M. Teresa Galceran

Determination of phenols in sea water by liquid chromatography with electrochemical detection after enrichment by using solid-phase extraction cartridges and disks

The efficiency and the reproducibility of different solid-phase adsorbents such as C18 cartridges, C18 and poly(styrene-divinylbenzene) (PS-DVB) membrane extraction disks were evaluated for the extraction of phenols from water at μg 1−1 concentration levels. Liquid chromatography with electrochemical detection (LC-ED) was used for the analysis of the organic extracts. A phosphate buffer-acetonitrile-methanol mixture as mobile phase and coulometric detection at + 750 mV were used. High recoveries (70–98%) and good reproducibility (relative standard deviation between 3 and 12%) were obtained using PS-DVB disks, which can be recommended for the enrichment of samples with low concentration of phenols (0.5 μg 1−1). For more concentrated samples (10 μg 1−1), the use of C18 cartridges was preferred because smaller solvent and sample volumes were used and the analysis time was reduced.

Evaluation of the presence of drugs of abuse in tap waters

A total of seventy samples of drinking water were tested for non-controlled and illicit drugs. Of these, 43 were from Spanish cities, 15 from seven other European countries, three from Japan and nine from seven different Latin American countries. The most frequently detected compounds were caffeine, nicotine, cotinine, cocaine and its metabolite benzoylecgonine, methadone and its metabolite EDDP. The mean concentrations of non-controlled drugs were: for caffeine 50 and 19 ng L(-1), in Spanish and worldwide drinking water respectively and for nicotine 13 and 19 ng L(-1). Illicit drugs were sparsely present and usually at ultratrace level (<1 ng L(-1)). For example, cocaine has mean values of 0.4 (Spain) and 0.3 ng L(-1) (worldwide), whereas for benzoylecgonine, these mean values were 0.4 and 1.8 ng L(-1), respectively. Higher concentrations of benzoylecgonine were found in Latin American samples (up to 15 ng L(-1)). No opiates were identified in any sample but the presence of methadone and EDDP was frequently detected. Total mean values for EDDP were 0.4 ng L(-1) (Spain) and 0.3 ng L(-1) (worldwide). Very few samples tested positive for amphetamines, in line with the reactivity of chlorine with these compounds. No cannabinoids, LSD, ketamine, fentanyl and PCP were detected.

Development of a solid-phase microextraction method for the determination of short-ethoxy-chain nonylphenols and their brominated analogs in raw and treated water

A direct solid-phase microextraction (SPME) procedure has been developed and applied for the simultaneous determination of nonylphenol, nonylphenol mono- and diethoxylates and their brominated derivatives in raw and treated water at low microg l(-1) concentrations. Several parameters affecting the SPME procedure, such as extraction mode (headspace or direct-SPME), selection of the SPME coating, extraction time, addition of organic modifiers such as methanol and temperature were optimized. The divinylbenzene-carboxen-polydimethylsiloxane fiber was the most appropriate one for the determination of nonylphenol ethoxylates (NPEOs) and bromononylphenol ethoxylates (BrNPEOs) by SPME-GC-MS. The optimized method was linear over the range studied (0.11-2.5 microg l(-1)) and showed good precision, with RSD values between 4 and 15% and detection limits ranging from 30 to 150 ng l(-1) depending on the compound. The SPME procedure was compared with a solid-phase extraction-GC-MS method (C18 cartridge) for the analysis of NPEO and BrNPEOs in water samples. There was good agreement between the results from both methods but the SPME procedure showed some advantages such as lower detection limits, a shorter analysis time and the avoidance of organic solvents. The optimized SPME method was applied to determine nonylphenol and brominated metabolites in raw and treated water of Barcelona (NE Spain).

Capillary electrophoresis with on‐line enrichment for the analysis of biological samples

“On-Line” preconcentration in capillary electrophoresis (CE) is a good strategy to overcome the low concentration sensitivity of the technique, which is the main limitation when trace-level compounds are to be determined in complex matrices such as biological samples. Here we discuss the use of at-, on-, and in-line preconcentration procedures in combination with CE in the analysis of biological fluids. The preconcentration strategies discussed are classified into two groups depending on the mechanism involved: chromatographic or electrophoretic techniques. Recent applications are included and the advantages and drawbacks of the techniques are examined.

5-Hydroxymethylfurfural content in foodstuffs determined by micellar electrokinetic chromatography

Micellar electrokinetic chromatography (MEKC) has been applied for the determination of 5-hydroxymethylfurfural in several foodstuffs. A 75mM phosphate buffer solution at pH 8.0 containing 100mM sodium dodecylsulphate was used as background electrolyte (BGE), and the separation was performed by applying +25kV in a 50μm I.D. uncoated fused-silica capillary. Good linearity over the range 2.5-250mgkg(-1) (r(2)⩾0.999) and run-to-run and day-to-day precisions at low and medium concentration levels were obtained. Sample limit of detection (0.7mgkg(-1)) and limit of quantification (2.5mgkg(-1)) were established by preparing the standards in blank matrix. The procedure was validated by comparing the results with those obtained with liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS). Levels of HMF in 45 different foodstuffs such as breakfast cereals, toasts, honey, orange juice, apple juice, jam, coffee, chocolate and biscuits were determined.

