Marcela C. Rodríguez

Carbon nanotubes for electrochemical biosensing.

The aim of this review is to summarize the most relevant contributions in the development of electrochemical (bio)sensors based on carbon nanotubes in the last years. Since the first application of carbon nanotubes in the preparation of an electrochemical sensor, an increasing number of publications involving carbon nanotubes-based sensors have been reported, demonstrating that the particular structure of carbon nanotubes and their unique properties make them a very attractive material for the design of electrochemical biosensors. The advantages of carbon nanotubes to promote different electron transfer reactions, in special those related to biomolecules; the different strategies for constructing carbon nanotubes-based electrochemical sensors, their analytical performance and future prospects are discussed in this article.

Glucose biosensors based on the immobilization of copper oxide and glucose oxidase within a carbon paste matrix

The performance of amperometric glucose biosensors based on the dispersion of glucose oxidase (GOx) and copper oxide within a classical carbon (graphite) paste composite is reported in this work. Copper oxide promotes an excellent electrocatalytic activity towards the oxidation and reduction of hydrogen peroxide, allowing a large decrease in the oxidation and reduction overpotentials, as well as an important enhancement of the corresponding currents. Therefore, it is possible to perform the glucose biosensing at low potentials where there is no interference even in large excess of ascorbic acid, uric acid or acetaminophen. The influence of the copper oxide and glucose oxidase content in the paste on the analytical performance of the bioelectrode is discussed. The resulting biosensor shows a fast response, a linear relationship between current and glucose concentration up to 1.35 x 10(-2) M (2.43 g L(-1)) and a detection limit of 2.0 x 10(-5) M. The effect of the presence of the enzyme in the composite material on the dispersion of the copper oxide particles is also discussed.

Label-free electrochemical aptasensor for the detection of lysozyme

This work reports the advantages of a label free electrochemical aptasensor for the detection of lysozyme. The biorecognition platform was obtained by the adsorption of the aptamer on the surface of a carbon paste electrode (CPE) previously blocked with mouse immunoglobulin under controlled-potential conditions. The recognition event was detected from the decrease in the guanine and adenine electro-oxidation signals produced as a consequence of the molecular interaction between the aptamer and lysozyme. The biosensing platform demonstrated to be highly selective even in the presence of large excess (9-fold) of bovine serum albumin, cytochrome C and myoglobin. The reproducibility for 10 repetitive determinations of 10.0 mg L(-1) lysozyme solution was 5.1% and 6.8% for guanine and adenine electro-oxidation signals, respectively. The detection limits of the aptasensor were 36.0 nmol L(-1) (if considering guanine signal) and 18.0 nmol L(-1) (if taking adenine oxidation current). This new sensing approach represents an interesting and promising alternative for the electrochemical quantification of lysozyme.

Selective detection of dopamine in the presence of ascorbic acid using carbon nanotube modified screen-printed electrodes

This work reports on the performance of carbon nanotube modified screen-printed electrodes (SPE-MWCNT) for the selective determination of dopamine (DA) in the presence of ascorbic acid (AA) by adsorptive stripping voltammetry (AdSV). Several operating conditions and parameters were examined including the electrochemical pre-treatment and the previous AA interaction and DA accumulation in the presence AA at physiological conditions. Under the chosen conditions, DA peak current of differential pulse voltammograms increases linearly with DA concentration in the range of 5.0 x 10(-8) to 1.0 x 10(-6) mol L(-1) with a limit of detection of 1.5 x 10(-8) mol L(-1) in connection with 600s accumulation time. The sensitivity obtained for DA was independent from the presence or absence of AA; therefore, the proposed method can be readily applied to detect DA in real samples. The proposed methodology was successfully used for the quantification of DA in urine samples.

