Luigi Tarpani

Plasmonic Nanobubbles as Transient Vapor Nanobubbles Generated Around Plasmonic Nanoparticles

We have used short laser pulses to generate transient vapor nanobubbles around plasmonic nanoparticles. The photothermal, mechanical, and optical properties of such bubbles were found to be different from those of plasmonic nanoparticle and vapor bubbles, as well. This phenomenon was considered as a new complex nanosystem-plasmonic nanobubble (PNB). Mechanical and optical scattering properties of PNB depended upon the nanoparticle surface and heat capacity, clusterization state, and the optical pulse length. The generation of the PNB required much higher laser pulse fluence thresholds than the explosive boiling level and was characterized by the relatively high lower threshold of the minimal size (lifetime) of PNB. Optical scattering by PNB and its diameter (measured as the lifetime) has been varied with the fluence of laser pulse, and this has demonstrated the tunable nature of PNB.

New insights on the incorporation of lanthanide ions into nanosized layered double hydroxides.

Nanosized Layered Double Hydroxides (LDH) were prepared in confined environment through the microemulsion method in the presence of different lanthanide cations (Ln(III) = Eu(III), Yb(III), Tb(III), and Nd(III)). To investigate the effects of lanthanide insertion in the sheets of LDH materials, several samples were prepared upon progressively increasing the content of Ln ions and properly reducing the Al(III) amount; the samples were characterized in terms of metal content, structure, morphology, thermal behavior, and spectroscopic properties. The data revealed that Ln(III) content in the LDH samples depends on the ionic radius of the lanthanide cations and on its concentration in the starting microemulsion. X-ray powder diffraction (XRPD) indicated that Eu(III) can be inserted into the LDH structure in average atomic percentages lower than 2.7%, leading to the formation of a low symmetry phase, as confirmed by steady state luminescence spectra; while Yb(III) can be incorporated into the layer structure up to about 10% forming a pure layered phase containing the lanthanide in the sheet. The incorporation of Yb(III) and Eu(III) into the LDH sheets is also supported by FT-IR measurements. Coupled thermogravimetrical (TG) and differential scanning calorimetric (DSC) studies indicated that water molecules are essential in the coordination sphere of incorporated Ln cations; this observation accounts for the lower thermal stability of Ln-doped LDH compared to the undoped ones. Furthermore, Eu-luminescence measurements indicates that the lanthanide inclusion does not compromise its luminescence although the spectral position and brightness can be tuned by the loading.

Protein Encapsulation in Biodegradable Polymeric Nanoparticles: Morphology, Fluorescence Behaviour and Stem Cell Uptake

The synthesis and characterization of new biodegradable polymeric NPs loaded with bovine serum albumin marked with fluorescein isothiocyanate (FITC-BSA) is reported. The protein is encapsulated in poly(D,L-lactide-co-glycolide) (PLGA) NPs by the double emulsion method with subsequent solvent evaporation. The NPs display a spherical shape with a narrow size distribution and no aggregation is observed after drying. Steady-state and time-resolved fluorescence measurements appear to be a sensitive method to investigate the protein environment on the nanometer-scale. Finally, FITC-BSA-loaded NPs are rapidly internalized in stem cells. Interestingly, 25% cells were slightly positive after 28 days.

Protein interactions with nanosized hydrotalcites of different composition

Nanosized hydrotalcite-like compounds (HTlc) with different chemical composition were prepared and used to study protein adsorption. Two soft proteins, myoglobin (Mb) and bovine serum albumin (BSA), were chosen to investigate the nature of the forces controlling the adsorption and how these depend on the chemical composition of the support. Both proteins strongly interact with HTlc exhibiting in most cases a Langmuir-type adsorption. Mb showed a higher affinity for Nickel Chromium (NiCr-HTlc) than for Nickel Aluminum (NiAl-HTlc), while for BSA no significant differences between supports were found. Adsorption experiments in the presence of additives showed that proteins exhibited different types of interactions onto the same HTlc surface and that the adsorption was strongly suppressed by the addition of disodium hydrogen phosphate (Na(2)HPO(4)). Atomic force microscopy images showed that the adsorption of both proteins onto nanoparticles was followed by the aggregation of biocomposites, with a more disordered structure for BSA. Fluorescence measurements for adsorbed Mb showed that the inorganic nanoparticles induced conformational changes in the biomolecules; in particular, the interactions with HTlc surface quenched the tryptophan fluorescence and this process was particularly efficient for NiCr-HTlc. The adsorption of BSA onto the HTlc nanoparticles induced a selective quenching of the exposed fluorescent residues, as indicated by the blue-shift of the emission spectra of tryptophan residues and by the shortening of the fluorescence decay times.

Spectroscopic Investigation of Interactions of New Potential Anticancer Drugs with DNA and Non-Ionic Micelles

Photophysical properties of some azinium iodides in aqueous solution of nanostructured systems as DNA and nonionic micelles were investigated using steady-state and ultrafast time-resolved spectroscopy. Spectrophotometric and fluorimetric titrations of the investigated compounds with salmon testes DNA supplied evidence of a good interaction between the salts and DNA with binding constants of 10(4)-10(6) M(-1), making them interesting for pharmaceutical applications. The interaction with DNA also changes the photobehavior of the compounds, increasing the radiative deactivation pathway to the detriment of internal conversion and slowing down the excited state dynamics. The interaction of the azinium salts with the nonionic surfactant Triton X-100 from premicellar to postmicellar concentration was studied by spectrophotometric and fluorimetric titrations evidencing the ability of the micelles to associate the studied salts in their hydrophobic portion and to release them in the presence of DNA, acting as promising drug carriers. Also transient absorption spectroscopy with femtosecond resolution demonstrated the insertion of the investigated compounds into micellar aggregates. Preliminary measurements by confocal fluorescence microscopy on MCF-7 cells in the presence of the studied azinium salts showed that they are able to cross the cellular membrane and that their cytotoxicity can be expressed through interaction with DNA (RNA). In fact, they showed a significant fluorescence signal in all cell compartments, particularly (for 2 and 3) into punctuate structures within the nuclei compatible with a localization into the nucleoli.

