Marcio Rodrigues de Almeida

Short-Term Treatment Effects Produced by the Herbst Appliance in the Mixed Dentition

This prospective clinical investigation evaluates the dentoalveolar and skeletal cephalometric changes produced by the Herbst appliance during treatment of mixed dentition patients with Class II division 1 malocclusion. Thirty individuals (15 male and 15 female individuals; initial mean age nine years 10 months) were treated with the Herbst appliance for a period of 12 months. For comparison, the records of 30 untreated Class II children (15 boys, 15 girls; initial mean age nine years eight months) were followed without treatment for a period of 12 months. The results indicated that the treatment effects produced in the mixed dentition patients were primarily dentoalveolar in nature. The mandibular incisors were tipped labially, and the maxillary incisors were retruded; a significant increase in mandibular posterior dentoalveolar height occurred, and there was a restriction in the vertical development of the maxillary molars. There was no difference in the forward growth of the maxilla between the two groups. In comparison with the controls, however, the Herbst treatment produced a modest but statistically significant increase in total mandibular length. This increase in total mandibular length, however, was less than that observed in adolescent Herbst patients in other studies.

Comparison of root resorption between self-ligating and conventional preadjusted brackets using cone beam computed tomography.

OBJECTIVE To compare the magnitude of external apical root resorption (EARR) of incisors in patients undergoing the initial phase of orthodontic treatment with two sets of brackets. MATERIALS AND METHODS According to the results of the power analysis for sample size calculation, 19 Angle Class I patients (anterior crowding: 3 to 5 mm; mean age: 20.6 years) were included in the study and randomly divided into two groups: group I (n  =  11, self-ligating brackets) and group II (n  =  8, conventional preadjusted brackets). The degree of EARR was detected in 152 upper and lower incisors by using cone-beam computed tomography (CBCT) scans and a three-dimensional program (Dolphin 11.5, Dolphin Imaging & Management Solutions, Chatsworth, Calif) with 25% level of sensitivity. The CBCT scans were obtained before (T1) and 6 months after initiation of treatment (T2). Differences between and within groups were analyzed by nonpaired and paired t-test, respectively, with 5% significance level. RESULTS Significant differences were found for both groups between T1 and T2. However, no differences in the degree of EARR were detected between the groups studied. CONCLUSIONS Although EARR has occurred in all teeth evaluated, the bracket design (self-ligating or conventional) did not demonstrate any influence on the results observed.

Importance of occlusion aspects in the completion of orthodontic treatment

The purpose of this study was to address the therapeutic goals regarding the static and functional occlusion in the completion of orthodontic treatment. For such purpose, a study population comprising 20 female treated Class II malocclusion subjects with an initial mean age of 11 years underwent a two-phase treatment (orthopedics and orthodontics). The patients were diagnosed in centric relation and were treated according to the six keys for normal occlusion and functional occlusal parameters (centric relation, vertical dimension, lateral and anterior guidances, occlusal contacts and direction of forces applied on the teeth). After removal of fixed mechanics, retainers were installed and maintained for two years. Five years after orthodontic completion, the occlusal stability of the patients was evaluated regarding molar relationship and overjet, measured in dental casts. All subjects maintained the normal molar relationship and correct overjet achieved at the end of treatment, indicating a fair level of occlusal stability. The importance of the criteria of the ideal functional occlusion to ensure a better stability after completion orthodontic treatment will be discussed in detail in this paper. In addition, some clinical situations in which localized adjustments are indicated for occlusal refinement will be described.