Liquid chromatography multi-stage mass spectrometry for the analysis of 5-hydroxymethylfurfural in foods

A new, simple and selective method for the analysis of 5-hydroxymethylfurfural (HMF) in foods by liquid chromatography coupled to ion trap multi-stage mass spectrometry (LC-MS(n)) is proposed in the present study. Several chromatographic columns were tested and the best results were obtained using a phenyl fluorinated column. MS conditions were established using an atmospheric pressure chemical ionisation (APCI) source in the positive ionisation mode. MS/MS was used for quantitative analysis while MS(3) was required for confirmation purposes. Quality parameters such as day-to-day and run-to-run precision (RSD<10%) and detection limit (133 ng g(-1), 333 pg injected) were established. This method was successfully applied to the analysis of HMF content in several Spanish food samples from a local market.

Multivariate calibration methods for quantification in strongly overlapping capillary electrophoretic peaks

Capillary zone electrophoresis with diode-array detection was applied to the separation of ebrotidine and its metabolites. However, three of these, which are neutral in the conditions studied, co-migrated with the electroosmotic flow signal. Therefore, strongly overlapping peaks were observed. The main aim of this study was to show the potentiality of capillary electrophoresis in combination with chemometrics. Multivariate calibration methods were applied to quantify these analytes in synthetic mixtures. The results obtained using partial least squares (PLS) were in agreement with actual values, with an overall prediction error of 9.7%.

New carrier electrolytes for the separation of chlorophenols by capillary electrophoresis

Optimum conditions for the separation of positional isomers of chlorophenols by capillary zone electrophoresis (CZE) were established. The behavior of five volatile electrolytes (L‐cysteic acid, 3‐amino‐1‐propanesulfonic acid, aminomethanesulfonic acid, diethylmalonic acid, and ammonium acetate) was compared. The best performance based on low electrophoretic current and high separation efficiency was obtained for diethylmalonic acid as working electrolyte. The influence of pH on the separation, using both uncoated fused‐silica capillaries and modified capillaries (NaAMPS from EKT) with anionic coating, was discussed. Moreover, the effect of electrolyte concentration and applied voltage using fused‐silica capillaries was studied. The optimum CZE conditions that allowed the separation of 16 chlorophenols were 20 kV, 30 mM diethylmalonic acid, pH 7.25, and uncoated fused‐silica capillary. Figures of merit such as run‐to‐run and day‐to‐day precision, linearity, and limits of detection were calculated.

Field amplified sample injection-capillary zone electrophoresis for the analysis of amprolium in eggs.

Veterinary medicines are widely administered to farm animals since they keep animals healthy at overcrowded conditions. Nevertheless the continuous administration of medicines to farm animals can frequently lead to the presence of residues of veterinary drugs in consumption products. Amprolium is a quaternary ammonium compound used in the treatment of coccidiosis. In this paper, a method based on CZE to analyze residues of amprolium in eggs was developed and validated for the first time. Parameters such as electrolyte type, concentration, and pH were optimized. In order to improve sensitivity, field‐amplified sample injection (FASI) was used for in‐line preconcentration after a quick and simple sample treatment based on SPE (Envi‐Carb). During method‐validation studies using egg samples, a matrix interference was found at the migration time of amprolium. This compound was identified as thiamine and confirmed by MSn experiments using CEcoupled to MS (CE‐MS) with an ion‐trap mass analyzer. CZE conditions were reoptimized to separate thiamine from amprolium allowing the quantification of amprolium in eggs at concentrations down to 75 μg/kg, which are far below the MRL‐legislated values.

Determination of free and total sulfate and phosphate in glycosaminoglycans by column-switching high-performance size-exclusion and ion chromatography and single-column ion chromatography.

Analytical procedures for the determination of free and total sulfate and phosphate in glycosaminoglycans by high-performance liquid chromatography were studied. A column-switching method coupling high-performance size-exclusion chromatography (HPSEC) and ion chromatography (IC) is proposed for the determination of free anions. Good run-to-run and day-to-day precision values (RSD) of < 4.7% were obtained for both anions. Total anion contents were determined after wet acid hydrolysis with nitric acid-hydrogen peroxide (5 + 1) by single-column IC and ICP-AES elemental analysis in order to validate the results. Recoveries ranging from 94.6 to 99.0% for sulfate and from 80.8 to 94.0% for phosphate were obtained. Both HPSEC-IC and single-column IC methods were applied to the analysis of a low molecular mass heparin, a non-fractionated heparin and a chondroitin 4-sulfate. From the free and total sulfate determinations, the content of linked sulfur was calculated and ranged from 5.1 to 12.2% m/m.