Maraísa Gonçalves

Activated carbon/iron oxide composites for the removal of atrazine from aqueous medium

The adsorption features of activated carbon and the oxidation properties of iron oxides were combined in a composite to produce new materials for atrazine removal from aqueous medium. Activated carbon/iron oxide composites were prepared at 1/1 and 5/1 mass ratios and characterized with powder X-ray diffractometry (XRD), infrared spectroscopy (FTIR), scanning electron microscopy (SEM) and nitrogen adsorption measurements. The adsorption and oxidation processes were evaluated in batch experiments, in order to monitor the atrazine removal capacity of these composites. The main iron oxide actually present in the composites was goethite (alpha-FeOOH). Impregnation with iron oxide reduced the surface area by its deposition in the activated carbon pores. However, a higher iron concentration promoted a higher oxidation rate, indicating that the efficiency of the oxidation reaction is related with the iron content and not with the pre-concentration of the contaminant on the carbon surface through adsorption process.

The use of piassava fibers (Attalea funifera) in the preparation of activated carbon

The piassava fiber, residue of the broom industry, was used as precursor for the preparation of activated carbons (AC). AC were prepared by chemical activation with zinc chloride (AC ZnCl(2)) or phosphoric acid (AC H(3)PO(4)) and by physical activation with carbon dioxide (AC CO(2)) or water vapor (AC H(2)O). These materials were characterized by adsorption/desorption of N(2) to determine the BET areas, elemental analysis (CHN), thermogravimetric analysis (TG, DTA) and scanning electron microscopy (SEM). The carbons were tested with respect to their adsorption capacity of methylene blue, reactive red, phenol and metallic ions (Cr(+6), Cu(+2) and Zn(+2)). AC ZnCl(2) presented the highest surface area (1190 m(2)g(-1)) and AC H(3)PO(4), the largest pore volume (0.543 cm(3)g(-1)). AC ZnCl(2) was more efficient in the adsorption of methylene blue, Cr(+6) and Cu(+2) ions. AC H(2)O was the better adsorbent for phenol, while AC CO(2) was better for Zn(+2) ions.

Síntese e propriedades catalíticas em reações de oxidação de goethitas contendo nióbio

Nb-substituted goethites have been prepared and characterized by Mossbauer spectroscopy, XRD, SEM and BET surface area measurements. Mossbauer and XRD analyses suggested that Nb replaces Fe3+ in the structure with duplet formation. The insertion of Nb into the goethite structure caused a significant increase in the BET surface area of the material. The prepared a-Fe1-xNbxOOH was investigated for the H2O2 decomposition to O2 and for the Fenton reaction to oxidize the dye methylene blue. It was observed that the introduction of Nb in to goethite produced a strong increase in the activity of oxidation of the dye contaminant by H2O2.

PREPARAÇÃO E CARACTERIZAÇÃO DE CARVÃO ATIVADO PRODUZIDO A PARTIR DE RESÍDUOS DO BENEFICIAMENTO DO CAFÉ

Coffee fruit processing is one of the most polluting activities in agriculture due to the large amount of waste generated in the process. In this work, coffee parchment was employed as precursor for the production of carbons activated with ZnCl2 (CAP). The material was characterized using N2 adsorption/desorption at 77 K, Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM). The material showed a surface area of 521.6 m2 g-1 and microporous structure. CAP was applied as adsorbent for the removal of methylene blue dye in aqueous medium. The adsorption capacity was found to be about 188.7 mg g-1.

Nióbia magnética como adsorvente de contaminantes orgânicos em meio aquoso: efeito da temperatura e do pH

This work describes novel materials based on pure iron oxide and iron oxide/niobia composite to produce a magnetic adsorbent. These materials were prepared with synthetic iron oxide and characterized by powder XRD, SEM, FTIR, TPR and Mossbauer spectroscopy. Results showed that the main iron oxides formed were goethite (aFeOOH) and maghemite (gFe2O3) with small particle size. The iron oxide and iron oxide/niobia composite showed high adsorption ability for organic compounds. The positive enthalpy indicated an endothermic adsorption process suggesting physical adsorption.

