), a high saturation magnetization (10.5 emu/g) and a prolonged release rate. A real-time monitoring method on the drug release from graphene oxide (GO) was reported using DOX as the model drug. The release mechanism of DOX at different pH was investigated via monitoring the time dependency of the accumulative drug release. Results show that the drug release of DOX was pH sensitive as observed at pH 5.3 and pH 7.4 PBS solutions, the lower pH values lead to weaker hydrogen bonds and degradation of CHI, and thus result in a higher release rate of DOX. Especially, this system could be applied as a dual-targeted drug nanocarrier by combined biological (active) and magnetical (passive) targeting capabilities. Our research suggests that a novel triple functionalized, pH-responsive nanocarrier for anticancer drug has been synthesized.

Synthesis of strongly green-photoluminescent graphene quantum dots for drug carrier.

A novel approach has been developed for the preparation of strongly green-photoluminescent graphene quantum dots (GQDs-PEG) which have been surface-passivated by polyethylene glycol. The photoluminescence (PL) quantum yield of the GQDs-PEG with 400 nm excitation was about 18.8%, which was higher than other GQDs reported in the literature. More importantly, the surface-passivated PEG on GQDs can not only enhance PL intensity but also load drug by hydrogen bonding. Moreover, the high specific surface area of GQDs-PEG endowed them high loading capability (2.5 mg/mg) to carry drug. The results demonstrated that the GQDs-PEG were suitable for drug carrier and cell imaging.

Adsorption Properties of Doxorubicin Hydrochloride onto Graphene Oxide: Equilibrium, Kinetic and Thermodynamic Studies

Doxorubicin hydrochloride (DOX) is an effective anticancer agent for leukemia chemotherapy, although its clinical use has been limited because of its side effects such as cardiotoxicity, alopecia, vomiting, and leucopenia. Attention has been focussed on developing new drug carriers with high adsorption capacity and rapid adsorption rate in order to minimize the side effects of DOX. Graphene oxide (GO), a new type of nanomaterial in the carbon family, was prepared by Hummers method and used as adsorbent for DOX from aqueous solution. The physico-chemical properties of GO were characterized by transmission electron microscope (TEM), Fourier transform infrared spectroscopy (FTIR), zeta potential, and element analysis. The adsorption properties of DOX on GO were studied as a function of contact time, adsorbent dosage, temperature and pH value. The results showed that GO had a maximum adsorption capacity of 1428.57 mg/g and the adsorption isotherm data fitted the Langmuir model. The kinetics of adsorption fits a pseudo-second-order model. The thermodynamic studies indicate that the adsorption of DOX on GO is spontaneous and endothermic in nature.

Graphene as an efficient sorbent for the SPE of organochlorine pesticides in water samples coupled with GC-MS.

The determination of organochlorine pesticides in water samples, which are harmful to humans, is very important for environmental risk assessment. Based on the excellent adsorption properties of graphene, an SPE coupled with GC-MS method for the monitoring of organochlorines (four hexachlorcyclohexanes and four dichlorodiphenyltrichloroethanes) was developed. Owing to the hydrophobic interaction and π-π stacking interaction between the analytes and graphene, the analytes quantitatively adsorbed onto the graphene-based SPE cartridge were eluted by ethyl acetate for analysis. Several parameters influencing the analytical performance, such as the kind of elution, sample volume, reusability of the cartridge, have been investigated in detail. Under the optimal conditions, detection of limits of 1.95-9.38 ng/L, recoveries of 83.9-107.3% at two spiked concentration levels (0.1 and 10 ng/mL) and RSDs in the range of 2.9-7.4% for real water samples were obtained for all the analytes. This work reveals the great potential of graphene in sample preparation procedures.

Highly effective removal of basic fuchsin from aqueous solutions by anionic polyacrylamide/graphene oxide aerogels

Novel anionic polyacrylamide/graphene oxide aerogels were prepared by a freeze drying method and used to remove basic fuchsin from aqueous solutions. These aerogels were sponge-like solid with lightweight, fluffy and porous structure. The batch adsorption experiments were carried out to study the effect of various parameters, such as the solution pH, adsorbent dose, contact time and temperature on adsorption properties of basic fuchsin onto anionic polyacrylamide/graphene oxide aerogels. The kinetics of adsorption corresponded to the pseudo-second-order kinetic model. The Langmuir adsorption isotherm was suitable to describe the equilibrium adsorption process. The maximum adsorption capacity was up to 1034.3 mg/g, which indicated that anionic polyacrylamide/graphene oxide aerogels were promising adsorbents for removing dyes pollutants from aqueous solution.

Platinum/graphene functionalized by PDDA as a novel enzyme carrier for hydrogen peroxide biosensor

In this work, we fabricated platinum nanoparticles/graphene nanohybrids (Pt/G) via in situ reduction of PtCl62− in the presence of poly(diallyldimethylammonium chloride)-modified G, and used them as a support for the immobilization of horseradish peroxidase to construct a biosensor (HRP/Pt/G/glassy carbon (GC)) for H2O2. Poly(diallyldimethylammonium chloride) (PDDA), a positively charged polyelectrolyte, created a net positive charge on the carbon atoms in the all-carbon graphene plane via intermolecular charge transfer. Then the resultant positively charged PDDA-modified G was used for sequential self-assembly with negatively charged PtCl62− which could be reduced in situ. The Pt/G hybrid provides an effective atmosphere for maintaining the bioactivity of HRP, and also acts as a bridge for the transfer of electrons between the active center of HRP and the electrode surface, thereby resulting in a more rapid transmission of electrons. The HRP/Pt/G/GC showed high sensitivity and fast response for electrocatalytic reduction towards H2O2, revealing that Pt/G effectively reinforced the immobilization of HRP and enhanced the utilization of HRP. The linear range for H2O2 was estimated to be from 3.0 × 10−6 mol L−1 to 5.2 × 10−3 mol L−1 with a detection limit of 5.0 × 10−9 mol L−1. Moreover, the biosensor exhibited good reproducibility and long-term stability.