Reliability of a method to conduct upper airway analysis in cone-beam computed tomography

The aim of this study was to assess the reliability of a method to measure the following upper airway dimensions: total volume (TV), the nasopharyngeal narrowest areas (NNA), and the oropharyngeal narrowest areas (ONA). The sample consisted of 60 cone-beam computed tomography (CBCT) scans, evaluated by two observers twice, using the Dolphin 3D software (Dolphin Imaging & Management solutions, Chatsworth, California, USA), which afforded image reconstruction, and measurement of the aforementioned dimensions. The data was submitted to reliability tests, by the intraclass correlation coefficient (ICC), and the Bland & Altman agreement tests, with their respective confidence intervals (CI) set at 95%. Excellent intra- and interobserver reliability values were found for all variables assessed (TV, NNA and ONA), with ICC values ranging from 0.88 to 0.99. The data demonstrated an agreement between the two assessments of each observer and between the first evaluations of both observers, thus confirming the reliability of this methodology. The results suggest that this methodology can be used in further studies to investigate upper airway dimensions (TV, NNA, and ONA), thereby contributing to the diagnosis of upper airway obstructions.

Comparison of manual, digital and lateral CBCT cephalometric analyses

Objective: The aim of this study was to compare the reliability of three different methods of cephalometric analysis. Material and Methods: Conventional pretreatment lateral cephalograms and cone beam computed tomography (CBCT) scans from 50 subjects from a radiological clinic were selected in order to test the three methods: manual tracings (MT), digitized lateral cephalograms (DLC), and lateral cephalograms from CBCT (LC-CBCT). The lateral cephalograms were manually analyzed through the Dolphin Imaging 11.0(tm) software. Twenty measurements were performed under the same conditions, and retraced after a 30-day period. Paired t tests and the Dahlberg formula were used to evaluate the intra-examiner errors. The Pearsons correlation coefficient and one-way analysis of variance (ANOVA) tests were used to compare the differences between the methods. Results: Intra-examiner reliability occurred for all methods for most of the measurements. Only six measurements were different between the methods and an agreement was observed in the analyses among the 3 methods. Conclusions: The results demonstrated that all evaluated methodologies are reliable and valid for scientific research, however, the method used in the lateral cephalograms from the CBCT proved the most reliable.

Treatment effects of bonded spurs associated with high-pull chincup therapy in the treatment of patients with anterior open bite

INTRODUCTION The aim of this prospective clinical study was to investigate the cephalometric changes produced by bonded spurs associated with high-pull chincup therapy in children with Angle Class I malocclusion and anterior open bite. METHODS Thirty patients with an initial mean age of 8.14 years and a mean anterior open bite of -3.93 mm were treated with bonded spurs associated with chincup therapy for 12 months. An untreated control group of 30 subjects with an initial mean age of 8.36 years and a mean anterior open bite of -3.93 mm and the same malocclusion was followed for 12 months for comparison. Student t tests were used for intergroup comparisons. RESULTS The treated group demonstrated a significantly greater decrease of the gonial angle, and increase in overbite, palatal tipping of the maxillary incisors, and vertical dentoalveolar development of the maxillary and mandibular incisors compared with the control group. CONCLUSIONS The association of bonded spurs with high-pull chincup therapy was efficient for the correction of the open bite in 86.7% of the patients, with a 5.23-mm (SD, ±1.69) overbite increase.

Early Treatment Protocol for Skeletal Class III Malocclusion

Skeletal Class III malocclusion, with its unpredictable and unfavorable nature, has been characterized by a growth pattern with doubtful prognosis regarding orthodontic mechanics, even when performed early. For a long time, Class III malocclusion was regarded as a synonym of mandibular prognathism, regardless of the affected skeletal structures. Mandibular growth, essentially determined by genetic factors, could barely be controlled by early orthodontic interventions. Therefore, the treatment choice was to wait for the patient to grow, and then make an orthodontic intervention associated with an orthognathic surgery. Maxillary involvement in the etiology of Class III malocclusion was conclusive to change orthodontic therapeutics. Maxillary intramembranous growth has a better response to orthopedic treatment, based on growth control and redirection, thus contributing for early intervention success. In several cases, excellent results have been achieved with rapid maxillary expansion and protraction. The aim of this study was to describe and discuss the treatment of a patient with Class III malocclusion, whose treatment planning comprised two phases: interceptive (mechanical orthopedic appliances) and comprehensive (fixed orthodontic appliance). The results of this case showed that Class III malocclusion should be intercepted as early as possible to permit growth redirection, mainly when the maxilla is the primary etiologic factor or dental and/or functional factors are involved. Diagnosis, treatment planning and prognosis depend on patient age, growth potential and severity of malocclusion. Early intervention, adequate indication of appliances, and patient compliance are key factors for good outcomes.