Spectroscopic and Microscopic Studies of Aggregation and Fibrillation of Lysozyme in Water/Ethanol Solutions

The thermal aggregation of lysozyme has been analyzed in water/ethanol solutions at low pH to induce the specific protein aggregation pathway which leads to fibrillar structures in a few hours. In this solvating medium, the protein undergoes a conformational rearrangement promoting the formation of fibrils that are structurally similar to amyloid ones. As the process evolves with different steps, a multitechnique approach has been used by means of analytical probes that can be selectively sensitive in the detection of the different stages of protein association. Fourier transform infrared spectroscopy, intrinsic fluorescence, stationary fluorescence anisotropy, transmission electron microscopy (TEM), and atomic force microscopy (AFM) measurements have been carried out at different times to access and characterize the whole aggregation pathway. The data recorded with different experimental setups revealed different sensitivity to different stages of protein assembling. The whole set of data together with the direct visualization of different aggregate structures by use of TEM and AFM imaging enable to discuss a possible mechanism of fibrillation.

The Influence of Modified Silica Nanomaterials on Adult Stem Cell Culture

The preparation of tailored nanomaterials able to support cell growth and viability is mandatory for tissue engineering applications. In the present work, silica nanoparticles were prepared by a sol-gel procedure and were then functionalized by condensation of amino groups and by adsorption of silver nanoparticles. Transmission electron microscopy (TEM) imaging was used to establish the morphology and the average dimensions of about 130 nm, which were not affected by the functionalization. The three silica samples were deposited (1 mg/mL) on cover glasses, which were used as a substrate to culture adult human bone marrow-mesenchymal stem cells (hBM-MSCs) and human adipose-derived stem cells (hASCs). The good cell viability over the different silica surfaces was evaluated by monitoring the mitochondrial dehydrogenase activity. The analysis of the morphological parameters (aspect ratio, cell length, and nuclear shape Index) yielded information about the interactions of stem cells with the surface of three different nanoparticles. The data are discussed in terms of chemical properties of the surface of silica nanoparticles.

Photoactivation of Luminescent Centers in Single SiO2 Nanoparticles

Photobleaching of fluorophores is one of the key problems in fluorescence microscopy. Overcoming the limitation of the maximum number of photons, which can be detected from a single emitter, would allow one to enhance the signal-to-noise ratio and thus the temporal and spatial resolution in fluorescence imaging. It would be a breakthrough for many applications of fluorescence spectroscopy, which are unachievable up to now. So far, the only approach for diminishing the effect of photobleaching has been to enhance the photostability of an emitter. Here, we present a fundamentally new solution for increasing the number of photons emitted by a fluorophore. We show that, by exposing a single SiO2 nanoparticle to UV illumination, one can create new luminescent centers within this particle. By analogy with nanodiamonds, SiO2 nanoparticles can possess luminescent defects in their regular SiO2 structure. However, due to the much weaker chemical bonds, it is possible to generate new defects in SiO2 nanostructures using UV light. This allows for the reactivation of the nanoparticles fluorescence after its photobleaching.

Solid-Phase Analysis of Polycyclic Aromatic Hydrocarbons by Fluorimetric Methods

Polycyclic aromatic hydrocarbons (PAHs) adsorbed on the surface of particulates collected in a working environment have been analyzed using fluorescence techniques. In particular, fluorescence measurements were carried out directly on the sampling filters, in solid phase, and for comparison, on the extract samples in solution. Fluorescence synchronous acquisitions allowed the detection of signals from different PAH compounds and, on the basis of the 0–0 transition energy, the assignment of the emission signals to chemical structures. In particular, the contribution of benzo-α-pyrene was easily detected and used to evaluate the sensitivity of the measurements, which is a few nanograms per milliliter, comparable with other analytical tools. The results of the fluorimetric investigation were validated through the comparison with the data obtained by gas chromatography (GC) analysis on the extracted samples, which allowed identification of the PAHs and the quantification of their distribution on the filters with different cut sizes. The agreement between the two series of data led to the conclusion that fluorimetric analysis directly on the sampling filter could be a new and cost-effective approach for the analysis of PAHs.

Driving the interactions between organic nanoparticles and phospolipidic membranes by an easy treatment of the surface stabilizer.

Polymer-stabilized perylene nanoparticles were prepared through a solvent exchange method. The formation of the nanostructures in aqueous solution was confirmed by the appearance of a red-shifted emission attributable to the formation of excimer-like aggregates. The behavior of organic nanostructures in the presence of lipid vesicles was investigated through steady-state and time-resolved fluorescence measurements. When no further surface treatment is applied to the nanoparticles, changes in the decay times and emission spectra demonstrate that inside the lipid bilayers the nanoparticles redissolve into the monomeric form with a rate and efficiency determined by the working temperature (above and below the transition temperature Tm of the phospholipid). On the other hand, when the stabilized shell is UV-cured to induce photo-cross-linking of the polymeric chains, the nanoparticle stability increases and their redissolution in the membrane is prevented. Confocal fluorescence images support the data obtained in bulk. The results indicate that the prepared nanostructures could be successfully used either as nanometric carriers for the delivery of poor water-soluble lipophilic compounds or as imaging tools depending on the rigidity/cross-linking degree of their polymeric stabilizer shell.