Lucas Rodrigues Pinheiro

Use of large-volume cone-beam computed tomography in identification and localization of horizontal root fracture in the presence and absence of intracanal metallic post.

INTRODUCTION The objective of the study was to evaluate the ability of large-volume cone-beam computed tomography (CBCT) to detect horizontal root fracture and to test the influence of a metallic post. METHODS Through the examination of 40 teeth by large-volume CBCT (20-cm height and 15-cm diameter cylinder) at 0.2-mm voxel resolution, 2 observers analyzed the samples for the presence and localization of horizontal root fracture. RESULTS The values of accuracy in the groups that had no metallic post ranged from 33%-68%, whereas for the samples with the metallic post, values showed a wide variation (38%-83%). Intraobserver agreement showed no statistically significant difference between the groups with/without metallic post; both ranged from very weak to weak (kappa, 0.09-0.369). CONCLUSIONS The low accuracy and low intraobserver and interobserver agreement reflect the difficulty in performing an adequate diagnosis of horizontal root fractures through a large-volume CBCT by using a small voxel reconstruction.

Assessment of open source software for CBCT in detecting additional mental foramina

The purpose of this study was to evaluate which post-processing imaging protocol would be better to analyze the additional mental foramen (AMF) in preoperative planning with cone-beam computed tomography (CBCT) exams, and to test reproducibility of measurements, using open source software (OsiriX). The software was used to detect the cases of AMF from among 58 exams for dental implant planning in edentulous mandible areas-three cases were found. The case images were submitted to qualitative analysis using 2D orthogonal MPR, 3D-MPR and 3D volume rendering protocols by two oral and maxillofacial radiologists. Quantitative analysis used the 3D-MPR protocol; the closed polygon tool measured the mental foramen (MF) and the AMF areas; the length tool measured the distance between foramina. The measurements were performed independently by the examiners, at two different times. Intra- and interexaminer agreement was assessed using the intraclass correlation coefficient. The panoramic view did not show the MF and the AMF clearly. The AMF could be detected in the parasagittal view. 2D Orthogonal MPR was effective to observe the AMF in some cases. The 3D-MPR and 3D view protocols were the most effective to locate and analyze the AMF. In conclusion, a 3D view improves visualization when anatomical points are not clearly visible. 3D-MPR was considered a more effective post-processing imaging protocol to observe foramina relationships. The high reproducibility of measurements for anatomical MF variations was established using specific tools featured in open source software for CBCT. OsiriX is realistic and recommended for preoperative planning.

Influence of Cone-beam Computed Tomographic Scan Mode for Detection of Horizontal Root Fracture

INTRODUCTION The purpose of the present study was (1) to test the accuracy of a small-volume cone-beam computed tomographic (CBCT) device in detecting horizontal root fractures (HRFs) in teeth with and without an intracanal metallic post (IMP) and (2) to investigate the use of 2 different acquisition protocols of a CBCT device for HRF diagnosis. METHODS Forty endodontically treated teeth with and without an IMP were examined using PreXion 3D CBCT scanner (Terarecon, San Mateo, CA) with a 5-cm high and 5-cm diameter cylinder at 0.10-mm voxel reconstruction. Two observers analyzed the samples to determine the presence and location of HRFs. RESULTS Sensitivity values ranged from 0.40-0.80. The most favorable results were found for the samples with no IMP observed using the protocol of a higher number of x-ray projections (0.70-0.80). Accuracy in the groups with an IMP ranged from 75%-90% in the 1024 x-ray projection protocol (HI-HI group) versus 70%-85% for the same samples examined in the 512 x-ray projection protocol (HI-STD group). Intraobserver agreement ranged from relevant to perfect concordance for both protocols (HI-HI = Kappa: 0.60-1.00 and HI-STD = Kappa: 0.55-0.89). Interobserver agreement ranged from moderate to perfect concordance for both protocols (HI-HI = Kappa: 0.79-0.89 and HI-STD = Kappa: 0.42-0.76). CONCLUSIONS Even though there are statistically significant differences for the protocol with the higher number of x-ray projections, we found high accuracy, sensitivity, sensibility, and intra- and interobserver agreement in detecting HRFs for both Prexion 3D protocols.