Prospective study of dentoskeletal changes in Class II division malocclusion treatment with twin force bite corrector

OBJECTIVE To evaluate the dentoskeletal changes of Class II malocclusion treatment with the Twin Force Bite Corrector (TFBC). MATERIALS AND METHODS The sample comprised 86 lateral cephalograms obtained from 43 subjects with Class II division 1 malocclusion; the subjects were divided into two groups. The experimental group comprised 23 patients with a mean initial age of 12.11 years who were treated with the TFBC for a mean period of 2.19 years. The control group included 40 lateral cephalograms from 20 Class II nontreated patients, with an initial mean age of 12.55 years and a mean observation period of 2.19 years. The lateral cephalograms were evaluated before and after orthodontic treatment in group 1 and in the beginning and end of the observation period in group 2. t-Tests were used to compare the initial and final cephalometric characteristics of the groups as well as the amount of change. RESULTS The experimental group presented greater maxillary growth restriction and mandibular retrusion than the control group, as well as greater maxillomandibular relationship improvement and greater labial tipping of the mandibular incisors. The results also showed a greater decrease in overbite and overjet in the experimental group, and there were no statistically significant differences in the craniofacial growth pattern between groups. CONCLUSIONS The TFBC promotes restriction of anterior maxillary displacement without significant changes in mandibular length and position and improvement of maxillomandibular relationship without changes in facial growth and significant buccal tipping of mandibular incisors. Class II correction with the TFBC occurred primarily as a result of dentoalveolar changes.

Early treatment of Class III malocclusion: 10-year clinical follow-up

Angle Class III malocclusion has been a challenge for researchers concerning diagnosis, prognosis and treatment. It has a prevalence of 5% in the Brazilian population, and may have a genetic or environmental etiology. This malocclusion can be classified as dentoalveolar, skeletal or functional, which will determine the prognosis. Considering these topics, the aim of this study was to describe and discuss a clinical case with functional Class III malocclusion treated by a two-stage approach (interceptive and corrective), with a long-term follow-up. In this case, the patient was treated with a chincup and an Eschler arch, used simultaneously during 14 months, followed by corrective orthodontics. It should be noticed that, in this case, initial diagnosis at the centric relation allowed visualizing the anterior teeth in an edge-to-edge relationship, thereby favoring the prognosis. After completion of the treatment, the patient was followed for a 10-year period, and stability was observed. The clinical treatment results showed that it is possible to achieve favorable outcomes with early management in functional Class III malocclusion patients.

Examination of temporomandibular disorders in the orthodontic patient: a clinical guide

The possible association between orthodontic treatment and temporomandibular disorders (TMD) is a topic of great interest in the current literature. The true role of orthodontic therapy on the etiology of TMD, however, is still uncertain. From the clinical prospective, a thorough examination of the stomatognathic system is always necessary in order to detect possible TMD signs and symptoms prior to the beginning of the orthodontic therapy. Caution should be exercised when planning, performing and finalizing orthodontics, especially in patients who with history of signs and symptoms of TMD. The clinician must always eliminate patient’s pain and dysfunction before initiating any type of orthodontic mechanics. Muscle incoordination, unstable disc-condyle relationship and bone alterations are usual TMD conditions that can interfere with the presenting occlusal relationship. This article reviews these aspects and presents a detailed clinical guide for the examination of the orthodontic patient, considering aspects related to facial pain and dysfunction.