Produção de carvão a partir de resíduo de erva-mate para a remoção de contaminantes orgânicos de meio aquoso

In this work we present a new adsorbent material, obtained by mate waste pyrolisis. The resulting charcoal presented high specific area when compared with other pyrolized materials and also high capacity to remove organic contaminants from aqueous solution. The charcoal showed specific area of 344, 191 and ~0.3 m2 g-1 for sample Mate 1, Mate 2 and Mate 3, respectively. According to the corresponding adsorption isotherm these materials present good adsorption capacity for reactive textile and methylene blue dyes and the herbicide atrazine. Adsorption maxima were respectively 16, 230 and 35 mg g-1 for such substances, when sample Mate 1 was used.In this work we present a new adsorbent material, obtained by mate waste pyrolisis. The resulting charcoal presented high specific area when compared with other pyrolized materials and also high capacity to remove organic contaminants from aqueous solution. The charcoal showed specific area of 344, 191 and ~0.3 m g for sample Mate 1, Mate 2 and Mate 3, respectively. According to the corresponding adsorption isotherm these materials present good adsorption capacity for reactive textile and methylene blue dyes and the herbicide atrazine. Adsorption maxima were respectively 16, 230 and 35 mg g for such substances, when sample Mate 1 was used.

Removal of organic dyes using Cr-containing activated carbon prepared from leather waste

In this work, hydrogen peroxide decomposition and oxidation of organics in aqueous medium were studied in the presence of activated carbon prepared from wet blue leather waste. The wet blue leather waste, after controlled pyrolysis under CO(2) flow, was transformed into chromium-containing activated carbons. The carbon with Cr showed high microporous surface area (up to 889 m(2)g(-1)). Moreover, the obtained carbon was impregnated with nanoparticles of chromium oxide from the wet blue leather. The chromium oxide was nanodispersed on the activated carbon, and the particle size increased with the activation time. It is proposed that these chromium species on the carbon can activate H(2)O(2) to generate HO radicals, which can lead to two competitive reactions, i.e. the hydrogen peroxide decomposition or the oxidation of organics in water. In fact, in this work we observed that activated carbon obtained from leather waste presented high removal of methylene blue dye combining the adsorption and oxidation processes.

Materiais à base de óxido de ferro para oxidação de compostos presentes no efluente da despolpa do café

Materials based on pure iron oxide and impregnated with niobia (Nb2O5) were prepared. Their catalytic activities were tested on the oxidation of compounds present in the wastewater from the processing of coffee berries. Particularly caffeine and catechol were tested. The oxidation reactions were carried out with the following systems (i) UV/H2O2, (ii) photo-Fenton and (iii) heterogeneous Fenton. All materials were characterized with X-ray diffraction, Mossbauer and infrared spectroscopy. Iron was mainly in the forms of goethite and maghemite. The oxidation kinetics were monitored by UV-vis and the oxidation products were monitored by mass spectrometry. The photo-Fenton reaction presented highest oxidation efficiency, removing 98% of all caffeine and catechol contents.

Produção e caracterização de carvão ativado produzido a partir do defeito preto, verde, ardido (PVA) do café

The black, green and sour coffee defect (PVA) contributes with 20% of the total coffee production. It should be separate from the normal coffee grains in order to improve the final quality of the beverage. In this way, the present work has the objective to use the PVA reject for the production of activated carbon. The activated carbon (CA) was prepared from PVA defect using zinc chloride as activating agent. The prepared material (CA PVA) was characterized and the adsorption tests were carried out using as organic models methylene blue (AM) and reactive red (VR). The CA PVA revealed to be more efficient in the removal of the organic contaminants compared to a commercial activated carbon.

Activated carbon prepared from coffee pulp: potential adsorbent of organic contaminants in aqueous solution

The processing of coffee beans generates large amounts of solid and liquid residues. The solid residues (pulp, husk and parchment) represent a serious environmental problem and do not have an adequate disposal mechanism. In this work, activated carbons (ACs) for adsorption of organic compounds were prepared from coffee pulp by controlled temperature at different pulp/Na2HPO4 ratios (4:1, 2:1, 5:4 and 1:1). The N2 adsorption/desorption isotherms showed ACs with high quantities of mesopores and micropores and specific surface areas of 140, 150, 450 and 440 m(2)g(-1) for AC 4:1, AC 2:1, AC 5:4 and AC 1:1, respectively. The prepared material AC 5:4 showed a higher removal capacity of the organic contaminants methylene blue (MB), direct red (DR) and phenol than did a Merck AC. The maximum capacities for this AC are approximately 150, 120 and 120 mg g(-1) for MB, DR and phenol, respectively. Thus, a good adsorbent was obtained from coffee pulp, an abundant Brazilian residue.