Effect of Cone-Beam Computed Tomography Field of View and Acquisition Frame on the Detection of Chemically Simulated Peri-Implant Bone Loss In Vitro

BACKGROUND The aim of this study is to determine the influence of field of view (FOV) and number of acquisition projection images (frames) on the detection of chemically simulated peri-implant defects by cone-beam computed tomography (CBCT) using an in vitro bovine rib bone model. METHODS Eighty implants were placed in bovine ribs in which small and large bone defects were created using 70% perchloric acid. CBCT images were acquired at three acquisition protocols: protocol 1 (FOV 4 × 4 cm, 0.08-mm voxel size, 1,009 frames [high fidelity]; protocol 2 (same as protocol 1 except 512 frames [standard]); and protocol 3 (FOV 14 × 5 cm, 0.25-mm voxel size; high fidelity). Two oral and maxillofacial radiologists (OMRs) and two oral and maxillofacial surgeons (OMSs) rated the presence or absence of bone defects on a five-point scale. κ and area under the curve (AUC) were calculated and compared using analysis of variance with post hoc Tukey test at P ≤ 0.05. RESULTS Intra- and interobserver agreement for OMRs ranged from moderate to good and from slight to moderate for OMSs. For the detection of small lesions, protocol 1 (AUC 0.813 ± 0.045) provided higher detection rates than protocol 2 (AUC 0.703 ± 0.02) and protocol 3 (AUC 0.773 ± 0.55) [F(2,9) = 1.6377]. For larger defects, the trends were similar, with protocol 1 (AUC 0.852 ± 0.108) providing higher detection rates than protocol 2 (AUC 0.730 ± 0.045) and protocol 3 (AUC 0.783 ± 0.058) [F(2,9) = 1.9576]. CONCLUSION Within the limits of this study, optimal detection of chemically simulated pericircumferential implant crestal bone defects is achieved at the least radiation detriment using the smallest FOV, the highest number of acquisition frames, and the smallest voxel.

Validity of three-dimensional computed tomography measurements for Le Fort I osteotomy

The purpose of this study was to test the precision and accuracy of three-dimensional (3D) linear measurements for Le Fort I osteotomy, obtained from multi-slice computed tomography (MSCT) and cone beam computed tomography (CBCT) scans. The study population consisted of 11 dried skulls submitted to 64-row MSCT and CBCT scans. Three-dimensional reconstructed images (3D-CT) were generated, and linear measurements (n=11) based on anatomical structures and landmarks of interest for Le Fort I osteotomy were performed independently by two oral and maxillofacial radiologists, twice each, using Vitrea software; this allows true 3D measurement on 3D-CT images. The results demonstrated no statistically significant differences between the inter-examiner and intra-examiner analyses, and physical and true 3D linear measurements using MSCT and CBCT images. Regarding examiner accuracy, no statistically significant differences were found for the comparisons among the physical and the MSCT and the CBCT linear measurements by either examiner. For examiners 1 and 2, the analysis intra-examiner correlation coefficient ranged from 0.87 to 0.96 and 0.82 to 0.98, respectively, using MSCT, and from 0.84 to 0.98 and 0.80 to 0.98, respectively, using CBCT, indicating almost perfect agreement for all analyses performed. 3D linear measurements obtained from MSCT and CBCT images were considered precise and accurate for Le Fort I osteotomy and thus accurate and helpful for Le Fort I osteotomy planning.

Effect of field of view in the detection of chemically created peri-implant bone defects in bovine ribs using cone beam computed tomography: an in vitro study

OBJECTIVES To assess the accuracy of cone beam computed tomography (CBCT) using two fields of view (FOVs) in the diagnosis of peri-implant defects. STUDY DESIGN Eighty implants were placed in bovine ribs, in which peri-implant bone defects of two sizes (T1 and T2) were simulated using 70% perchloric acid. CBCT images were acquired with the use of two FOV size settings of the i-CAT NG unit: 6 × 16 cm and 8 × 8 cm. One oral and maxillofacial surgeon (OMS) and two oral and maxillofacial radiologists (OMRs) evaluated the presence of defects, and their findings were compared with direct visual evaluation. The kappa (κ)-statistic, area under the curve (AUC), sensitivity, specificity, positive predictive value (PPV), and negative predictive value (NPV) of the examinations were calculated. AUC values were compared with the Student t test. RESULTS The obtained κ-values indicated good intra- and interobserver agreement. A significant difference was found between T1 and T2 (P = .01) with regard to AUC values, and no significant difference was found between the different FOVs in both test groups (T1, P = .06; T2, P = .33). The sensitivity, specificity, PPV, and NPV of the examinations were higher for the OMRs than for the OMS involved in the study. CONCLUSIONS The ability of CBCT to detect chemically created peri-implant bone defects was good, especially for larger defects (Group T2) but only for the observations of the OMRs. The observations of the OMS were less accurate. The two FOVs tested were appropriate to detect peri-implant bone defects.