Highly Selective First Generation Glucose Biosensor Based on Carbon Paste Containing Copper and Glucose Oxidase

A highly selective electrochemical glucose biosensor based on the dispersion of copper microparticles and glucose oxidase into a carbon paste matrix is described. Copper offers a very efficient and preferential electrocatalytic activity towards the reduction of enzymatically generated hydrogen peroxide. Careful evaluation of the influence of copper content in the paste on the sensitivity and selectivity of the biosensor was performed, and 1.2 % w/w copper was selected as the optimum. Hence, the strong electrocatalytic effect of copper towards hydrogen peroxide allows for a fast and remarkably selective glucose quantification at −0.100 V. No interference was observed even in the presence of large excess of ascorbic acid (up to 3.5×10−3 M), uric acid (up to 5.0×10−4 M, 8.3 mg %) or acetaminophen (up to 7.4×10−4 M). The detection limit was 150 μM, and the response was linear up to 6.0×10−3 M. When stored dried at 4 °C, the sensor showed almost no change in the analytical performance after operating for 30 days. Calibration plots performed with glucose solutions prepared in human blood serum samples containing undetectable glucose level, showed no appreciable differences with those obtained using pure glucose standard solutions. The usefulness of the bioelectrode for direct glucose quantification in human blood serum matrices is also discussed.

Characterization of a modified gold platform for the development of a label-free anti-thrombin aptasensor.

This work reports the characterization of a modified gold surface as a platform for the development of a label free aptasensor for thrombin detection. The biorecognition platform was obtained by the self-assembly of 4-mercaptobenzoic acid onto a gold surface, covalent attachment of streptavidin and further immobilization of the biotinylated anti-thrombin aptamer. The biosensing platform was characterized by cyclic voltammetry, electrochemical impedance spectroscopy, surface plasmon resonance (SPR) and quartz crystal microbalance with dissipation monitoring. The biorecognition event aptamer-thrombin was detected from changes in the SPR angle produced as a consequence of the molecular interaction between the aptasensor and the target protein. The biosensing platform demonstrated to be highly selective for human thrombin even in the presence of large excess of bovine thrombin, bovine serum albumin, cytochrome C, lysozyme and myoglobin. The relationship between the changes in the SPR angle and thrombin concentration was linear up to 0.19 μmol L(-1) (R(2)=0.992) while the detection limit was of 12.0 nmol L(-1) (240 fmol in the sample). This new sensing approach represents an interesting and promising alternative for the SPR-based quantification of thrombin.

Enzymatic biosensor for the electrochemical detection of 2,4-dinitrotoluene biodegradation derivatives

In this work, we demonstrate for the first time that 4-methyl-5-nitrocatechol (4M5NC) and 2,4,5-trihydroxytoluene (2,4,5-THT), two compounds obtained from the 2,4-DNT biodegradation are recognized by polyphenol oxidase as substrates. An amperometric biosensor is described for detecting these compounds and for evaluating the efficiency of the 2,4-DNT conversion into 4M5NC in the presence of bacteria able to produce the 2,4-DNT-biotransformation. The biosensor format involves the immobilization of polyphenol oxidase into a composite matrix made of glassy carbon microspheres and mineral oil. The biosensor demonstrated to be highly sensitive for the quantification of 4M5NC and 2,4,5-THT. The analytical parameters for 4M5NC are the following: sensitivity of (7.5+/-0.1)x10(5)nAM(-1), linear range between 1.0x10(-5) and 8.4x10(-5)M, and detection limit of 4.7x10(-6)M. The sensitivity for the determination of 2,4,5-THT is (6.2+/-0.6)x10(6)nAM(-1), with a linear range between 1.0x10(-6) and 5.8x10(-6)M, and a detection limit of 2.0x10(-7). Under the experimental conditions, it was possible to selectively quantify 4M5NC even in the presence of a large excess of 2,4-DNT. The suitability of the biosensor for detecting the efficiency of 2,4-DNT biotransformation into 4M5NC is demonstrated and compared with HPLC-spectrophotometric detection, with very good correlation. This biosensor holds great promise for decentralized environmental testing of 2,4-DNT.