Detection of horizontal root fracture using four different protocols of cone-beam computed tomography

The purpose of this study was to analyze four different cone-beam computed tomography (CBCT) protocols to identify horizontal root fractures (HRF) in endodontically treated teeth, with or without the presence of a metallic post. Thirty extracted single-rooted human premolars were treated endodontically. Afterwards, an observer induced a horizontal fracture in 15 teeth. Each tooth was inserted in an empty mandibular socket and submitted to a computed tomography scan taken with and without the metallic post. The acquisition followed four different protocols, with different fields of view (FOV) and voxel sizes, as follows: FOV 6 X 16 cm/0.2 mm voxel; FOV 6 X 16 cm/0.25 mm voxel; FOV 8 X 8 cm/0.2 mm voxel; FOV 8 X 8 cm/0.25 mm voxel. Two observers checked all the acquisitions within a two-week interval, and the values of sensitivity, specificity, accuracy and kappa were calculated. The sensitivity, specificity and accuracy values were better for the 8 X 8 cm/0.2 mm and 16 X 6 cm/0.25 mm protocols, ranging from 0.60 to 0.86 and 0.53 to 0.80, respectively. The intra- and interobserver concordance ranged from 0.65 to 0.72. The protocols where FOV and voxel were proportional showed better results. The 8 x 8 cm/0.2 mm protocol had the least interference from the metallic artifact. All four protocols showed a decline in values in the presence of the metallic artifact.

Dentomaxillofacial manifestations of mucopolysaccharidosis VI: clinical and imaging findings from two cases, with an emphasis on the temporomandibular joint

OBJECTIVES Using a clinical survey, panoramic, cone-beam computed tomography (CBCT), and magnetic resonance (MR) imaging, this study was conducted to ascertain primary maxillofacial abnormalities in patients with mucopolysaccharidosis VI (MPS VI). STUDY DESIGN Two patients previously diagnosed with MPS VI underwent clinical and imaging surveys (panoramic radiographs, CBCT, and MR imaging). RESULTS Jaw involvement was present in all patients. The most prevalent findings were enlarged marrow spaces, osteopenia, dentigerous cyst-like follicles, effacement of the jaw structures, and osteosclerosis. This is the first study to describe temporomandibular joint (TMJ) involvement for MPS VI. CONCLUSIONS CBCT and MR imaging were needed to observe features that were not clear in conventional radiographs. Both patients reported symptoms in the TMJ and demonstrated involvement during their examinations. A multicenter study is necessary to better document maxillofacial involvement in MPS VI.

Clinical and imagiological findings of central giant cell lesion and cherubism

Cone beam computed tomography (CBCT) is the best examination for bone lesions of the maxilla, allowing the dentist to evaluate precisely the behavior and components of the lesion and their relationship to the surrounding structures. Central giant cell lesion and cherubism are histologically very similar lesions. Therefore clinical and radiological examinations are fundamentally important for the diagnosis. The aim of this paper is to report two cases diagnosed as central giant cell lesions and cherubism using CBCT. This imaging modality was very important for the diagnosis of the lesions presented in the current study. It also allowed observing precisely the limits of the lesions, the components, the behavior and the exact relationship to adjacent structures.

CBCT-based evaluation of integrity of cortical sinus close to periapical lesions

The purpose of the present study was to test the applicability of cone beam computed tomography (CBCT) to evaluate the integrity of the cortical sinus close to periapical lesions. Two observers analyzed samples of 64 alveoli of first molar roots in macerated swine maxillas prepared with perchloric acid to simulate periapical lesions. The specimens were evaluated using CBCT (55-mm high and 100-mm diameter cylinder at 0.2-mm voxel resolution) for the presence of oroantral communication (OAC) caused by the simulated lesions. Sensitivity, specificity, and accuracy were calculated. Fair values were obtained for accuracy (66%-78%) and good values for specificity (70%-98%), whereas the values for sensibility showed relevant variation (41%-78%). For this reason, the interobserver agreement score was weak. CBCT proved capable of evaluating the integrity of the cortical sinus (absence of oroantral communication) when it lies close to an apical periodontitis lesion. However, the low interobserver agreement reflects the difficulty in performing diagnoses when OAC is adjacent to a periapical lesion, using the acquisition protocol adopted in this research. This could be attributed to the high level of image noise.